PubMed · 8897308
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
C Ercoli, T C Abrahamsen. 1996. A simple method for making accurate duplicate casts.. https://doi.org/10.1016/s0022-3913(96)90556-9
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
Azotobacter vinelandii forms desiccation-resistant cysts which contain a high proportion of the exopolysaccharide alginate in their envelope. We have previously shown that the A. vinelandii alginate biosynthetic genes algA and algL are transcribed from a promoter located somewhere upstream of algL. In this study we sequenced the A. vinelandii algX, algL, algV, algI and algF genes located between algG and algA. We carried out primer extension analysis of the algG, algX and algL genes and detected transcription start sites upstream algG but not upstream algX or algL, implying that algG and algX form part of the previously identified algL-A operon. A promoter upstream algA was also detected; however, transcription of algA exclusively from this promoter is not sufficient for the AlgA levels required for alginate production. An algF mutant (AJ34) was constructed by insertion of the Omega-tetracycline cassette in the non-polar orientation. As expected, AJ34 produced unacetylated alginate. Viability of 35day old cysts formed by strain AJ34, but not of those formed by the wild type, was reduced, indicating that acetylation of alginate plays a role in cyst resistance to desiccation.
With the aim of producing a biomaterial for surgical applications, the alginate-hyaluronate association has been investigated to combine the gel-forming properties of alginate with the healing properties of hyaluronate. Gels were prepared by diffusion of calcium into alginate-hyaluronate mixtures, with an alginate content of 20 mg/mL. The hyaluronate source was shown to have significant effect on the aspect and the properties of the gels. The gels have viscoelastic behaviour and the transient measurements carried out in creep mode could be interpreted through a Kelvin-Voigt generalised model: experimental data led to the steady state hardness and a characteristic viscosity of the gel. Gels prepared from Na rooster comb hyaluronate with weight ratio up to 0.50 have satisfactory mechanical properties, and fully stable gels are obtained after a few days; on the contrary, use of lower molecular weight hyaluronate led to loose gels for hyaluronate contents over 0.25. Gel formation was investigated by measurements of the exchange fluxes between the calcium chloride solution and the forming gel, which allowed thorough investigations of the occuring diffusion phenomena of water, calcium ion and hyaluronate. Strong interactions of water with hyaluronate reduce significantly the rate of weight loss from the gel beads and allows higher water content in steady-state gels. Calcium content in the gel samples could be correlated to the actual alginate concentration, whatever the nature and the weight ratio of hyaluronate.
Release of macromolecular drug from calcium-alginate gel beads was investigated. Fluorescein isothiocyanate-labeled dextrans with molecular weight ranging from 9400 to 145000 were used as a model macromolecular drug. Dextran release was observed to be molecular weight-dependent, with the release pattern changing from pseudo first-order for dextran with 9400 molecular weight to sigmoidal for dextran with molecular weight of 145000. Release of a lower molecular weight dextran is mainly governed by the drug diffusion through the calcium-alginate gel matrix. With increasing dextran molecular weights, dextran release was strongly influenced by the dissolution of alginate matrix through the exchange of Ca2+ ions which act as a cross-linker. Rapid and complete release was achieved for dextran with 145000 molecular weight in a "burst" fashion showing a initial lag time. Minimal dextran release was observed in pseudo-gastric fluid at pH 1.2, while rapid dextran release within a narrow time range was achieved in simulated intestinal fluid at pH 6. 8. These results strongly suggest that calcium-alginate gel is a useful vehicle for pulsatile release of macromolecular drugs in oral drug delivery.