Search PubMed⌕ Search

SEARCH · Search PubMed

Results for “ESTHETICS, DENTAL”

Search indexed PubMed citations on genomics, clinical trials, systematic reviews and public health. Explore titles, authors and supplied subject terms, then open the PubMed record.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,459 records · Page 81Linked to original sources

Clinical management of non-carious enamel defects.

Enamel defects not caused by decay may occur singly or may be generalized over the entire tooth surface. In the past, treatment of these aesthetic problems required large cavity preparations or full crown coverage of the affected teeth. Now, with the advent of various resin restorative materials capable of bonding to enamel, new techniques are being developed which are less radical. By etching the surface of the enamel with varying concentrations of dilute phosphoric acid, sufficient porosity is produced to allow the resin to adhere to it. Thus, by removing a minimal amount of tooth structure, the affected area can be masked with a thin layer of resin material after the surface has been properly prepared. If the fault in the enamel is generalized, the whole surface of the tooth may be restored using this technique, effectively covering the tooth with an aesthetic veneer. The new resin filling materials offer good colour stability as well as resistance to abrasive wear. Tests have revealed that this mode of treatment has a successful retention rate of over 92 per cent after 5 years. Lightly discoloured or stained defects of the enamel may be treated by bleaching the affected area with no adverse effect on the pulp tissue. Those teeth not improved by bleaching can be conservatively managed by veneering their surfaces with smooth finishing plastic materials.

Acid Etching, Dental↗

The development of a posterior tooth composite system, in-vitro investigation.

Adaptation and marginal seal of conventional MOD composite restorations was investigated in vitro with the scanning electron microscope and a dye penetration test. An optimal adaptation i.e. with over 90% "perfect margin" was achieved in conventional MOD cavity preparations without using the enamel-etch technique. After applying a composite sealer the proximal boxes were filled with a condensable composite to the level of the occlusal floor. Only after the proximal portions had hardened was the occlusal portion of the restoration completed. The proximal margin of an MOD composite restoration made in this manner is, in comparison to amalgam, about four times better adapted, however, because of the conventional cavity form with sharp line angles there is some percolation. With the presently available composite materials a clinically acceptable posterior resoration comosite system can be constructed: For the initial proximal portion a sufficiently radiopaque, condensable, not necessarily wear resistant composite would be used, and for the occlusal portion a proven wear-resistant, not necessarily radiopaque composite. On the basis of experiments measuring roughness it could be shown in test samples and in MOD composite restoration, in vitro and in vivo, that ultrafine diamond burs were well suited for the finishing of conventional and microfill composites. For the finishing of MOD microfill composites burs with fine and ultrafine diamond particles and specially developed forms are necessary.

Dental Cavity Preparation↗