PubMed · 5250346
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
R Dufour. 1968. [Temporary ligatures].. https://pubmed.ncbi.nlm.nih.gov/5250346/
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
In previous studies, an RF magnetron sputter technique was developed for the production of thin calcium phosphate coating. Several deposition parameters were found to influence the growth rate and the stoichiometry of the coatings. For instance, deposition with additional oxygen pressure decreased the Ca to P ratio of the coatings to 1.67. For application of these coatings on actual Ti implants, it is important to know their adhesive tensile strength with the implant surface and how it varies with the deposition parameters. Motivated by these goals, the aim of this study was to measure the adhesive tensile strength of these coatings with Ti substrates and to study its variation with the deposition parameters. Since most mechanical characterization methods are incapable of providing a direct measure of the interface's fundamental strength, a novel laser spallation experiment was used to accomplish this task. In this experiment, a compressive stress pulse is generated on the back side of a substrate by impinging a 3-ns long Nd:YAG laser pulse. The stress pulse propagates through the substrate and is reflected into a tensile stress wave from the free surface of the coating deposited on its front surface. The returning tensile pulse pries off the coating if its amplitude is high enough. The peak interface tensile stress is computed by using the optically recorded free surface displacement of the coating. Because interface decohesion is accomplished at a strain rate of almost 10(7) s-1, all inelastic processes essentially are suppressed and the measured value essentially is the intrinsic tensile strength of the interface. Tensile strength values in the range of 500-900 MPa were recorded for the interfaces between sputter-deposited calcium-phosphate coatings and Ti substrates. To confirm the locus of failure, the spalled spots were examined using SEM and EDS. The variation in the measured values was related to the changes in the deposition conditions.
This study tested whether macrophages respond differently to retrieved titanium-alloy particles than they do to machined titanium-alloy particles and assessed whether pretreatment of machined titanium-alloy particles with human serum would influence macrophage activation and cytokine release in vitro. Human monocyte/macrophages were isolated from normal healthy donors and exposed to increasing concentrations of machined and retrieved titanium-alloy particles. The profile of cytokine release was determined by commercially available ELISA kits. Machined titanium-alloy particles were opsonized with human serum and added to macrophage cultures. Serum protein binding was confirmed by SDS-PAGE analysis. The results showed that machined titanium-alloy particles and retrieved titanium-alloy particles stimulate a similar level of cytokine release when tested at comparable concentrations. Opsonization of the machined particles with human serum increased the macrophage release of cytokines in the first 12 h after exposure compared to nonopsonized particles. At 24 h, the opsonized particles stimulated significantly higher levels of cytokine release, but only at the greatest particle concentrations. This study demonstrates that machined titanium alloy induces a metabolic response in macrophages similar to that of titanium-alloy particles retrieved from failed total hip arthroplasty. In addition, these data show that serum protein binding to orthopedic biomaterial debris alters the macrophage reaction to the particles.
This work describes experimental aspects of the measurement of relative interfacial energies from the equilibrium dihedral angles of small liquid inclusions or precipitates at interfaces in solids using in situ transmission electron microscopy. We demonstrate how limitations such as faceting, free surfaces, and projection errors can be handled to minimize experimental errors.