PubMed · 14626270
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
A Joseph Ecker. 2003. Extractions.. https://doi.org/10.1016/j.ajodo.2003.09.018
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
PURPOSE: This study compares the marginal accuracy of posterior metal ceramic (MC), all-ceramic IPS Empress 2 and experimental pressed ceramic (EPC-VP 1989/4) three-unit fixed partial dentures (FPD), before and after luting and after thermo-mechanical fatigue in a dual-axis chewing simulator. MATERIALS AND METHODS: Caries-free human teeth (n=160) were used as abutments for the fabrication of eighty posterior three-unit FPD, divided into two test-groups, IPS Empress 2 and EPC, of 32 samples each and one control group of 16 samples metal ceramic FPD. All FPD were cemented with Variolink II dual-curing resin cement. Half of the samples in each group were exposed to a dual-axis chewing simulator. RESULTS: The geometric mean marginal gap values (microm, before cementation, after cementation and after thermo-mechanical fatigue) amounted to 53, 63 and 62 for the ceramic metal FPD, 57, 71 and 68 for the Empress 2 FPD and 55, 67 and 68 for the EPC FPD. In all groups a statistically significant increase in marginal gap width was observed after cementation. The effect of functional loading in the chewing simulator on marginal gap was not significant. Marginal gap was lowest in the control group but differences with all-ceramic materials were small in all evaluation stages. CONCLUSION: Within the limits of this investigation, it can be concluded that marginal gap values of these all-ceramic materials and conventional MC techniques are on a similar level. In particular, almost all marginal gap values observed in this study were within the limits of clinical acceptance.
The purpose of this study was to compare the removal of root surface smear layer following active application of EDTA gel and EDTA-T (texapon) gel in different concentrations (5%, 10%, 15%, 20% and 24%), using scanning electron microscopy. A total of 220 dentin blocks obtained from the root surfaces of extracted teeth were divided into 3 groups: Group I - (control) application of saline solution (n = 20); Group II - EDTA gel (pH 7.0) was applied in the following concentrations: 5%, 10%, 15%, 20% and 24% (n = 100); Group III - EDTA-T gel (pH 7.0) applied in the same concentrations described above (n = 100). The photomicrographs were evaluated by one calibrated examiner using a smear layer removal index and following statistical analysis (Kruskal-Wallis test). The results demonstrated that the specimens treated with EDTA and EDTA-T gel presented a better smear layer removal than the control group (p < 0.01); no statistically significant differences were observed between the EDTA and EDTA-T groups and between the concentrations tested (Mann-Whitney, p > 0.05). Within the limits of this study, it can be concluded that all treatment modalities effectively removed the smear layer from the root surface. The addition of texapon into the EDTA gel formulation did not increase its effectiveness.
This section deals with the important issue of impacted teeth. Impacted canines in Class I uncrowded cases can be improved by removal of the deciduous canines. There is some evidence that this is true for both buccal and palatal impactions. Treatment of impacted canines is lengthy and potentially hazardous. Interceptive measures are effective and preferred to active treatment. Supernumerary teeth may also cause impaction of permanent incisors, their early diagnosis and appropriate treatment is essential to optimise final outcomes. If there are any doubts about impacted teeth it is better to refer too early than too late, this latter option may unnecessarily extend the length of treatment as well as the treatment required.