Search PubMed⌕ Search

PubMed · 15274569

Evidence for gravity's influence on molecules at a solid-solution interface.

Abstract

Yoshimoto et al. [Anal. Chem. 2002, 74, 4306-4309] reported that a quartz crystal microbalance or QCM changed its response to sucrose solutions according to its angle of immersion. The effect was tentatively attributed to gravity-caused stress on the viscous interface between the oscillator and the bulk solution. The present work reports results from QCM experiments carried out so that any effect of gravity on the interfacial region would be magnified. This permitted use of a lower-frequency, less-sensitive QCM. Molecules of DNA were tethered to a functionalized QCM surface and then extended in steps, via sandwich hybridization, to produce DNA of uniform and known length. This feature allowed both the effect of QCM immersion angle and the relationship between frequency and molecular length to be investigated simultaneously. Comparison of acoustic wave damping at 0 degrees and 180 degrees immersion angles offers compelling evidence that the interfacial region expands when the active face of the QCM is down and contracts when it is up. This is apparently a consequence of the interfacial region being more dense than the bulk solution. The results are consistent with (a) slow gravity-driven movement of molecules away from a down-facing QCM, (b) rapid hybridization-driven movement away from an up-facing QCM, and (c) a QCM frequency response that decreases according to a simple exponential function of the tethered molecules' radius of gyration.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Newton C Fawcett, Richard D Craven, Ping Zhang, Jeffrey A Evans. 2004-08-03. Evidence for gravity's influence on molecules at a solid-solution interface.. https://doi.org/10.1021/la030390d

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

The singing power ratio as an objective measure of singing voice quality in untrained talented and nontalented singers.

A growing body of contemporary research has investigated differences between trained and untrained singing voices. However, few studies have separated untrained singers into those who do and do not express abilities related to singing talent, including accurate pitch control and production of a pleasant timbre (voice quality). This investigation studied measures of the singing power ratio (SPR), which is a quantitative measure of the resonant quality of the singing voice. SPR reflects the amplification or suppression in the vocal tract of the harmonics produced by the sound source. This measure was acquired from the voices of untrained talented and nontalented singers as a means to objectively investigate voice quality differences. Measures of SPR were acquired from vocal samples with fast Fourier transform (FFT) power spectra to analyze the amplitude level of the partials in the acoustic spectrum. Long-term average spectra (LTAS) were also analyzed. Results indicated significant differences in SPR between groups, which suggest that vocal tract resonance, and its effect on perceived vocal timbre or quality, may be an important variable related to the perception of singing talent. LTAS confirmed group differences in the tuning of vocal tract harmonics.

Acoustics↗

Acoustic characteristics of air puff-induced 22-kHz alarm calls in direct recordings.

Alarm calls were induced in adult Wistar rats by an air puff. Emitted calls were digitized and directly recorded on a computer hard drive. The long-duration 22-kHz calls were emitted almost exclusively in series. Initial calls in the series tended to have the longest durations, higher frequency range, and the highest degree of frequency modulation, as compared to other calls. The frequency modulation always appeared as a downward sweep and seemed to represent a tuning of individual calls to a 3 kHz communicatory band. Regardless of the maximum frequency, rats always reached approximately the same minimum frequency, common to all calls. Thus, the broader was the frequency range of a given call, the longer the call duration. It is postulated, therefore, that rats emit 22-kHz calls at the minimum possible ultrasonic frequency they are able to produce, which is synonymous with peak frequency. It is further postulated that production of alarm calls in series, with long call duration and the invariably low ultrasonic frequency, maximizes successful communication in dangerous situations. Exceptions to this rule were observed immediately following air puffs, suggesting that acoustic parameters of the initial calls may differ from the alarming properties of the remaining 22-kHz calls.

Acoustics↗

Direct quantification of analyte concentration by resonant acoustic profiling.

BACKGROUND: Acoustic sensors that exploit resonating quartz crystals directly detect the binding of an analyte to a receptor. Applications include detection of bacteria, viruses, and oligonucleotides and measurement of myoglobin, interleukin 1beta (IL-1beta), and enzyme cofactors. METHODS: Resonant Acoustic Profiling was combined with a microfluidic lateral flow device incorporating an internal reference control, stable linker chemistry, and immobilized receptors on a disposable sensor "chip". Analyte concentrations were determined by analyzing the rate of binding of the analyte to an appropriate receptor. RESULTS: The specificity and affinity of antibody-antigen and enzyme-cofactor interactions were determined without labeling of the receptor or the analyte. We measured protein concentrations (recombinant human IL-1beta and recombinant human myoglobin) and quantified binding of cofactors (NADP+ and NAD+) to the enzyme glucose dehydrogenase. Lower limits of detection were approximately 1 nmol/L (17 ng/mL) for both IL-1beta and human myoglobin. The equilibrium binding constant for NADP+ binding to glucose dehydrogenase was 2.8 mmol/L. CONCLUSIONS: Resonant Acoustic Profiling detects analytes in a relatively simple receptor-binding assay in <10 min. Potential applications include real-time immunoassays and biomarker detection. Combination of this technology platform with existing technologies for concentration and presentation of analytes may lead to simple, label-free, high-sensitivity methodologies for reagent and assay validation in clinical chemistry and, ultimately, for real-time in vitro diagnostics.

Acoustics↗