PubMed · 3282684
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
R L Bertolotti. 1988. Indirect veneers.. https://pubmed.ncbi.nlm.nih.gov/3282684/
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
BACKGROUND: At the Department of Ophthalmology, Heidelberg, Germany, posterior capsule opacification (PCO) of a silicone and an acrylic intraocular lens (IOL) with a sharp optic edge design was evaluated. PATIENTS AND METHODS: In a prospective study either the AMO ClariFlex silicone IOL or the Sensar AR40e hydrophobic acrylic IOL were implanted in 47 patients following uneventful phacoemulsification. Mean patient age was 76.2+/-7.8 (ClariFlex) and 73.4+/-12.9 years (AR40e), respectively. The mean follow-up time was 19.7+/-5.34 in the ClariFlex and 21.9+/-1.89 months in the AR40e group. PCO development was evaluated postoperatively using the EPCO 2000 analysis software (scale 0-4). Areas of interest were the total IOL optic, the central 3-mm zone as well as the capsulorhexis. RESULTS: In both groups, all patients achieved a BCVA of 20/32 (AR40e) and 20/25 (ClariFlex), respectively. There was a very low incidence of PCO development with a mean EPCO score of 0.07+/-0.2 (ClariFlex and 0.15+/-0.2 (AR40e). Within the 3-mm zone and the capsulorhexis, there was a tendency for even lower EPCO scores in both groups. We calculated a statistically significant difference for the two lens materials for all investigated IOL areas (Wilcoxon's test, p<0.05). CONCLUSION: Both IOLs with a sharp edge design showed good functional results, a stable position in the capsular bag as well as a low incidence of PCO development. However, the silicone IOL showed statistically significantly lower PCO scores.
OBJECTIVES: The purpose of this study was to evaluate the tensile bond strength (TBS) of Panavia F resin cement (PF) applied on dentine pre-treated with ED Primer (ED) and Clearfil Liner Bond 2V (CLB) coated with a layer of low-viscosity composite Protect Liner F (PLF) at 10 min, 24 h and 12 months after curing. METHODS: The labial surfaces of 60 bovine lower incisors were ground to obtain a flat dentine surface, allowing a demarcation of a 4.0 mm-diameter area with adhesive tape. The teeth were randomly divided in six groups; ED was applied in groups A I, A II and A III and CLB was applied, followed by PLF, in groups B I, B II and B III. A resin composite rod with a wire loop was luted directly to the prepared surface of each group with PF. The specimens of groups A I and B I were submitted to TBS test after 10 min. Groups A II and B II were submitted to TBS test after 24 h storage and groups A III and B III were submitted to TBS test after 12 months storage. Each specimen was inspected by SEM and classified according to the failure mode. Additionally, two representative specimens of each failure mode were sectioned for a composite/dentine interface SEM evaluation. RESULTS: No significant statistical differences were observed among the groups at 10 min and 24 h. Groups A III and B III presented the lowest TBS values (p<0.05) after 12 months storage. PF on resin-coated dentin (PLF) showed the highest TBS values and was statistically different to PF on dentine for all the groups. The fracture pattern was generally cohesive on the adhesive/hybrid layer for groups A I, A II and A III and cohesive on composite resin for B I, B II and B III. SIGNIFICANCE: The use of a less hydrophilic self-etching system to pre-treat dentine, coating with a low-viscosity composite layer prior luting with resin cement, may provide a protection of the hybridised complex, allowing a dentine seal during the 12 months storage period.
PURPOSE: To investigate whether inflammatory responses are more severe in uveitic eyes than nonuveitic eyes when acrylic intraocular lens (IOL) is implanted after cataract surgery. METHODS: Clear lens removal (phacoemulsification and aspiration) was conducted and the hydrophobic acrylic IOL (AR40e, AMO) was implanted in adult albino rabbits. Just after the operation, rabbits were divided into two groups. One group (nine rabbits) received intravitreal injection of lipopolysaccharide (LPS, 200 ng/10 microl) into both eyes to induce endotoxin-induced uveitis (EIU) and the other group (nine rabbits) received intravitreal injection of phosphate-buffered saline (PBS, 10 microl) into both eyes as the control. Aqueous humour (AH) and IOLs were harvested 1, 3 , and 7 days after the intravitreal injection. The infiltrating cell number in AH was counted and the protein concentration of AH was measured. IOLs were evaluated morphologically. RESULTS: At 1 day after intravitreal injection, both the infiltrating cell number in AH and protein concentration of AH were significantly higher in the LPS-injected group than in the PBS-injected group. Similarly, more inflammatory cells attached to the surfaces of the IOLs in the LPS-injected group. However, 7 days later, inflammatory reactions subsided and no clear differences in any of the parameters examined were observed between the two groups. CONCLUSIONS: At 7 days after the operation, inflammatory reactions in eyes implanted with the hydrophobic acrylic IOLs were similar in uveitic eyes and nonuveitic eyes. The data suggest that the hydrophobic acrylic IOLs may be suitable for patients with uveitis.