Search PubMed⌕ Search

PubMed · 8269537

[Liquid ventilation--1].

Abstract

The authors investigated in detail the sorption and desorption of oxygen and carbon dioxide in a solution of perfluorocarbons (solution RM 101, Miteni, Italy). From the results of the investigation ensues that maximal oxygen saturation of 77.3 vol.% can be achieved at 8 degrees C. With rising temperature the oxygen concentration in the solution declines (67.6 vol.% at 37 degrees). The saturation of the RM 101 solution corresponds to a linear equation of seventh order (fig. 2). Desorption of the RM 101 solution fully saturated with carbon dioxide, is on the other hand, most rapid at 37 degrees C (after the 13th minute the RM 101 solution contains less than 2% carbon dioxide as compared with 25 vol.% at 8 degrees C during the same period. In general the kinetics of desorption of carbon dioxide in solution correspond to a linear equation of fifth order (fig. 4). From the practical aspect it is not expedient to saturate the RM 101 solution with oxygen longer than 15-20 minutes. The mentioned kinetic parameters are important for the construction of a special liquid membrane or bubble oxygenator. In particular the latter is useful as with its use the authors achieved a 1.9 x higher oxygen concentration in the RM 101 solution than declared by the manufacturer.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

R Nekvasil, M Dressler, Z Vecera, Z Penková. 1993. [Liquid ventilation--1].. https://pubmed.ncbi.nlm.nih.gov/8269537/

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

Immobilization of D-ribulose-1,5-bisphosphate carboxylase/oxygenase: a step toward carbon dioxide fixation bioprocess.

Immobilization of D-ribulose-1,5-bisphosphate carboxylase/oxygenase (Rubisco) from spinach leaves is described. This enzyme enables the fixation of carbon dioxide on a five-carbon sugar D-ribulose-1,5-bisphosphate (RuBP). Two different immobilization methods were employed: dicyclohexylcarbodiimide coupling on nylon membrane matrix and dimethylpimelimidate immobilization on protein A agarose. The reusability of immobilized enzymes, coupling efficiency, and temperature-activity relationship of soluble and immobilized Rubisco are presented. The immobilization imparted greater thermal and storage stability. The thermal deactivation rates of the immobilized enzymes were considerably lower than those of the soluble enzyme.

Carbon Dioxide↗

Supercritical extraction of essential oil from aniseed (Pimpinella anisum L) using CO2: solubility, kinetics, and composition data.

Supercritical fluid extraction (SFE) from aniseed using carbon dioxide was performed at 30 degrees C and pressures of 80-180 bar. The chemical composition of the SFE extract was determined by GC-MS; the quantitative analysis was done by GC-FID and TLC. The total amount of extractable substances or global yield (mass of extract/mass of feed) for the SFE process varied from 3.13 to 10.67% (mass). The solubilities of the anise essential oil in CO(2) were 0.0110, 0.0277, 0.0143, and 0.0182 kg of solute/kg of CO(2) at 80, 100, 140, and 180 bar, respectively. The major compounds identified and quantified in the extracts were anethole ( approximately 90%), gamma-himachalene (2-4%), p-anisaldehyde (<1%), methylchavicol (0.9-1.5%), cis-pseudoisoeugenyl 2-methylbutyrate ( approximately 3%), and trans-pseudoisoeugenyl 2-methylbutyrate ( approximately 1.3%). The Sovová model described quite well the experimental overall extraction curves.

Carbon Dioxide↗

Reaction of (mu-oxo)diiron(III) core with CO2 in N-methylimidazole: formation of mono(mu-carboxylato)(mu-oxo)diiron(III) complexes with N-methylimidazole as ligands.

Several iron(III) complexes with N-methylimidazole (N-MeIm) as the ligand have been synthesized by using N-MeIm as the solvent. Under anaerobic conditions, [Fe(N-MeIm)(6)](ClO(4))(3) (1) reacts with stoichiometric amounts of water in N-MeIm to afford the (mu-oxo)diiron(III) complex, [Fe(2)(mu-O)(N-MeIm)(10)](ClO(4))(4) (3). Exposure of a solution of 3 in N-MeIm to stoichiometric and excess CO(2) gives rise to the (mu-oxo)(mu-carboxylato)diiron(III) species [Fe(2)(mu-O)(mu-HCO(2))(N-MeIm)(8)](ClO(4))(3) (4) and the methyl carbonate complex [Fe(2)(mu-O)(mu-CH(3)OCO(2))(N-MeIm)(8)](ClO(4))(3) (5), respectively. Formation of the formato-bridged complex 4 upon fixation of CO(2) by 3 in N-MeIm is unprecedentated. Methyl transfer from N-MeIm to a bicarbonato-bridged (mu-oxo)diiron(III) intermediate appears to give rise to 5. Complex 3 is a good starting material for the synthesis of (mu-oxo)mono(mu-carboxylato)diiron(III) species [Fe(2)(mu-O)(mu-RCO(2))(N-MeIm)(8)](ClO(4))(3) (where R = H (4), CH(3) (6), or C(6)H(5) (7)); addition of the respective carboxylate ligand in stoichiometric amount to a solution of 3 in N-MeIm affords these complexes in high yields. Attempts to add a third bridge to complexes 4, 6, and 7 to form the (mu-oxo)bis(mu-carboxylato)diiron(III) species result in the isolation of the previously known triiron(III) mu-eta(3)-oxo clusters [[Fe(mu-RCO(2))(2)(N-MeIm)](3)O](ClO(4)) (8). The structures of 3, 4, 6, and 7 allow one, for the first time, to inspect the various features of the [Fe(2)(mu-O)(mu-RCO(2))](3+) moiety with no strain from the ligand framework.

Carbon Dioxide↗