Search PubMed⌕ Search

Biomedical subjects

Uwe Karst

Publications and source records attributed to Uwe Karst.

45 records · Page 3Linked to original sources

LC-electron capture-APCI(-)-MS determination of nitrobenzoxadiazole derivatives.

Nitrobenzoxadiazole (NBD) derivatives are determined with limits of detection ranging down to 20 nmol l(-1) using liquid chromatography-mass spectrometry (LC-MS) with electron capture (EC) ionisation. An atmospheric pressure chemical ionisation (APCI) interface operated in the negative ion mode is used as ionisation source. Amine derivatives of 4-chloro-7-nitro-2,1,3-benzoxadiazole (NBDCl) as well as the isocyanate derivatives of 4-nitro-7-piperazino-2,1,3-nitrobenzoxadiazole (NBDPZ) have been analysed using this technique. The parameters favouring electron capture mechanisms have been investigated thoroughly under consideration of the competing mechanism of deprotonation to allow a better understanding of the electron capture process and to improve selectivity of the analysis.

Chromatography, Liquid↗

4-Nitro-7-piperazino-2,1,3-benzoxadiazole as a reagent for monitoring of airborne isocyanates by liquid chromatography.

4-Nitro-7-piperazino-2,1,3-benzoxadiazole (NBDPZ) is presented as a new reagent for the determination of mono- and diisocyanates in air samples. NBDPZ readily reacts with the airborne analytes, thus yielding the corresponding urea derivatives, which are subsequently separated by means of reversed-phase liquid chromatography. On a phenyl-modified stationary phase, excellent baseline separation for numerous mono- and diisocyanate derivatives is obtained. Both diode array and fluorescence detection are performed with limits of detection of 11-35 and 5-9 nmol/L for the individual derivatives, respectively. In contrast to established derivatizing agents for the analysis of isocyanates, NBDPZ provides for increased selectivity due to the favorable detection wavelengths in the visible range (UV/visible, absorption maximums approximately 480 nm; fluorescence, excitation maximums approximately 470 nm, emission maximums approximately 535 nm). In addition, the high molar absorptivities of the reagent and the derivatives provide excellent sensitivity that is superior to most literature-known methods. Finally, air sampling methods comprising both the use of impingers and test tubes are developed and successfully applied to the determination of isocyanates in gaseous samples. Excellent recovery reaching values of >90% is observed for each of the two techniques investigated.

Air Pollutants↗

Fast liquid chromatography-electrochemistry-mass spectrometry of ferrocenecarboxylic acid esters.

Rapid liquid chromatographic separations of ferrocenecarboxylic esters of various alcohols and phenols have been achieved on reversed-phase columns of 20 mm length. After separation, the ferrocene derivatives are oxidized electrochemically under formation of the charged ferrocinium species, which are easily detected by mass spectrometry using an atmospheric pressure chemical ionization source operated in the heated nebulizer mode. While a series of nine phenol derivatives was separated within less than 1.5 min, six alcohol derivatives eluted within 1 min. Limits of detection using a single quadrupole mass analyzer ranged from 60 to 190 nmol/l. Additional work was directed on the use of a graphite in-line filter instead of a silica-based reversed-phase column to achieve the separation.

Chromatography, Liquid↗

On-line electrochemistry--MS and related techniques.

This review summarizes publications on the on-line coupling of electrochemistry with mass spectrometry. After a brief historic introduction it is divided into three parts, organized in order of increasing complexity of the experimental arrangement. The first section deals with the use of the electrospray ion source as an electrochemical reactor for oxidation or reduction reactions. It is followed by the second part which covers the hyphenation of different kinds of electrochemical flow cell with a variety of ionization interfaces. The last section focuses on the on-line coupling of chromatographic techniques with electrochemical flow cells and mass spectrometry.

Journal Article↗

LC-electron capture APCI-MS for the determination of nitroaromatic compounds.

The determination of selected nitroaromatic compounds in liquid chromatography-mass spectrometry with electron capture (EC) ionisation using a commercial atmospheric pressure chemical ionisation (APCI) interface in the negative mode is described. The electron capture effect is observed for nitroaromatics which do not easily undergo deprotonation under these conditions. Depending on the structure of the analytes, either dissociative or, for the first time in LC-MS, non-dissociative electron capture is observed. Limits of detection and linear range for the determination of the analytes match those obtained for nitroaromatics which undergo deprotonation. The investigated substances comprise numerous substituted nitrobenzenes and nitrobenzooxadiazoles.

Journal Article↗

A field test for the detection of peroxide-based explosives.

A rapid and simple field test for the detection of triacetone-triperoxide (TATP) and hexamethylenetriperoxidediamine (HMTD), two explosives which find significant illegal use, has been developed. Unknown samples are first treated with a catalase solution to remove hydrogen peroxide traces, in order to provide selectivity towards peroxide-based bleaching agents which are contained in commercial laundry detergents. Subsequently, the peroxide-based explosives are decomposed via UV irradiation, thus yielding hydrogen peroxide, which is determined by the horseradish peroxidase (POD) catalysed formation of the green radical cation of 2,2'-azino-bis(3-ethylbenzothiazoline)-6-sulfonate (ABTS). The limits of detection for this method are 8 x 10(-6) mol dm(-3) for TATP and 8 x 10(-7) mol dm(-3) for HMTD, respectively. As an option, p-hydroxyphenylacetic acid (pHPAA) may be used as peroxidase substrate, resulting in lower limits of detection (8 x 10(-7) mol dm(-3) for TATP and HMTD). The complete method uses a mobile setup to be applied under field conditions.

Explosions↗

Selective determination of hydrogen peroxide by adduct formation with a dinuclear iron(III) complex and flow injection analysis/tandem mass spectrometry.

A highly selective method for the determination of hydrogen peroxide is presented. In a flow injection analysis (FIA) instrument, the analyte is brought into contact with a dinuclear heptadentate iron(III) complex. The formation of the peroxide adduct is quantified using electrospray tandem mass spectrometry (ESI-MS/MS). Selected reaction monitoring (SRM) based on the transition from the triply charged peroxide adduct with m/z = 251.2 to the triply charged fragment ion of m/z = 240.5 is performed. The limit of detection for hydrogen peroxide is 10(-7) mol dm(-3), limit of quantification is 3 x 10(-7) mol dm(-3), and a linear range of 2.5 decades starting at the limit of quantification is observed.

Journal Article↗