PubMed · 14342374
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
L SIEGEL. 1965. A METHOD FOR CONVERTING VOLTAGE LEVELS.. https://doi.org/10.1901/jeab.1965.8-339
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
Electrical impedance tomography (EIT) was used to monitor the movement of a fluorinated hydrocarbon dense nonaqueous phase liquid (DNAPL) through a saturated porous medium within a laboratory column. Impedance measurements were made using a horizontal plane of 12 electrodes positioned at regular intervals around the centre of the column. A 2D inversion algorithm, which incorporated the cylindrical geometry of the column, was used to reconstruct resistivity and phase images from the measured data. Differential time-lapse images of DNAPL movement past the plane of electrodes were generated by the cell-by-cell subtraction of resistivity and phase baseline models from those associated with the DNAPL release stage of the experiment. The DNAPL pulse was clearly delineated as resistive anomalies in the differential time-lapse resistivity images. The spatial extent of the resistive anomalies indicated that in addition to vertical migration, some lateral spreading of the DNAPL had occurred. Residual contamination could be detected after quasi-static conditions were reestablished. Residual DNAPL saturation was estimated from the resistivity model data by applying Archie's second equation.Despite significant measured phase changes due to DNAPL contamination, the differential phase images revealed only weak anomalies associated with DNAPL flow; these anomalies could be seen only in the initial stages of the experiment during peak flow through the plane of electrodes.
Explore the source record for details and available documents.
The proper management of discarded electronic devices (E-waste) is an important issue for solid waste professionals because of the magnitude of the waste stream and because these devices often contain a variety of toxic metals (e.g., lead). While recycling of E-waste is developing, much of this waste stream is disposed in landfills. Leaching tests are frequently used to characterize the potential of a solid waste to leach when disposed in a landfill. In the United States, the Toxicity Characteristic Leaching Procedure (TCLP) is used to determine whether a solid waste is a hazardous waste by the toxicity characteristic. The TCLP is designed to simulate worse-case leaching in a landfill environment where the waste is co-disposed with municipal solid waste (MSW). While the TCLP is a required analysis from a regulatory perspective, the leachate concentrations measured may not accurately reflect the concentrations observed under typical landfill conditions. Another method that can be performed to assess the degree a pollutant might leach from a waste in a landfill is to use actual landfill leachate as the leaching solution. In this study, two lead-containing components found in electronic devices (printed wire boards from computers and cathode ray tubes from computers and televisions) were leached using the TCLP and leachates from 11 Florida landfills. California's Waste Extraction Test (WET) and the Synthetic Precipitation Leaching Procedure were also performed. The results indicated that the extractions using MSW landfill leachates resulted in lower lead concentrations than those by the TCLP. The pH of the leaching solution and the ability of the organic acids in the TCLP and WET to complex with the lead are factors that regulate the amount of lead leached.