Search PubMed⌕ Search

PubMed · 16083896

Mucin at solution/air and solid/solution interfaces.

Abstract

In this paper the surface activity of protein mucin at solution/air interface has been studied. The experiments of the adsorbed protein at solution/air interface have been carried out with a range of protein concentrations at a defined pH. The adsorption of the protein to solid surfaces and the degree of hydrophobicity at solid/solution interface of mucin have been evaluated at different pH and in the presence of Hofmeister electrolyte. The results from these studies have been further substantiated by surface potential measurements of mucin covered surface on stainless steel. Quartz crystal microbalance (QCM) has been used to follow the protein adsorption kinetics from solution to solid surface. The results from these measurements show that the adsorption behavior has a remarkable dependence on the degree of maximum coverage and is almost independent of the ionic strength. Other characteristic features such as maximum adsorption values at the protein isoelectric point (IEP4.7) and low-affinity isotherms that showed surface saturation even under unfavorable electrostatic conditions have been observed. The amount of mucin adsorbed in the presence of electrolytes has been estimated using electron spectroscopy for chemical analysis (ESCA). The study clearly shows that there exists an inverse relationship between the hydrophobicity and surface tension of the protein and also on the hydrated radius of Hofmeister electrolyte used.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

R Maheshwari, Aruna Dhathathreyan. 2005-08-03. Mucin at solution/air and solid/solution interfaces.. https://doi.org/10.1016/j.jcis.2005.06.058

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

Impact of long-term partial aeration on the removal of 2,4,6-trichlorophenol in an initially methanogenic fluidized bed bioreactor.

A fluidized bed bioreactor (FBBR) was operated for more than 1000 days under two regimes, Methanogenic (M) and Methanogenic-Aerobic (M-A), to remove 2,4,6-trichlorophenol (TCP) and phenol (Phe) from a synthetic wastewater, containing different amounts of TCP and Phe, using different aeration flow-rates (0, 2.13, and 1.06 NL O(2)/L.day). M conditions (80:20 mg/L of TCP:Phe, 0 NL O(2)/L.day) showed similar TCP and Phe removal (>95%). Nevertheless accumulation of 4-chlorophenol (4CP) up to 16 mg/L and Phe up to 4 mg/L was observed, while in M-A conditions (80:20 mg/L of TCP:Phe, 2.13 NL O(2)/L.day) TCP and Phe removal achieved 99.9(+)% and after 70 days no accumulation of intermediates were detected. The increase of TCP and Phe in the influent under M-A conditions from 80:20 to 120:30 mg/L of TCP:Phe did not negatively affect the removal of TCP, intermediates and Phe; in fact, they were similar to those in previous M-A conditions. The decrease in the oxygen flow rate from 2.13 to 1.06 NL O(2)/L.day had no negative effect on pollutant removals, which were as high as in previous two M-A conditions. The specific methanogenic activity of bioparticles of the fluidized bed decreased with long-term partial aeration, starting from 1.097 mmol CH(4)/h.g(TKN) in the M regime (day 60) to <0.02 mmolCH(4)/h.g(TKN) at day 1050, suggesting aerobic regime in the bioreactor rather than an M-A regime. In conclusion, complete removal of TCP and less chlorinated intermediates could be achieved in an initially methanogenic FBBR under conditions of partial aeration, although long-term operation seemed to negatively affect the methanogenic activity of biomass. It is also likely that after extended aeration the microbial community was finally enriched with strains with the ability to attack 2,4,6-TCP under aerobic conditions. This report represents the first evidence of a long exposure to oxygen of an anaerobic microbial consortium that efficiently remove TCP.

Air↗

Understanding urban vehicular pollution problem vis-a-vis ambient air quality--case study of a megacity (Delhi, India).

Air pollution has become a growing problem in megacities and large urban areas through out the globe, and transportation is recognized as the major source of air pollution in many cities, especially in developing countries. Contribution of automobiles is reported in the range of 40 to 80% of the total air pollution. The challenge facing megacities is how to reduce the adverse environmental impacts and other negative effects of transportation without giving up the benefits of mobility. The dilemma becomes most pressing under conditions of rapid urban growth, which is likely to increase travel demand significantly. The paper is aimed at understanding the problem of vehicular pollution vis-a-vis ambient air quality for a highly traffic affected megacity, Delhi, wherein, the contribution of transport sector was estimated to be as high as 72%. An effort has been made to review and evaluate the benefits (in terms of improved air quality) of the technological interventions/policies adopted for vehicular pollution control in Delhi. It also highlights the outcome of the efforts and suggests further improvements thereon. The importance of public participation and awareness are also discussed. The paper focuses on deriving the benefits of the implementation of management strategies, supported by scientific and technical data/interpretation, so that the people can realize and participate in the government's endeavor for clean city drive in a more effective manner.

Air↗

Effect of reagent (dye) addition in wet chemical method of sulfur dioxide determination in ambient air.

For measurement of sulfur dioxide (SO2) in ambient air, the United States Environment Protection Agency (US EPA) had recommended the PRA dye-based colorimetric method as a reference technique. The method has been developed and applied in many countries for a longtime; however information regarding the sensitivity of the method with respect to sampling and analysis conditions is not available. Collaborative studies conducted in some of the South East Asian countries indicated substantial variations (of the order of 50%) in the measured concentrations against the true values. It was observed that dye used for color development plays an important role and even a slight variation in the way the dye solution is prepared can cause substantial variation in the measured SO2 concentration. Because a major objective of air quality measurements is to relate air pollution concentration to the effects of air pollution, it is important that the method used should yield accurate levels of the pollutant, so that appropriate management plans can be devised and implemented effectively. In the present investigation, therefore, the role of dye used in SO2 monitoring method has been highlighted. Different makes of dyes prepared in different modes were used to study the variation in the measured SO2 concentration levels. Specifications of all the dyes were also tested. Need for use of certified reference material (CRM) for SO2 has also been emphasized.

Air↗