Search PubMed⌕ Search
Home/Archive/PubMed

PubMed · 3225832

Technical note: a mains drop-out simulator.

H M Norwood
View original source ↗Export metadata ↓

Abstract

During an investigation into mains-borne and radiated interference in the Ultrasound Department of St James's University Hospital, the need arose to determine the susceptibility of some equipment to the mains supply failing for very brief periods. This is known as 'drop-out'. A circuit was built that can drop out the mains supply to a piece of equipment for up to 15 consecutive half-cycles at a selectable repetition rate between approximately 0.4/s to 6.5/s. Circuit design was simplified by using a solid state relay (SSR), which turns on and off only at the zero crossing points in the mains supply waveform.

Explore related subjects

Electric ConductivityElectronics, MedicalEquipment DesignEquipment FailureMaterials TestingUltrasonicsJournal Article

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

H M Norwood. Technical note: a mains drop-out simulator.. https://doi.org/10.3109/03091908809012412

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

PubMed1998

Electrorotation of isolated generative and vegetative cells, and of intact pollen grains of Lilium longiflorum.

The dielectric structure of mature pollen of the angiosperm Lilium longiflorum was studied by means of single-cell electrorotation. The use of a microstructured four-electrode chamber allowed the measurements to be performed over a wide range of medium conductivity from 3 to 500 mS m-1. The rotation spectra of hydrated pollen grains exhibited at least three well-resolved peaks in the kHz-MHz frequency range, which obviously arise due to the multilayered structure of pollen grains. The three-shell model can explain the complex rotational behavior of pollen grains in terms of conductivities, permittivities and thicknesses of the following compartments: the exine and intine of the pollen grain wall as well as the membrane and cytoplasm of the vegetative cell. However, the number of unknown parameters (more than 8) was too large to allow unambiguous values to be assigned to any of them. Therefore, to facilitate the evaluation of the pollen grain parameters, additional rotational measurements were made on isolated vegetative and generative cells. The rotation spectra of these cells could be fitted very accurately on the basis of the single-shell model by assuming a dispersion of the cytoplasm. The data on the membrane and cytoplasmic properties of isolated vegetative cells were then used for modeling the rotation spectra of pollen grains. This greatly facilitated the fitting of the theoretical model to the experimental data and allowed the dielectric properties of the major structural units to be determined. The dielectric characterization of pollen is of enormous interest for plant biotechnology, where pollen and isolated germ cells are successfully used for production of transgenic crop and drug plants of economic importance by means of electromanipulation techniques.

Electric Conductivity↗
PubMed1997

Electrorotation of liposomes: verification of dielectric multi-shell model for cells.

The reliability of multi-shell dielectric models, used to describe the ac electrokinetic behaviour of cells, has been tested by performing electrorotation and dielectrophoretic measurements on unilamellar, oligolamellar, and multilamellar liposomes of diameters ranging from 5 to 24 microm. Fluorescence microscopy, flow cytometry and electron spin resonance were used to characterise the morphology and membranes of the liposomes. The dielectric properties of the various types of liposomes, based on appropriate dielectric shell models, were then analysed using a general purpose, recursive, algorithm. Through simulations, the confidence levels that can be assigned to parameters derived through application of simple shell models are estimated. From this, we confirm that electrorotation data enable accurate determinations to be made of the dielectric properties of the outermost membrane of liposomes, and provide good indications of the level of complexity of the shells and internal compartments. We also demonstrate that, used with sufficient additional information, such as that provided by dielectrophoresis, electrorotation data yields unique solutions for the dielectric parameters of liposome-like particles.

Electric Conductivity↗
PubMed1997

Capillary electrochromatography: theories on electroosmotic flow in porous media.

In view of the present interest in capillary electrochromatography (CEC), theories dealing with electroosmotic flow (EOF) in porous media are reviewed with particular regard to the use of packed capillaries in CEC. Two of the models found in the pertinent literature are applicable to CEC and give simple analytical solutions. The first of the two models is based on von Smoluchowski's work as adapted and extended by Overbeek. It deals with EOF through packed capillaries under conditions of low electric field strength where the EOF varies linearly with the field strength because there is no polarization of the double layer. Overbeek's model originally developed for porous media of infinite dimensions was modified in an attempt to account for the wall effect that assumes importance in the packed capillary columns used in CEC. The second model proposed by Dukhin and his coworkers predicts EOF of at least an order of magnitude higher than that expected by classical theories. This "electroosmosis of the second kind" is believed to occur in columns packed with conductive particles like ion exchangers at high electric field strengths when the double layer is polarized and the EOF becomes a non-linear function of the applied voltage. Conditions necessary for electroosmosis of the the second kind are likely to arise upon the further development of CEC when further enhancement of the speed of analysis is brought about at electric field strength higher than that employed at present.

Electric Conductivity↗