PubMed · 1290908
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
R A Glenner. 1992. The broach.. https://pubmed.ncbi.nlm.nih.gov/1290908/
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
This study deals with the structure of the inorganic phase of tertiary dentin, and is limited to dentin formation caused by mild or moderate stimuli, e.g., attrition or initial or shallow carious lesions. Ground sections were prepared from 20 human deciduous teeth extracted mainly because of orthodontic treatment, and contact microradiographs were produced. Based on visual inspection of the ground sections in reflected and transmitted light and microradiographic findings, small areas were dissected out and processed for electron microscopy. In the tertiary dentin formed in the pulp horns the number of tubules was reduced, while in that on the side walls of the pulp there was often no marked reduction in the number of tubules. Several tubules could be followed from the physiological (primary and secondary) dentin into the tertiary dentin, and a change in the direction of the tubules was often noted. Interglobular dentin was frequently observed, and in some teeth incremental lines with alternating high and low mineral content were seen, indicating that tertiary dentin, like other mineralized tissues, is subject to biological rhythms during formation. When studied in the electron microscope, tubules with varying size and distribution as well as occluded tubules with a high mineral content were seen. The tubules often had an irregular circumference with projections of mineralized tissue protruding into the lumen. Highly mineralized peritubular dentin was rarely observed. The present results show that orthodentin is formed when dentin in primary human teeth is exposed to mild or moderate stimuli.
Explore the source record for details and available documents.
In this study, the cutting ability of a newly developed dental laser was compared with a dental high-speed handpiece and rotary bur for removal of enamel. Measurements of the volume of tissue removed, energy emitted, and time of exposure were used to quantify the ablation rate (rate of tissue removal) for each test group and compared. Cutting efficiency (mm3/s) of the laser was calculated based on the mean volume of tissue removed per pulse (mm3/pulse) and unit energy expended (mm3/J) over the range of applied powers (2, 4, 6, and 8 W). The specimens were then examined by light microscopy and scanning electron micrographs for qualitative analysis of the amount of remaining debris and the presence of the smear layer on the prepared enamel surface. Calculations of the cutting efficiency of the laser over the range of powers tested revealed a linear relationship with the level of applied power. The maximum average rate of tissue removal by the laser was 0.256 mm3/s at 8 W, compared with 0.945 mm3/s by the dental handpiece. Light microscopy and scanning electron micrograph examinations revealed a reduction in the amount of remaining debris and smear layer in the laser-prepared enamel surfaces, compared with the conventional method. Based on the results of this study, the cutting efficiency of the high-speed handpiece and dental bur was 3.7 times greater than the laser over the range of powers tested, but the laser appeared to create a cleaner enamel surface with minimal thermal damage. Further modifications of the laser system are suggested for improvement of laser cutting efficiency.