PubMed · 12074232
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
Chris H Miller. 2002. Tips on preparing instruments for sterilization.. https://pubmed.ncbi.nlm.nih.gov/12074232/
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
OBJECTIVE: The purpose of this study was to evaluate and compare in vitro, the galvanic corrosion behavior of Co-Cr alloys (R2000, R800), Ni-Cr (RCS), silver-palladium (Jelstar), Gold (Pontallor-4) and Ternary Ti (experimental Ter Ti) when coupled with endosseous Ti implant abutment material. Amalgam alloy and commercially pure Ti cylinders (SSTi) were coupled with endosseous Ti implants as negative and positive controls, respectively. METHODS: An EG&G Model 263 Scanning Potentiostat was used for this purpose. Specimens were prepared and fresh artificial saliva was used as an electrolyte solution. The experiment run time was 24h for each couple. The common potential, galvanic current and current integration during the last 6h were recorded for each couple. RESULTS: The results showed that the best couples were Ti/Pontallor-4, Ti/Ter Ti, Ti/R800 and Ti/Jelstar. The least acceptable couples were Ti/amalgam, SSTi/SSTi and Ti/R2000, while the Ti/RCS couple showed unstable galvanic corrosion behavior. SIGNIFICANCE: It is concluded that the following alloys can be used as suprastructure alloys with Ti implants: Pontallor-4, R800, Jelstar and Ter Ti. Although Ter Ti alloy is an experimental alloy, it showed good results, but cannot be used in the clinical field unless extensive investigations are carried out. The SSTi/SSTi couple showed unexpected galvanic corrosion behavior which needs further investigation.
It is well known that the osseointegration of the commercially pure titanium (c.p. Ti) dental implant is improved when the metal is shot blasted in order to increase its surface roughness. This roughness is colonised by bone, which improves implant fixation. However, shot blasting also changes the chemical composition of the implant surface because some shot particles remain adhered on the metal. The c.p. Ti surfaces shot blasted with different materials and sizes of shot particles were tested in order to determine their topographical features (surface roughness, real surface area and the percentage of surface covered by the adhered shot particles) and electrochemical behaviour (open circuit potential, electrochemical impedance spectroscopy and cyclic polarisation). The results demonstrate that the increased surface area of the material because of the increasing surface roughness is not the only cause for differences found in the electrochemical behaviour and corrosion resistance of the blasted c.p. Ti. Among other possible causes, those differences may be attributed to the compressive residual surface stresses induced by shot blasting. All the materials tested have an adequate corrosion and electrochemical behaviour in terms of its possible use as dental implant material.
This paper describes the application of magnetically-soft ribbon-like sensors for measurement of temperature and stress, as well as corrosive monitoring, based upon changes in the amplitudes of the higher-order harmonics generated by the sensors in response to a magnetic interrogation signal. The sensors operate independently of mass loading, and so can be placed or rigidly embedded inside nonmetallic, opaque structures such as concrete or plastic. The passive harmonic-based sensor is remotely monitored through a single coplanar interrogation and detection coil. Effects due to the relative location of the sensor are eliminated by tracking harmonic amplitude ratios, thereby, enabling wide area monitoring. The wireless, passive, mass loading independent nature of the described sensor platform makes it ideally suited for long-term structural monitoring applications, such as measurement of temperature and stress inside concrete structures. A theoretical model is presented to explain the origin and behavior of the higher-order harmonics in response to temperature and stress.