Search PubMed⌕ Search

PubMed · 12398443

Internal-wave time evolution effect on ocean acoustic rays.

Abstract

A range-dependent field of sound speed in the ocean, c(x,z), caused by internal waves, can give rise to instabilities in acoustic ray paths. Past work has shown the importance of the background, range-independent, sound-speed profile; the ray initial conditions; the source-receiver geometry (depths and range); and the strength of the internal waves. However, in the past the time evolution of the internal waves has been ignored on the grounds that the speed of internal waves is much slower than the speed of the acoustic wave. It is shown here by numerical simulation that two rays with identical initial conditions, traveling through an ocean with the same background profile and the same random realization of internal waves, but with the internal waves frozen in one case and evolving in the other, travel significantly different trajectories. The dependence of this "frozen-unfrozen" difference on the initial ray launch angle, the background profile, and the strength of the internal-wave spectrum, is investigated. The launch-angle difference that generates similar arrival-depth differences to those induced by internal-wave time evolution is on the order of 100 microrad. The pattern of differences is measured here by the arrival depth at the final range of 1000 km. The observed pattern as a function of launch angle, change in the background profile, and change in internal-wave strength is found to be nearly the same for "frozen-unfrozen" change as for a slight change in launch angle.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Stanley M Flatté, Michael D Vera. 2002. Internal-wave time evolution effect on ocean acoustic rays.. https://doi.org/10.1121/1.1501897

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

Effects of gamma irradiation on mechanical properties of defatted trabecular bone allografts assessed by speed-of-sound measurement.

New sterilization methods for human bone allografts may lead to alterations in bone mechanical properties, which strongly influence short- and medium-term outcomes. In many sterilization procedures, bone allografts are subjected to gamma irradiation, usually with 25 KGy, after treatment and packaging. We used speed-of-sound (SOS) measurements to evaluate the effects of gamma irradiation on bone. All bone specimens were subjected to the same microbial inactivation procedure. They were then separated into three groups, of which one was treated and not irradiated and two were exposed to 10 and 25 KGy of gamma radiation, respectively. SOS was measured using high- and low-frequency ultrasound beams in each orthogonal direction. SOS and Young modulus were altered significantly in the three groups, compared to native untreated bone. Exposure to 10 or 25 KGy had no noticeable effect on the study variables. The impact of irradiation was small compared to the effects of physical or chemical defatting. Reducing the radiation dose used in everyday practice failed to improve graft mechanical properties in this study.

Acoustics↗

Objective and subjective evaluation of the acoustic comfort in classrooms.

The acoustic comfort of classrooms in a Brazilian public school has been evaluated through interviews with 62 teachers and 464 pupils, measurements of background noise, reverberation time, and sound insulation. Acoustic measurements have revealed the poor acoustic quality of the classrooms. Results have shown that teachers and pupils consider the noise generated and the voice of the teacher in neighboring classrooms as the main sources of annoyance inside the classroom. Acoustic simulations resulted in the suggestion of placement of perforated plywood on the ceiling, for reduction in reverberation time and increase in the acoustic comfort of the classrooms.

Acoustics↗

Analysis of effective radiating area, power, intensity, and field characteristics of ultrasound transducers.

OBJECTIVE: To characterize the ultrasound fields produced by a cohort of transducers from a single manufacturer via hydrophone and Schlieren technology. DESIGN: Descriptive study. SETTING: Measurement laboratory. PARTICIPANTS: Seven same-model ultrasound transducers from a single manufacturer. INTERVENTIONS: Not applicable. MAIN OUTCOME MEASURES: Effective radiating area (ERA), total power, spatial average intensity (SAI), beam nonuniformity ratio (BNR), and Schlieren beam widths at 1.0 and 3.3 MHz. RESULTS: Values for ERA (1.0 MHz range, 3.62-4.38 cm(2); 3.3 MHz range, 3.74-4.76 cm(2)), total power (1.0 MHz range, 5.0-5.6 W; 3.3 MHz range, 4.7-5.7 W), SAI (1.0 MHz range, 1.2-1.4 W/cm(2); 3.3 MHz range, 1.0-1.5 W/cm(2)), and BNR (1.0 MHz range, 2.79-5.85; 3.3 MHz range, 2.51-4.56) fell within manufacturer's specifications and U.S. Food and Drug Administration (FDA) regulations. Schlieren analysis showed significantly larger beam widths at 3.3 MHz compared with 1.0 MHz and a large degree of variability in the ultrasound fields generated by the different transducers. There were no significant correlations between beam widths and ERA values. CONCLUSIONS: ERA and total power values in a test cohort exist within a range that met FDA regulations. Individual variability in ERA and total power resulted in 50% variability in SAI. This variability may help explain previous reports of heating differences between transducers.

Acoustics↗