PubMed · 6957390
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
1982. Benzene.. https://pubmed.ncbi.nlm.nih.gov/6957390/
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
The main objective of this study is to investigate the personal or area exposure of organic solvents during paint stripping and paint spraying. Three aircraft paint stripping/spraying workplaces in Taiwan were selected, and the Council of Labor Affairs and NIOSH recommended sampling/analytical methods used in this study. Activated charcoal tubes were used to investigate the personal and area exposure concentration of organic solvents in paint stripping and paint spraying operations. During aircraft paint stripping, experiment results show that methylene chloride personal exposure concentration at the ground area, 42.01+/-31.86 ppm, is higher than that at the working platform 4 M high above the ground, 20.41+/-11.43 ppm. Exposure concentration of methylene chloride in the initial paint stripping operation stage of every workplace is over the PEL (50 ppm) set by the Taiwan Council of Labor Affairs. Corrective actions are needed. During paint spraying, concentrations of all organic solvents were found to be below the PEL of OSHA.
Twelve air samples were collected from an electronic recycling facility in Sweden representing three different dust fractions; respirable, total and inhalable dust. Four samples were collected from each fraction. The highest concentration of polybrominated diphenyl ether (PBDE) #209 (ten bromine atoms) was found in the samples from the inhalable dust fraction (ID), which was 10 times higher than for the "total dust" fraction (TD). The concentration ranges were 157.6-208.6; 13.9-16.7; and 2.8-3.3 ng/m3 for inhalable, total and respirable fractions, respectively. The second most abundant PBDE congener was PBDE #183 (seven bromine atoms), followed by the second most abundant substance 1,2-bis(2,4,6-tribromophenoxy)ethane (BTBPE) in all samples. In addition, decabromodiphenyl ethane (DeBDethane) was tentatively identified in five of the samples. Because of the large differences in air concentrations between the three fractions in ID, TD and RD, it is suggested that the inhalable instead of "total dust" fraction should be used to assess air concentrations, in particular for the larger and higher brominated flame retardants (BFRs).
A sensitive internal standard method for the analysis of a DNA-adduct of N,N-dimethylformamide (N4-methylcarbamoylcytosine, NMC-C) in human urine has been developed. A sample pre-treatment involving an acidic hydrolysis is followed by the sample clean-up performed with solid-phase extraction (SPE) technique using a cation-exchange resin. A two-dimensional liquid chromatography is used to separate the target analyte from the matrix using first a C18 reversed phase column with incorporated hydrophilic moieties and then a C8 bonded reversed phase column for the final separation. Quantification is carried out by positive electrospray ionisation and mass spectrometry detection of the transitions from molecule ions to product ions (169-->112 and 172-->115) for the analyte and the labelled internal standard, respectively. The detection limit in urine reaches down to 8 ng/L (48 pmol/L). In the general population NMC-C could not be detected. In 10 out of 32 urine samples of occupationally to DMF exposed subjects NMC-C could be detected. The concentrations ranged up to 172 ng/L (1023 pmol/L) with a 95th percentile of 121 ng/L (720 pmol/L).