PubMed · 12542281
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
Carl O Bauer. 2003-01-01. Developing clean coal technology.. https://doi.org/10.1021/es032325w
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
Interfacial tension, which is a critical variable affecting multiphase flow of nonaqueous phase liquids (NAPLs) in the subsurface, varies greatly with the composition of complex NAPLs recovered from field sites. Much of this variability stems from the presence of acid and base molecules in the NAPL mixture. The interfacial tension and acid and base concentration in six coal-derived NAPLs were measured. Creosotes generally have lower interfacial tensions due to their higher concentrations of organic acid and base macromolecules as compared with coal tar samples. Interfacial tension is a function of pH, with lower values measured at pH greater than approximately 9. At a neutral pH, the interfacial tensions are inversely proportional to the total acid concentration. Asphaltenes in these coal-derived NAPLs account for most of the acid and base constituents. It is found in this study that acid and base numbers are valuable indicators of interfacial tension and, therefore, the capillary phenomena associated with multiphase flow behavior of NAPLs in the subsurface.
A chemical mass balance model developed by the U.S. EPA, CMB8.2, was used to apportion the major sources of PAHs found in the sediments of Lake Calumet and surrounding wetlands in southeast Chicago. The results indicate the feasibility of applying CMB8.2 to pollutants found in aquatic sediments. To establish the fingerprints of PAH sources, 28 source profiles were collected from the literature. Some of the source profiles were modified based on the gas/particle partitioning of individual PAHs. The profiles under the same source category were averaged, and the fingerprints of six sources were established, including coke oven, residential coal burning, coal combustion in power generation, gasoline engine exhaust, diesel engine exhaust, and traffic tunnel air. Nine model operations with a total of 422 runs were made, differing in the choice of fitting species and the sources involved. Modeling results indicate that coke ovens and traffic are the two major sources of PAHs in the area. For traffic sources, either traffic tunnel alone or both diesel and gasoline engine exhausts were entered into the model. These two groups of model operations produced comparable results with regard to the PAH contributions from road traffic. Although the steel industries have shrunk in recent years, closed and still-active coke plants continue to contribute significantly to the PAH loadings. Overall, the average contribution from coke oven emissions calculated by different operations ranges from 21% to 53% of all sources, and that from traffic ranges from 27% to 63%. The pattern of source contributions shows spatial and temporal variations.
Explore the source record for details and available documents.