Search PubMed⌕ Search

PubMed · 1746341

Water diffusivity in starch-based systems.

Abstract

The objective of this study was to investigate the influence of structure, and component interactions, on the sorption and transport properties of water in starch-based systems. We compared the effective diffusivity (Deff) of water in two starches, with differing amylose-amylopectin ratios, using either kinetics of water adsorption or analysis of drying curves (water desorption) to estimate Deff. The effect of incorporating small sugar molecules into the granular or gelatinized starch matrices on Deff was measured by drying curve analysis. To investigate the possible mechanisms of water transport, the porosity and microscopic appearance of the samples at different stages of drying were determined. In a complementary study, sorption isotherms and the number of accessible "binding" sites in the starch and starch-sugar systems were determined using gravimetric analysis and inverse gas chromatography (IGC) 'probe analysis'. In the case of the starch-sugar systems, the measurements were made after the components had been 'mechanically mixed', or after more intimate mixing had been achieved by a co-freeze-drying process. The Deff of the starches was found to depend, in a complex way, on the moisture content of the samples. At relatively high moisture contents, the predominant mode of water transport was by liquid diffusion. As the samples became drier, their porosity increased, and the predominant mode of moisture transport was by vapor phase diffusion. As the samples became very dry (less than 10% water content), Deff fell significantly. Incorporation of sugars, in general, led to a reduction of Deff, which was correlated with a corresponding fall in porosity. In agreement with the findings of other workers, for the starches studied, the value of Deff determined from water adsorption measurements was significantly less than Deff determined from water desorption (drying curve analysis). The form of the Deff versus moisture content relationship was, however, independent of the method of measurement (adsorption or desorption). The water sorption and IGC probe analysis results indicated that some physicochemical interaction was expedited by the freeze-drying process. This interaction was manifested by a reduction in water sorption at a given relative vapor pressure, and by major changes in the accessibility of the co-freeze-dried samples to organic probe molecules. Taken together, the results indicate that water transport (diffusion) in starches and in starch-sugar mixtures is dependent significantly on gross structural features (development of porosity during drying), but that specific molecular, physico-chemical interactions must also be considered.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

R B Leslie, P J Carillo, T Y Chung, S G Gilbert, K Hayakawa, S Marousis, G D Saravacos, M Solberg. 1991. Water diffusivity in starch-based systems.. https://doi.org/10.1007/978-1-4899-0664-9_21

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

Three-dimensional porous nano-hydroxyapatite@gelatin composite as efficient adsorbent for uranyl ion removal from low-level radioactive wastewater.

The contamination of water resources by uranyl (UO22+) ions poses significant environmental and health risks, requiring the development of efficient and sustainable remediation strategies. Adsorption-based techniques have emerged as promising approaches in the field of UO22+ removal, but the design of cost-effective, high-capacity, and environmentally friendly adsorbents remains challenging. In this study, a three-dimensional porous nano-hydroxyapatite@gelatin (nHAP@Ge) composite was synthesized through glutaraldehyde cross-linking, combining the structural stability of Ge with the high uranium affinity of nHAP. The optimized nHAP@Ge, with a nHAP:Ge mass ratio of 1:0.5, exhibited exceptional UO22+ removal efficiency (97 %), along with high adsorption capacity (364.03 mg/g). Systematic characterizations using scanning electron microscopy (SEM), thermogravimetric analysis (TGA), Fourier transform infrared (FT-IR) spectroscopy, and X-ray photoelectron spectroscopy (XPS) methods revealed that the porous structure and surface functional groups (-OH, Ca2+, and PO43-) of the material synergistically contributed to binding UO22+ species. Furthermore, the incorporation of nHAP into the Ge framework resulted in enhanced thermal stability while significantly improving the UO22+ adsorption performance. This work presents a scalable, eco-friendly, and recyclable strategy for the effective treatment of uranium-contaminated water, with potential applications in nuclear wastewater treatment and environmental remediation.

Adsorption↗

Dual radiolabeling to study protein adsorption competition in relation with hemocompatibility.

Human fibrinogen (Fg) and albumin (HSA) were labeled with (3)H and (14)C, respectively. Dual counting allowed the adsorbed amount of the two proteins to be determined simultaneously. Single adsorption, adsorption of the two proteins in competition, but also exchange (substitution by molecules of the same nature) and displacement (desorption under the action of the other protein) experiments were performed on two model surfaces, glass and polystyrene (PS), as well as on pure polyvinylchloride (PVC-s) and on PVC from blood bag (PVC-b). As expected, the adsorbed amount of a single protein is higher on a hydrophobic compared to a hydrophilic surface. When the two proteins are adsorbed in competition, they are found in equal proportion on glass, while HSA is twice more abundant than Fg on PS and PVC-s and about six times more abundant on PVC-b. This trend is related to an increase of the water contact angle of the substrates. For PVC-b, the contact angle is affected by the presence of aliphatic components exposed at the extreme surface, as determined by angle-resolved X-ray photoelectron spectroscopy. In exchange and displacement experiments, the first adsorbed molecules remain dominating on PS while they can be removed from glass. Given the known importance of HSA and Fg adsorption for the fate of materials placed in contact with blood, the method described in this paper may be used as a first approach to orient the design of surfaces with improved hemocompatibility.

Adsorption↗

Effective immobilization of subunit protein in mesoporous silica modified with ethanol.

Ethoxylated FSM-type mesoporous silica (folded-sheet mesoporous material) with a pore diameter of 6.2 nm (FSM6.2) remarkably enhances rigidly of the structure in aqueous solutions. The esterified material could be used successfully as an adsorbent to accommodate subunit protein, methemoglobin (Fe(3+)). Furthermore, methemoglobin (Fe(3+)) in the pores of ethoxy-FSM is maintained a peroxidase activity similar to the native, indicating methemoglobin retains its fore subunit structure in the pores of FSM6.2.

Adsorption↗