Search PubMed⌕ Search

PubMed · 15464809

Aggregate restructuring by polymer solvency effects.

Abstract

This study investigates the aggregation in cyclohexane of silica particles initially stabilized by grafted polystyrene and destabilized by temperature reduction. It complements an earlier study by Zhu and Napper (P.W. Zhu, D.H. Napper, Phys. Rev. E 50 (1994) 1360) in which the aggregation of polystyrene latex particles with tethered poly(N-isopropyl acrylamide) (PNIPAM) in water was investigated. Their dynamic light scattering results showed that both the rate of aggregation and the aggregate fractal dimension increased with a sufficient decrease in the PNIPAM adlayer solvency, achieved by means of either salt (NaNO3) addition or temperature rise. This result stands in contrast to those obtained when an electrostatically stabilized colloid is destabilized, i.e., that the more rapidly aggregates are formed, the lower the resulting fractal dimension. The authors explained their results in terms of the effects of both salt effects and increased temperature on the extent of the hydrophobic interactions between the adlayer-covered surfaces in the water. The present study examines a sterically-stabilized colloid in a nonaqueous solvent, where neither salt effects nor hydrophobic effects play a role. Temperature is decreased to bring the system from better-than-theta-conditions to worse-than-theta-conditions. Power-law aggregation kinetics are observed at 15.7 degrees C by dynamic light scattering. The particles first undergo reduced rate aggregation, producing low-fractal-dimension aggregates, which after some time, restructure into more compact aged clusters. The fractal dimension of these aged clusters increases with increasing initial aggregation rate, consistent with results seen by Zhu and Napper, but without the presence of hydrophobic effects. The ability of the polymer-grafted particles to rearrange suggests aggregation into a secondary minimum, with the ability to slide over one another to achieve a more energetically favorable, denser configuration. The reversible nature of the aggregation is verified by additional experiments gradually bringing the system from worse-than-theta-conditions back to better-than-theta-conditions, with an attendant decrease in aggregate fractal dimension, and ultimately full redispersion.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Alvin Y Huang, John C Berg. 2004-11-15. Aggregate restructuring by polymer solvency effects.. https://doi.org/10.1016/j.jcis.2004.06.088

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

Diastereoselective reactions at enantiomerically pure, sterically congested cyclohexanes as an entry to wailupemycins A and B: total synthesis of (+)-wailupemycin B.

Wailupemycin A (1) and B (2) are polyketide natural products with a highly substituted cyclohexanone core. Three different routes for the syntheses of these compounds were pursued, which commenced from either (R)-(-)-carvone (ent-5) or (S)-(+)-carvone (5). In the first approach it was attempted to construct the skeleton of wailupemycin A from triol 19 (nine steps from ent-5; 19 % yield) by a sequence of diastereoselective epoxidation, nucleophilic ring opening at C-13 and carbonyl addition at C-5. The synthetic plan failed at the stage of the carbonyl addition to aldehyde 27, which had been obtained in seven steps (18 % yield) from triol 19. The second route included an epoxide ring opening at C-13 and a carbonyl addition at C-7 as key steps. It could have led to either wailupemycin A or B depending on the diastereoselectivity of the addition step. Starting from allylic alcohol 30 (six steps from ent-5; 59 % yield) the cyclohexanone 28 was obtained in five steps (54 % yield). Unfortunately, the carbonyl addition failed also in this instance. In the eventually successful third attempt the skeleton of wailupemycin B was built from cyclohexanone 43 (eight steps from 5; 53 % yield) by highly diastereoselective carbonyl addition reactions at C-7 and C-12. The phenyl group at C-14 was introduced at a late stage of the synthetic sequence. Careful protecting group manipulation finally allowed for the total synthesis of (+)-wailupemycin B. The absolute and relative configuration of the natural product was unambiguously confirmed. The total yield of wailupemycin B amounted to 6 % over 23 steps starting from (S)-(+)-carvone (5).

Cyclohexanes↗

Allene oxide cyclase is essential for theobroxide-induced jasmonic acid biosynthesis in Pharbitis nil.

Theobroxide, a natural product, strongly stimulates the biosynthesis of jasmonic acid (JA) in Pharbitis nil. In this study, we investigated the accumulation of protein by the immunoblot analysis of lipoxygenase (LOX), allene oxide synthase (AOS), and allene oxide cyclase (AOC), key enzymes in JA biosynthesis, and how the endogenous levels of JA in P. nil are affected by theobroxide. The effect of JA on the accumulations of these proteins was monitored simultaneously. The results show that theobroxide treatment led to a high level accumulation of JA, which is due to high accumulations of LOX, AOS, and AOC proteins induced by theobroxide treatment both under short day (SD) and long day (LD) conditions. However, under SD conditions AOS and AOC proteins are not enhanced by JA treatment. Kinetic analysis of protein levels shows that a biphasic activation of AOC protein by theobroxide is displayed and the first activation of AOC protein together with elevated JA levels is observed within 30min after treatment. Meanwhile, AOS and LOX proteins are activated by theobroxide later than AOC protein, suggesting that AOC plays an essential role in the initial JA formation induced by theobroxide. Since theobroxide-increased JA levels also show a biphasic manner similar to AOC activation and AOS, LOX proteins are activated later than AOC, and thus we propose a positive JA feedback regulation. Interestingly, AOS protein, which is also the enzyme for the biosynthesis of 9,10-ketol-octadecadienoic acid (KODA, a flowering inducing factor), accumulates markedly due to the simultaneous involvement of theobroxide and SD conditions, suggesting that AOS probably plays a role in flower bud formation in P. nil.

Cyclohexanes↗

A luminescence sensor of inositol 1,4,5-triphosphate and its model compound by ruthenium-templated assembly of a bis(Zn2+-cyclen) complex having a 2,2'-bipyridyl linker (cyclen = 1,4,7,10-tetraazacyclododecane).

A new supramolecular complex (Ru(Zn2L4)3) was designed and synthesized as a luminescence sensor for inositol 1,4,5-triphosphate (IP3), which is one of the important second messengers in intracellular signal transduction, and its achiral model compound, cis,cis-1,3,5-cyclohexanetriol triphosphate (CTP3), by a ruthenium(II)-templated assembly of three molecules of a bis(Zn2+-cyclen) complex having a 2,2-bipyridyl linker (Zn2L4). Single-crystal X-ray diffraction analysis of a racemic mixture of Ru(Zn2L4)3 showed that three of the six Zn2+-cyclen units are orientated to face the opposite side of the molecule with three apical ligands (Zn2+-bound HO-) of each of the three Zn2+ located on the same face. 1H NMR and UV titrations of Ru(Zn2L4)3 with CTP3 indicated that Ru(Zn2L4)3 forms a 1:2 complex with CTP3, (Ru(Zn2L4)3)-((CTP3)6-)2, in aqueous solution at neutral pH. In the absence of guest molecules, Ru(Zn2L4)3 (10 microM) has an emission maximum at 610 nm at pH 7.4 (10 mM HEPES with I = 0.1 (NaNO3)) and 25 degrees C (excitation at 300 nm). An addition of 2 equiv of CTP3 induced a 4.2-fold enhancement in the emission of Ru(Zn2L4)3 at 584 nm. In this article, we describe that Ru(Zn2L4)3 is the first chemical sensor that directly responds to CTP3 and IP3 and discriminates these triphosphates from monophosphates and diphosphates. The photodecomposition of Ru(Zn2L4)3, which is inhibited upon complexation with CTP3, and the stereoselective complexation of chiral IP3 by Ru(Zn2L4)3 are also described.

Cyclohexanes↗