Search PubMed⌕ Search

PubMed · 11769317

Temperature data for phenological models.

Abstract

In an arid environment, the effect of evaporation on energy balance can affect air temperature recordings and greatly impact on degree-day calculations. This is an important consideration when choosing a site or climate data for phenological models. To our knowledge, there is no literature showing the effect of the underlying surface and its fetch around a weather station on degree-day accumulations. In this paper, we present data to show that this is a serious consideration, and it can lead to dubious models. Microscale measurements of temperature and energy balance are presented to explain why the differences occur. For example, the effect of fetch of irrigated grass and wetting of bare soil around a weather station on diurnal temperature are reported. A 43-day experiment showed that temperature measured on the upwind edge of an irrigated grass area averaged 4% higher than temperatures recorded 200 m inside the grass field. When the single-triangle method was used with a 10 degrees C threshold and starting on May 19, the station on the upwind edge recorded 900 degree-days on June 28, whereas the interior station recorded 900 degree-days on July 1. Clearly, a difference in fetch can lead to big errors for large degree-day accumulations. Immediately after wetting, the temperature over a wet soil surface was similar to that measured over grass. However, the temperature over the soil increased more than that over the grass as the soil surface dried. Therefore, the observed difference between temperatures measured over bare soil and those over grass increases with longer periods between wettings. In most arid locations, measuring temperature over irrigated grass gives a lower mean annual temperature, resulting in lower annual cumulative degree-day values. This was verified by comparing measurements over grass with those over bare soil at several weather stations in a range of climates. To eliminate the effect of rainfall frequency, using temperature data collected only over irrigated grass, is recommended for long-term assessment of climate change effects on degree-day accumulation. In high evaporative conditions, a fetch of at least 100 m of grass is recommended. Our results clearly indicate that weather stations sited over bare soil have consistently higher degree-day accumulations. Therefore, especially in arid environments, phenology models based on temperature collected over bare soil are not transferable to those based on temperature recorded over irrigated grass. At a minimum, all degree-day-based phenology models reported in the literature should clearly describe the weather station site.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

R L Snyder, D Spano, P Duce, C Cesaraccio. 2001. Temperature data for phenological models.. https://doi.org/10.1007/s004840100103

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

Comprehensive source-risk assessment of organophosphate esters in surface water of the Dianchi Lake Basin, Yunnan, China.

Organophosphate esters (OPEs), widely used as flame retardants and plasticizers, have been increasingly detected in aquatic environments. However, investigations of their distribution in high-altitude plateau lakes remain scarce. Identifying and quantifying the sources and associated risks of OPEs are crucial for subsequent water environment management. In this study, an integrated source-risk analysis approach was employed by combining the Positive Matrix Factorization (PMF) model, the Geodetector (GD) model, and risk quotient (RQ). Analysis of 14 OPEs in surface waters of the Dianchi Lake Basin (DLB) revealed 12 detectable compounds, with total OPEs concentrations (ΣOPEs) ranging from not detected (ND)-64.6 ng/L during the wet season and ND-35.8 ng/L during the dry season. Elevated ΣOPEs were primarily observed at inflow sites in the northern part of the lake and in urban rivers. Source apportionment indicated four major contributing sources: agricultural films containing flame-retardant and plasticizer additives, traffic-related particulate emissions, releases from household and personal care products, and industrial production and applications of flame retardants in plastics, electronics, and related products (the predominant source). The ecological impact caused by OPEs ranges from no risk to low risk, with tris(2-chloroethyl) phosphate emitted from industrial source being the primary driver of potential environmental risk. These findings highlight the necessity of prioritizing industrial sources in future management strategies. Overall, this study provides a methodological framework for source apportionment and risk assessment of OPEs and offers scientific evidence to support environmental management of OPEs in the DLB.

Environmental Monitoring↗

Integrated ambient ozone evaluation by passive samplers and clover biomonitoring mini-stations.

An ozone monitoring network was set up using passive samplers and biological mini-stations of two clones of white clover (Trifolium repens L. cv. Regal), NC-R (O(3)-resistant) and NC-S (O(3)-sensitive). This paper reports on a pilot study performed in the period June-October 1999 in the Rome municipal area by using five biomonitoring mini-stations and ozone passive samplers with a new nitrite based design. This combined methodology can be used to obtain information on the biological implications of the injury due to tropospheric ozone. The two techniques can integrate data for the short-medium period and can be placed in different urban and rural sites, proving to be a very useful tool for ozone concentration mapping.

Environmental Monitoring↗

Microscopic observations of reductive manganite dissolution under oxic conditions.

At oxic/anoxic transition zones, manganese release from (hydr)oxide minerals into aqueous solution is a dynamic balance between mineral dissolution and Mn2+(aq) oxidation and precipitation, which are processes respectively promoted by organic reductants and molecular oxygen. We employ a flow-through atomic force microscope reactor (AFM-R) to investigate the reductive dissolution of the [010] surface of manganite (gamma-MnOOH) across a range of pH values and ascorbic acid concentrations in aqueous solutions equilibrated with atmospheric CO2 and O2. The apparent dissolution rate increases with higher ascorbic acid concentrations and lower pH values. Concurrent changes in surface morphology show that dissolution proceeds at low pH via etching and step retreat, while at high pH dissolution is concurrent with precipitation. The precipitates are characterized ex situ by X-ray photoelectron spectroscopy (XPS) and found to be Mn(III)-oxide. The onset of precipitation is consistent with an analysis of the thermodynamic driving forces for the reactions of a two-step mechanism. In the first step, Mn2+ is released to aqueous solution by reduction of gamma-MnOOH in reaction with ascorbic acid. This step is thermodynamically favorable under all conditions employed. In the second step, which leads to precipitation, surface adsorbed Mn2+ is oxidized by O2 to yield a Mn(III)-oxide precipitate. This step is thermodynamically possible only at pH > 5 for our experimental conditions. When the second step is active, the apparent dissolution rate equals the intrinsic dissolution rate minus the precipitation rate. Analysis of the growth rates observed in AFM indicates the precipitation rate reaches 71% of the intrinsic dissolution rate under some reactor conditions. Comparison of our gamma-MnOOH results to literature reports for Mn2+ oxidation on gamma-FeOOH indicates gamma-MnOOH is a more effective surface catalyst by a factor of 10(8).

Environmental Monitoring↗