Search PubMed⌕ Search

PubMed · 3333137

Monopolar surfaces.

Abstract

Following the development of a methodology for determining the apolar components as well as the electron donor and the electron acceptor parameters of the surface tension of polar surfaces, surfaces of a number of quite common materials were found to manifest virtually only electron donor properties and no, or hardly, any electron acceptor properties. Such materials may be called monopolar; they can strongly interact with bipolar materials (e.g., with polar liquids such as water); but one single polar parameter of a monopolar material cannot contribute to its energy of cohesion. Monopolar materials manifesting only electron acceptor properties also may exist, but they do not appear to occur in as great an abundance. Among the electron donor monopolar materials are: polymethylmethacrylate, polyvinylalcohol, polyethyleneglycol, proteins, many polysaccharides, phospholipids, nonionic surfactants, cellulose esters, etc. Strongly monopolar materials of the same sign repel each other when immersed or dissolved in water or other polar liquids. The interfacial tension between strongly monopolar surfaces and water has a negative value. This leads to a tendency for water to penetrate between facing surfaces of a monopolar substance and hence, to repulsion between the molecules or particles of such a monopolar material, when immersed in water, and thus to pronounced solubility or dispersibility. Monopolar repulsion energies can far outweigh Lifshitz-van der Waals attractions as well as electrostatic and "steric" repulsions. In aqueous systems the commonly observed stabilization effects, which usually are ascribed to "steric" stabilization, may in many instances be attributed to monopolar repulsion between nonionic stabilizing molecules. The repulsion between monopolar molecules of the same sign can also lead to phase separation in aqueous solutions (or suspensions), where not only two, but multiple phases are possible. Negative interfacial tensions between monopolar surfactants and the brine phase can be the driving force for the formation of microemulsions; such negative interfacial tensions ultimately decay and stabilize at a value very close to zero. Strongly monopolar macromolecules or particles surrounded by oriented water molecules of hydration can still repel each other, albeit to an attenuated degree. This repulsion was earlier perceived as caused by "hydration pressure". A few of the relevant colloid and surface phenomena are reviewed and re-examined in the light of the influence of surface monopolarity on these phenomena.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

C J van Oss, M K Chaudhury, R J Good. 1987. Monopolar surfaces.. https://doi.org/10.1016/0001-8686(87)80008-8

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

Preliminary 3-D site-scale studies of radioactive colloid transport in the unsaturated zone at Yucca Mountain, Nevada.

The U.S. Department of Energy (DOE) is actively investigating the technical feasibility of permanent disposal of high-level nuclear waste in a repository to be situated in the unsaturated zone (UZ) at Yucca Mountain (YM), Nevada. In this study we investigate, by means of numerical simulation, the transport of radioactive colloids under ambient conditions from the potential repository horizon to the water table. The site hydrology and the effects of the spatial distribution of hydraulic and transport properties in the Yucca Mountain subsurface are considered. The study of migration and retardation of colloids accounts for the complex processes in the unsaturated zone of Yucca Mountain, and includes advection, diffusion, hydrodynamic dispersion, kinetic colloid filtration, colloid straining, and radioactive decay. The results of the study indicate that the most important factors affecting colloid transport are the subsurface geology and site hydrology, i.e., the presence of faults (they dominate and control transport), fractures (the main migration pathways), and the relative distribution of zeolitic and vitric tuffs. The transport of colloids is strongly influenced by their size (as it affects diffusion into the matrix, straining at hydrogeologic unit interfaces, and transport velocity) and by the parameters of the kinetic-filtration model used for the simulations. Arrival times at the water table decrease with an increasing colloid size because of smaller diffusion, increased straining, and higher transport velocities. The importance of diffusion as a retardation mechanism increases with a decreasing colloid size, but appears to be minimal in large colloids.

Colloids↗

Stretching and collapse of neutral polymer layers under association with ionic surfactants.

We provide experimental evidence for stretching and collapse of neutral polymer layers, already adsorbed at an oil-in-water interface, due to its interaction with surfactants. Upon stretching, the first interaction length (2L(0)) follows a power law dependence on surfactant concentration ( proportional, variant C(x)(s), where x approximately 0.5 for cationic surfactants) and collapses in the presence of salt, as a relatively weak power law (C(-y)(s), where y=0.17), in good agreement with brush length decay for polyelectrolyte brushes.

Colloids↗

Characterization of Gorleben groundwater colloids by atomic force microscopy.

Groundwater colloids from the Gorleben site (Lower Saxony, Germany) are characterized in the presence of Eu(III) by tapping-mode atomic force microscopy (AFM) with phase contrast imaging. Using a liquid cell the method allows investigations of samples being in contact with aqueous solution. This ensures that complex structures are kept in their native hydrated state. Different types of colloids and aggregates are found by AFM, e.g., spherical particles, fibrous structures, and structures which appear to be hollow. A partial coating of the edges of clay particles with humic colloids can be assumed from phase contrast images. Therefore, aquatic colloids and their aggregates found in Gorleben groundwater can be characterized as a complex mixture of components, which may influence the migration of groundwater contaminants in different processes.

Colloids↗