Search PubMedSearch

PubMed · 9391587

Temporal representations with cochlear implants.

Abstract

OBJECTIVE: To record and characterize intracochlear evoked potentials (EPs) for a variety of electrical stimuli in studies with cochlear implant patients. METHODS: Recordings were made with patients having direct percutaneous access to their implanted electrodes. Intracochlear voltages were recorded via unstimulated electrodes. The stimuli included trains of identical pulses, with pulse rates ranging from 100 to 4065/s, and a modulated pulse train produced by a single-channel speech processor, with the pulse rate of 824/s. RESULTS: Magnitudes of EPs for each pulse in trains of identical pulses were uniform for pulse rates below about 200/s. For rates between about 400 and 1000/s, an alternating pattern of EP magnitudes was observed, with relatively large EPs following the odd-numbered pulses. For rates between about 1000 and 3000/s, more complex patterns were observed. After the first millisecond of each train at even higher rates, uniform EPs again were observed across pulses, although the absolute magnitude of the EPs was much lower than that observed for low rates of stimulation. The approximate rates corresponding to boundaries between these different regions varied among subjects and among electrodes within subjects. EP magnitudes for the modulated pulse train reflected the gross periodicity of the modulation waveform but did not reflect temporal details within the periods. CONCLUSIONS: Population responses of the human auditory nerve, as indicated by EP magnitudes, reflect the amplitudes of electrical pulses for pulse rates below about 200/s and above about 3000/s. Use of intermediate rates may introduce distortions in the transmission of stimulus information with cochlear implants.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

B S Wilson, C C Finley, D T Lawson, M Zerbi. 1997. Temporal representations with cochlear implants.. https://pubmed.ncbi.nlm.nih.gov/9391587/

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

[Cold deformation elements for attaching an implantable hearing aid transducer to ear ossicles or perilymph].

Development and short-term implantation results of the Tübingen implantable hearing aid (TI = Tübingen implant) have been presented. The TI is designed for patients with sensorineural hearing loss due to a malfunction of the cochlear amplifier. This can be identified by the presence of positive recruitment and the absence of TEOAE (transitory evoked otoacoustic emissions). The Tübingen implant functions in two ways: it allows electronic amplification of the auditory signal and electromechanical signal transduction into a micromechanical vibratory stimulus. There are two paths by which vibratory stimulus reaches the cochlea: (1) directly through a perforation in the stapes foot plate into the perilymph or (2) via the ossicular chain. Made of pure titanium, the casing of the helium-tight welded transducer includes the piezoelectric actuator. An implantable manipulator device is designed for transducer positioning and anchoring in the mastoid cavity. Usually, the transducer probe tip is directly coupled to the body of the incus. This functions without a special coupling device by utilization of an Erbium-YAG laser. Special anatomical situations or the loss of incus and/or stapes suprastructure, however, requires coupling of the vibratory signal to other points of the ossicular chain or to the perilymph. A major problem, however, was an intraoperative, irreversible link between the titanium probe tip and coupling elements. To overcome this problem, the coupling elements were made of gold. A crimp technique was developed, allowing the surgeon to induce cold deformation of the gold. The cold deformation technique (crimp) results in an irreversible coupling between the titanium probe tip and the golden coupling element.

Cochlear Implantation