PubMed · 15396021
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
W M MacNEVIN. 1949-12-16. Electrolytically induced reactions.. https://doi.org/10.1126/science.110.2868.661
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
The electrochemical oxidation is a promising process for organic pollutants which are recalcitrant to biological degradation. The anodic oxidation of 1,5-naphthalenedisulfonic acid, hereafter NDS, was evaluated at a Pt anode using in situ generated Ag(II) cation or peroxydisulfate [S2O(8)(2-)] anion as mediators. Kinetics of the direct chemical oxidation of NDS in the presence of Na2S2O8, and the identification of some oxidation intermediates are also reported. An analysis of the results shows that Ag(II) is characterized by a high-reaction rates, while [S2O(8)(2-)] performs the oxidation of NDS in a complete way.
The present study encompasses the application of electrolysis as novel treatment technique for the abatement of low-salinity concentrates generated from the filtrative treatment of water and wastewater. Four different materials have been tested as anode for a number of brine samples in a one-compartment electrolytic cell in galvanostatic mode. It was found that PbO(2) and SnO(2) anodes initiated electrochemical precipitation through an increase of the pH. Boron-doped diamond (BDD) and RuO(2) anodes successfully oxidised the pollutants in the brine and a linear removal of total ammonia nitrogen (TAN) and chemical oxygen demand (COD) was observed during the first phase of oxidation. Oxidation was predominantly achieved through indirect hypochlorite bulk oxidation; the higher oxidation rate and extent for the BDD anode was attributed to the higher selectivity and activity of the latter. Overall performance of the BDD electrode was higher than for RuO(2): higher rates for TAN (17.9 vs. 13.5mg/Ah) and COD (74.5 vs. 20.0mg/Ah) removal as well as higher overall current efficiencies (35.2% vs. 14.5%). Extensive colour removal was observed for both anodes (>90% decrease in absorbency at 455 nm).
Commercial methyl-parathion (MeP) was detoxified using an electrochemical method that employed a Ti/Pt anode and stainless steel 304 as cathode. Sodium chloride was added as electrolyte and the mixture was passed through an electrolytic cell for 2 h. Due to the strong oxidizing potential of the produced chemicals, the organic pollutants were wet oxidized to carbon dioxide and water. A number of experiments were run at laboratory scale. Reductions of COD and BOD(5) were both over 80% and the mean energy consumption was 18-8 kWh per kg(-1) COD reduced (COD(r)). The degradation of MeP was more effective when the pH of the brine solution was in the acid range than when it was in the alkaline range. From the results it can be concluded that electrolysis could be used as an oxidation pre-treatment stage for detoxification of toxic wastes with MeP.