Biomechanical stability and design. Strength.
Explore the source record for details and available documents.
Biomedical subjects
Publications and source records attributed to W Bonfield.
Explore the source record for details and available documents.
Explore the source record for details and available documents.
Explore the source record for details and available documents.
As cortical bone is a semi-brittle solid, its fracture is dependent not only on the magnitude of the applied stress, but also on the nature of any intrinsic or introduced cracks. Consequently a variety of fracture mechanics techniques have been utilised to evaluate the fracture toughness of cortical bone, including the single edge notched, centre notched cylindrical and compact tension methods, and values have been established for the critical stress intensity factor (Kc) and the critical strain energy release rate (Gc). The Kc and Gc values obtained depend on the orientation of the cortical bone, as well as on bone density, the velocity of crack propagation and specimen geometry. The significance of these fracture mechanics parameters for cortical bone is critically reviewed.
The fracture mechanics parameters of critical stress intensity factor (Kc) and critical strain energy release rate (Gc) for longitudinal fracture of bovine tibia cortical bone were determined by the compact tension method. It was demonstrated that, for a given bone density, Kc and Gc depended on the loading rate, and resultant crack velocity, with a maximum in fracture toughness (Kc approximately 6.3 MNm-3/2, Gc approximately 2900 Jm-2) at a crack velocity approximately 10(-3) ms-1. For a given loading rate, or crack velocity, an increase in bone density, in the range from 1.92 to 2.02 Mgm-3, produced increases in Kc and Gc, but a variation in specimen thickness (from 0.5 to 2 mm) had no effect on the measured fracture mechanics parameters.
Explore the source record for details and available documents.
A pulsed differential ultrasonic technique for the determination of the elastic stiffness coefficients of bone sections in the 'wet' condition, at any required temperature, has been developed. Some preliminary measurements of the Young's modulus of longitudinally oriented mature bovine femur cortical bone sections by this technique gave average values ranging from 23.6 GNm-2 at 17 degrees C to 21.8 GNm-2 at 41 degrees C.
Explore the source record for details and available documents.
Explore the source record for details and available documents.
Explore the source record for details and available documents.
Explore the source record for details and available documents.
Explore the source record for details and available documents.
Explore the source record for details and available documents.
Explore the source record for details and available documents.
Human osteoblast-like (bone-forming) cells were imaged using environmental scanning electron microscopy (ESEM). The cells were hydrated, unfrozen, and uncoated. Specimens were cooled to 3 degrees C and imaged in water vapor, with partial pressures varying from saturated conditions to a humidity of approximately 50%, relative to pure water. The ESEM images show the presence of cell nuclei, nucleoli, and cytoplasmic membranes. Comparisons between chemically fixed and unfixed specimens (neither dried nor coated) show that cell morphologies are similar in both cases. These results are compared with a fixed, dried, carbon-coated specimen. Thermodynamic and kinetic arguments are used to show that humidities significantly lower than 100% correspond to metastable states suitable for stabilizing hydrated biological tissues and cells. The ability to perform observations with minimal specimen preparation is potentially useful for studying interactions between mammalian cells and biomaterials that are developed for tissue engineering. The methods employed are equally applicable to the study of specimens in the biological, materials, and physical sciences where careful control over specimen stability is required.
Hydroxyapatite has been investigated for use in the osseous environment for over 20 years and the biocompatibility of the ceramic and its osseoconductive behavior is well established. Therefore, the use of porous hydroxyapatite for the repair of osseous defects seems promising with potential for complete penetration of osseous tissue and restoration of vascularity throughout the repair site. However, there have been few systematic studies of the effects of physical properties such as macropore size and pore connectivity on the rate and quality of bone integration within porous hydroxyapatite implants. This paper quantifies the early biological response to a well-characterized series of implants with uniform microstructure and phase composition, but differing macrostructures and demonstrates the dependence of the rate of osseointegration on the apparent density of porous hydroxyapatite as a function of pore connectivity. Furthermore, compression testing established that bony ingrowth has a strong reinforcing effect on porous hydroxyapatite implants, which is more pronounced in the lower density implants, as a result of a greater relative volume of bone ingrowth.
A drug delivery system (DDS) which provides a sustained release of antibiotics at the focal site either singly, or in combination with a bone stimulating factor could both eliminate infection and increase the number of potentially healthy osteogenic cells. In this study, we address the use of a degradable gelatin DDS, for the combined release of therapeutic levels of both gentamicin and growth hormone (GH). An initial bolus release was observed during the first 24 h followed by a reduced, but sustained, release for both drugs up to 14 days. Bioactivity of gentamicin was demonstrated by growth inhibition of Staphylococcus aureus for over 96 h with a mean zone of inhibition of 29.4 mm (+/-0.19) for the time period studied. Furthermore, GH was shown to have a direct effect on primary human osteoblast-like (HOB) cells, stimulating proliferation and enhancing their differentiation. Site-specific drug delivery offers the advantage of localizing a drug directly at the target site, thus minimizing systemic effects. The results of this study suggest that gelatin is a good DDS for the combined release of drugs. In addition, gelatin is both biocompatible and biodegradable, thus making it a promising DDS for the management of acute and chronic bone and tissue infection such as osteomyelitis.