PubMed · 1446207
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
B C Cohney. 1992. Polyurethane foam covered prostheses.. https://doi.org/10.1016/0007-1226(92)90158-t
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
This research was undertaken to address environmental concerns associated with industrial solid waste and to reduce cement consumption in geotechnical engineering. It specifically investigates the feasibility of using steel slag (SS) and silica fume (SF) as partial substitutes for ordinary Portland cement (OPC) in soil stabilization. The effects of SS, SF, OPC, and initial moisture content on the unconfined compressive strength (UCS) of stabilized soil were investigated through single-factor experiments and response surface methodology (RSM). The results show that SS and SF can synergistically enhance the strength of stabilized soil, although their interaction effect was not statistically significant within the investigated ranges. Compared with soil stabilized solely with OPC, the addition of 18 % SS and 10 % SF reduced OPC consumption by 3 % without compromising strength. Microstructural and compositional analyses further revealed that SS mainly supplied calcium- and silica-bearing components, while SF provided highly reactive silica and micro-filling effects, jointly promoting hydration reactions and improving the compactness of the stabilized soil matrix. As a result, more hydration products were formed in the OPC/SS/SF-stabilized soil than in the OPC-stabilized soil, which contributed to pore filling and strength enhancement. This study provides useful guidance for the sustainable utilization of industrial solid waste and the low-carbon development of soil stabilization materials.
Explore the source record for details and available documents.
At a high-energy, high-intensity proton accelerator facility, the accelerator components inside the beam-line tunnel and the concrete wall of the tunnel are activated due to beam loss during operation. During maintenance work inside the tunnel, radiation emitted from these activated materials can cause exposure to radiation workers. In this study, the relation between the surface dose rate of activated materials and the induced radioactivity was considered, and an evaluation of the major radioactivity using the surface dose rate was made. It has been revealed that (22)Na in Al samples and (54)Mn in Fe samples, (60)Co and (54)Mn in Fe samples, and (60)Co in Fe and Cu samples are principal residual radionuclides after a few hundred days of cooling about a few years of cooling and approximately 10 y of cooling, respectively.