Search PubMed⌕ Search

PubMed · 13950658

Temperature and lambda phage reproduction.

Abstract

Groman, Neal B. (University of Washington, Seattle) and Grace Suzuki. Temperature and lambda phage reproduction. J. Bacteriol. 84:431-437. 1962.-The effect of temperature on lambda phage production in Escherichia coli K-12 was studied, and a temperature-phage yield relationship established. Phage yield declines slowly below optimal temperature and rapidly above the optimum. An extensive comparison of phage reproduction at 37 and 44 C was made when it was observed that at 44 C phage yield was reduced to 2 to 5% that at 37 C in the absence of any significant effect on bacterial growth. The reduced yield is manifest rather uniformly in every infected cell, and the reduction is due primarily to a speed-up of the lytic process. Temperature shift-up and shift-down experiments established that the temperature-affected step or process is initiated about 25 min after adsorption. This is close to the time the first intracellular phage appears. The data indicate that heat inactivation, lysogenization or major blocks in adsorption, penetration, replication, and maturation make minor contributions, if any, to the depression of the yield. Phenotypic adaptation of phage and host to the production of a greater yield at 44 C was not observed. There was no correlation observed between the enhanced thermoresistance of free lambdavir, tr(1) phage and ability to reproduce at 44 C.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

N B GROMAN, G SUZUKI. 1962. Temperature and lambda phage reproduction.. https://doi.org/10.1128/jb.84.3.431-437.1962

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

Three-dimensional porous nano-hydroxyapatite@gelatin composite as efficient adsorbent for uranyl ion removal from low-level radioactive wastewater.

The contamination of water resources by uranyl (UO22+) ions poses significant environmental and health risks, requiring the development of efficient and sustainable remediation strategies. Adsorption-based techniques have emerged as promising approaches in the field of UO22+ removal, but the design of cost-effective, high-capacity, and environmentally friendly adsorbents remains challenging. In this study, a three-dimensional porous nano-hydroxyapatite@gelatin (nHAP@Ge) composite was synthesized through glutaraldehyde cross-linking, combining the structural stability of Ge with the high uranium affinity of nHAP. The optimized nHAP@Ge, with a nHAP:Ge mass ratio of 1:0.5, exhibited exceptional UO22+ removal efficiency (97 %), along with high adsorption capacity (364.03 mg/g). Systematic characterizations using scanning electron microscopy (SEM), thermogravimetric analysis (TGA), Fourier transform infrared (FT-IR) spectroscopy, and X-ray photoelectron spectroscopy (XPS) methods revealed that the porous structure and surface functional groups (-OH, Ca2+, and PO43-) of the material synergistically contributed to binding UO22+ species. Furthermore, the incorporation of nHAP into the Ge framework resulted in enhanced thermal stability while significantly improving the UO22+ adsorption performance. This work presents a scalable, eco-friendly, and recyclable strategy for the effective treatment of uranium-contaminated water, with potential applications in nuclear wastewater treatment and environmental remediation.

Adsorption↗

Adsorption behavior of selected monosaccharides onto an alumina interface.

The adsorption of glucose and fructose from their aqueous solutions onto an alumina interface has been carried out spectrophotometrically at room temperature. The adsorption isotherms are characterized as typical L-type and an adsorption mechanism on the basis of dipolar interactions has been suggested. In addition to this, a partial role of metal-saccharide interactions as found in organometallic complexes (OMCs) for the observed adsorption cannot be ruled out. Various kinetic and thermodynamic parameters of the adsorption process have been evaluated. The effects of variation in experimental conditions of the system have also been investigated. The adsorption exhibited a typical response to the pH effect and maximum adsorption was found near the isoelectric point of alumina (pH 9.0). The anionic addition to the suspension affects the adsorbed amount and Cl(-), SO(4)(2-), and PO(4)(3-) affect the adsorption quantitatively. The addition of similar concentration of cations was found to reduce the adsorbed amount. The presence of cationic and anionic detergents was found to influence both the adsorbed amount and the adsorption rate. The temperature was found to have an inverse effect on adsorption. Adsorptive kinetic parameters have revealed that fructose tends to be a better adsorbate than glucose. This is found to be consistent with the chelation behaviour of monosaccharides as found in the OMC of monosaccharides. The thermodynamics of the adsorption model indicates its spontaneous and exothermic nature. The negative values of entropy are an indication of the probability of a favorable nature of adsorption.

Adsorption↗

Cu(II) retention on a humic substance.

Humic substances (HS) are macromolecular products derived from a physical, chemical, and microbiological process called "humification." These substances play an important role in the mobility and bioavailability of nutrients and contaminants in the environment. Adsorption isotherms provide a macroscopic view of the retention phenomena. However, complementary techniques are needed in order to study the retention mechanism. The application of the classical models and some modern ones, based on humic substances chemistry, do not accurately describe these adsorption data. The aim of this paper is to model isotherms and combine adsorption data with spectroscopy and microscopy techniques to study the Cu(II) retention on a HS. The adsorption isotherms shape varies significantly with the solution pH from L-type (pH 2-6) to S-type (pH 8). FTIR shows that, when pH is 2 the retention of Cu(II), as [Cu(H(2)O)(6)](2+), is the preferred retention mechanism. The quantity of Cu(II) retained as [Cu(OH)(H(2)O)(6)](+) rises, as pH increases. At pH 4, Cu(II) begins to precipitate, which is the preferred mechanism at pH 8.02. The presence of HS has a great influence on the precipitation process of Cu(II), giving rise to amorphous precipitates. As it is shown by SEM-XRF, Cu(II) distributes heterogeneously on HS surface and accumulates on the humic phases. The presence of different anions (chloride and nitrate) slightly modifies the HS behavior as cation exchanger. When Cl(-) ions are present, part of the Cu(II) form [CuCl(4)](2-), which is stable in solution due to its negative charge; when the anion present is NO(3)(-) the formed complex, [CuNO(3)](+), is retained on the HS.

Adsorption↗