PubMed · 15022497
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
Rory A Cooper, Rosemarie Cooper, Mark Schmeler, Michael L Boninger. 2004. Push for power.. https://pubmed.ncbi.nlm.nih.gov/15022497/
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
The extraction and insertion of lithium in LiFePO4 has been investigated in practical Li-ion intercalation electrodes for Li-ion batteries using Fe K-edge X-ray absorption spectroscopy (XAS). A versatile electrochemical in situ reaction cell was utilized, specifically designed for long-term X-ray experiments on battery electrodes during the lithium-extraction/insertion process in electrode materials for Li-ion batteries. The electrode contained about 7.7 mg of LiFePO4 on a 20 microm-thick Al foil. In order to determine the charge compensation mechanism and structural perturbations occurring in the system during cycling, in situ X-ray absorption fine-structure spectroscopy (XAFS) measurements were conducted on the cell at a moderate rate using typical Li-ion battery operating voltages (3.0-4.1 V versus Li/Li+). XAS studies of the LiFePO4 electrode measured at the initial state (LiFePO4) showed iron to be in the Fe(II) state corresponding to the initial state (0.0 mAh) of the battery, whereas in the delithiated state (FePO4) iron was found to be in the Fe(III) state corresponding to the final charged state (3 mAh) of the battery. The X-ray absorption near-edge structure (XANES) region of the XAS spectra revealed a high-spin configuration for the two states [Fe(II), d6 and Fe(III), d5]. The XAFS data analysis confirmed that the olivine structure of the LiFePO4 and FePO4 is retained by the electrodes, which is in agreement with the X-ray diffraction observations on these compounds. The XAFS data that were collected continuously during cycling revealed details about the response of the cathode to Li insertion and extraction. These measurements on the LiFePO4 cathode show that the material retains good structural short-range order leading to superior cycling.
We have fabricated a low-cost disposable polymerase chain reaction thermal chamber that uses buoyancy forces to move the sample solution between the different temperatures necessary for amplification. Three-dimensional, unsteady finite element modeling and a simpler 1-D steady-state model are used together with digital particle image velocimetry data to characterize the flow within the device. Biological samples have been amplified using this novel thermal chamber. Time for amplification is less than 30 min. More importantly, an analysis of the energy consumption shows significant improvements over current technology.
The design, construction and operation of a simple, inexpensive and compact high voltage power supply (HVPS) for use in conjunction with a simple cross capillary electrophoresis microchip is presented. The microchip HVPS utilizes a single high voltage power supply (15 kV), a voltage-divider network, to give the voltages necessary to operate a gated injection valve, and two high voltage relays for switching between the open and closed gate sequences of the injection. In order to accommodate the application of different simple cross microchip dimensions, a set of equations for defining the resistor network and ensuring proper gate performance are presented.