PubMed · 15651232
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
Markus B Blatz, Avishai Sadan, Matthias Kern. 2004. Ceramic restorations.. https://pubmed.ncbi.nlm.nih.gov/15651232/
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
The main objective of this study was to measure the fracture toughness of the human teeth enamel using the microindentation technique and to compare the results calculated from the equations developed for Palmqvist and radial-median cracks. Vickers microhardness measurements of dental ceramic (alumina) and human teeth were performed using indentation fracture method. The fracture toughness of enamel was calculated using different equations reported in the literature. Vickers microhardness of the sintered alumina specimen (98.8% theoretical density) was measured to be 14.92 GPa under 9.8 N indentation load. Three equations based on the radial-median cracks were found to be applicable for the fracture toughness determination of the enamel. Results show that indentation fracture method is adequate to measure microhardness and fracture toughness of dental materials. However the calculation of fracture toughness depended on the nature of the cracks and also on the location of the indentation. Therefore, it is necessary to identify the crack profile and to select the appropriate equation for accurate fracture toughness values.
The use of ceramic-on-ceramic (alumina- and zirconia-based) couplings in hip joint prostheses has been reported to produce lower wear rates than other combinations (i.e., metal-on-polyethylene and ceramic-on-polyethylene). The addition of zirconia into an alumina matrix (zirconia-toughened alumina, ZTA) has been reported to result in an enhancement of flexural strength, fracture toughness, and fatigue resistance. The development of new processing routes in nonaqueous media has allowed to obtain high-density ZTA nanocomposites with a very homogeneous microstructure and a significantly smaller and narrower particle-size distribution of zirconia than conventional powder mixing methods. The aim of the present study was to set up and validate a new ZTA nanocomposite by testing its biocompatibility and wear behavior in a hip-joint simulator in comparison with commercial alumina and experimental alumina specimens. The primary osteoblast proliferation onto ZTA nanocomposite samples was found to be not significantly different from that onto commercial alumina samples. After 7 million cycles, no significant differences were observed between the wear behaviors of the three sets of cups. In this light, it can be affirmed that ZTA nanocomposite materials can offer the option of improving the lifetime and reliability of ceramic joint prostheses.
The preparation of a catecholamine receptor was carried out using a molecular imprinting method with silica-alumina gel to form complementary structures for template recognition. The molecularly imprinted polymer (MIP) was synthesized by the condensation of silicate from tetraethyl orthosilictate (TEOS) under hydrothermal conditions at 60 degrees C. Aluminum chloride was added as a functional monomer to increase the material's rebinding ability. The selectivity of the MIP receptor prepared with different ratios of template to Si and Al, was examined with seven analytes including: dopamine, epinephrine, norepinephrine, ascorbic acid, homovanillic acid, uric acid, and l-tyrosine. The results showed a size selective effect for the receptors with respect to the recognition of the catecholamines. Some factors affecting the recognition ability were investigated including: the solution pH of analytes, surface capping on the MIP, and the imprinting pH of the silica-alumina solution. Also, the catecholamine MIP films on quartz crystal microbalance (QCM) electrodes were fabricated as sensors for in situ monitoring of the analytes in a 2-propanol solution.