Gas transfer from air diffusers.

Erica L Schierholz; John S Gulliver; Steven C Wilhelms; Heather E Henneman

doi:10.1016/j.watres.2005.12.033

Home/Archive/PubMed

PubMed · 16490229

Gas transfer from air diffusers.

Erica L Schierholz·John S Gulliver·Steven C Wilhelms·Heather E Henneman

View original source ↗Export metadata ↓

Abstract

The bubble and surface volumetric mass transfer coefficients for oxygen, k(L)a(b) and k(L)a(s), are separately determined for 179 aeration tests, with diffuser depths ranging from 2.25 to 32 m, using the DeMoyer et al. 12003. Impact of bubble and free surface oxygen transfer on diffused aeration systems. Water Res 37, 1890-1904] mass transfer model. Two empirical characterization equations are developed for k(L)a(b) and k(L)a(s), correlating the coefficients to air flow, Qa, diffuser depth, hd, cross-sectional area, Acs, and volume, V. The characterization equations indicate that the bubble transfer coefficient, k(L)a(b), increases with increasing gas flow rate and depth, and decreases with increasing water volume. For fine bubble diffusers, k(L)a(b) is approximately six times greater than k(L)a(b) for coarse bubble diffusers. The surface transfer coefficient, k(L)A(s), increases with increasing gas flow rate and diffuser depth. The characterization equations make it possible to predict the gas transfer that will occur across bubble interfaces and across the free surface with a bubble plume at depths up to 32 m and with variable air discharge in deep tanks and reservoirs.

Explore related subjects

Bioreactors Diffusion Gases Models, Theoretical Oxygen Waste Disposal, Fluid Journal Article Research Support, U.S. Gov't, Non-P.H.S.

Keep this discovery

Explore connections, maps & timelines

BibTeX RIS

Erica L Schierholz, John S Gulliver, Steven C Wilhelms, Heather E Henneman. 2006. Gas transfer from air diffusers.. https://doi.org/10.1016/j.watres.2005.12.033

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

PubMed2025

Unraveling the ecological success of Iodidimonas in a bioreactor treating oil and gas produced water.

UNLABELLED: Iodidimonas sp., a bacterium found in bioreactors treating oil and gas produced water as well as iodide-rich brines, has garnered attention for its unique ability to oxidize iodine. However, little is known about the metabolic capabilities that enable Iodidimonas sp. to thrive in certain unique ecological niches. In this study, we isolated, characterized, and sequenced three strains belonging to the Iodidimonas genus from the sludge of a membrane bioreactor used for produced water treatment. We investigated the genomic features of these isolates and compared them with the four publicly available isolate genomes from this genus, as well as a metagenome-assembled genome from the source bioreactor. Our Iodidimonas isolates had several genes associated with mitigating salinity, heavy metal, and organic compound stress, which likely help these bacteria to survive in produced water. Phenotyping tests revealed that while the isolates could utilize a wide variety of simple carbon substrates, they failed to degrade aliphatic or aromatic hydrocarbons, consistent with the lack of genes associated with common hydrocarbon degradation pathways in their genomes. We hypothesize that these microbes may lead a scavenging lifestyle in the bioreactor and similar iodide-rich brines. IMPORTANCE: Occupying a niche habitat and having few representative isolates, the genus Iodidimonas is a relatively understudied alphaproteobacterial group. Its ability to corrode pipes in iodine production facilities has economic implications, and its ability to generate potentially carcinogenic iodinated organic compounds during treatment of oil and gas produced water may cause environmental and health concerns with the recycling of treated water. Therefore, detailed characterization of the metabolic potential of the Iodidimonas isolates in this study both sheds light on their adaptation to the environmental conditions they inhabit and has environmental and economic significance.

Bioreactors↗

PubMed2006

Numerical simulation of a fully baffled biological reactor: the differential circumferential averaging mixing plane approach.

A modified mixing plane approach for steady state simulation of flow field in fully baffled biological reactor is presented and discussed. Without requiring any experimental input, this approach of dividing the vessel into suitable number of connected and disconnected zones; solving steady state equation separately in each zone and then transferring information between them, provides a computationally less intensive alternative for simulating the flow in the whole vessel. Impeller used is the standard Rushton Turbine positioned at mid-height of the reactor and simulations are carried out using standard k-epsilon turbulence model implemented in CFD code FLUENT. Meshing is done using tetrahedral elements such that mesh size gradually increases from the center to the periphery. Most of the previous simulation works present only a few aspects of the flow field with scant importance to the energy balance in the tank and near tip turbulence. In this work, complete model prediction for velocity field and turbulence parameters (near tip and in the bulk region) are validated by comparison with experimental data. As compared to previous simulation works, the results predicted by this "Differential circumferential averaging mixing plane approach" show a better qualitative and quantitative agreement with the published experimental data. A distribution of energy dissipation in various zones of vessel is presented. Also a qualitative picture of flow field and stagnant zones inside the reactor is presented and discussed. Comparison of flow characteristics for different number of baffles shows that for the present dimension of the vessel, five baffles gives maximum enhanced mixing.

Bioreactors↗

PubMed2006

Ultra scale-down studies of the effect of flow and impact conditions during E. coli cell processing.

The ability to recover cells from a fermentation broth in an intact form can be an important criterion for determining the overall performance of a recovery and purification sequence. Disruption of the cells can lead to undesired contamination of an extracellular product with intracellular components and vice versa loss of intracellular products may occur. In particular, the value of directed location of a product in the periplasmic space of say Escherichia coli (E. coli) would be diminished by such premature non-selective cell disruption. Several options exist for cell recovery/removal; namely centrifugation, in batch or continuous configuration, filtration or membrane operations, and in selected cases expanded beds. The choice of operation is dependant on many variables including the impact on the overall process sequence. In all cases, the cells are exposed to shear stresses of varying levels and times and additionally such environments exist in ancillary operations such as pumping, pipe flow, and control valves. In this study, a small-scale device has been designed to expose cells to controlled levels of shear, time and impact in a way that seeks to mimic those effects that may occur during full-scale processes. The extent of cell breakage was found to be proportional to shear stress. An additional level of breakage occurred due to the jet impacting on the collecting surface. Here it was possible to correlate the additional breakage with the impact velocity, which is a function of the distance that the jet travels before meeting the collection surface and the initial jet velocity.

Bioreactors↗