PubMed · 9766985
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
A K Singh. 1998-10-01. Dialysis therapy.. https://doi.org/10.1056/nejm199810013391414
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
A zeolite catalyst of ultrastable Y-type (USY) was investigated in the research of two staged pyrolysis-catalysis of scrap tyres. Scrap tyres were pyrolysed in a fixed bed reactor and the evolved pyrolysis gases were passed through a secondary catalytic reactor. The main objective of this paper was to investigate the effect of zeolite USY on the yield of products and the composition of derived oil. The influences of several parameters such as pyrolysis temperature, catalytic temperature, catalyst/tyre ratio, heating rate, etc. on the yield of the derived oil, char and gas were investigated. It showed that the increase of catalytic temperature and catalyst/tyre ratio resulted in high yield of gas at the expense of the oil yield. For example, when the catalyst/tyre ratio increased from 0.25 to 1.0, the yield of gas increased from 30.5 to 49.9 wt.%, and the oil yield decreased nearly two-fold from 31.6 to 12.7 wt.%. The concentration of light naphtha (boiling point < 160 degrees C) was also investigated in this study. And the high catalyst/tyre ratio favored to increase the concentration of light naphtha (< 160 degrees C) in oil. In order to study the composition of derived oil, a distilled fraction (< 280 degrees C), which was 92.5 wt.% of the oil obtained from catalytic pyrolysis of scrap tyre at a pyrolysis temperature, catalytic temperature and catalyst/tyre ratio of 500, 400 degrees C and 0.5, respectively, was analyzed with gas chromatography/mass spectrometry (GC/MS). The distillate was found to contain 1.23 wt.% benzene, 9.35 wt.% toluene, 3.68 wt.% ethylbenzene, 12.64 wt.% xylenes, 1.81 wt.% limonene and 13.89 wt.% PAHs, etc., where the single ring aromatics represented a significant potential use as chemicals.
Explore the source record for details and available documents.
To broaden the beneficial reuse of sewage sludge, small amounts of nanomaterial were considered as additives to evaluate influences of nanomaterials on microstructures of sludge cement paste. Paste specimens were manufactured using different mix designs and cured for various ages. Tests such as scanning electron microscope, X-ray diffraction, transmission electron microscope, and mercury intrusion porosimetry were then performed. Results obtained indicated that the quantities of crystallization in hydrates rose with the increased amounts of nanomaterial added. Moreover, nanomaterial additives could make crystallizations denser, pore sizes smaller, and the number of pores decreased. Consequently, the strength of sludge cement paste became better as more amounts of nanomaterial were added.