PubMed · 10237588
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
1975. Seward minor operating table.. https://pubmed.ncbi.nlm.nih.gov/10237588/
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
Effect of temperature on interfacial sliding in single-walled carbon nanotube polycarbonate composites is investigated experimentally. We show that interfacial slip at the tube-polymer interfaces can be activated at relatively low dynamic strain levels ( approximately 0.35%) by raising temperature to approximately 90 degrees C. We attribute this to increased mobility of the polymer chain backbones at elevated temperatures and thermal relaxation of the radial compressive stresses at the tube-polymer interfaces. These results show the potential of polymer nanocomposites as high-temperature damping materials for vibration and acoustic suppression in a variety of dynamic systems.
The purpose of this study was to investigate the effects of particle shape on the movement of particles in a pan-coating device using novel video-imaging techniques. An area scan CCD camera was installed inside a 24-in pan coater at the same location as that of a spray nozzle, and the movement of particles was tracked using machine vision. A white tracer particle was introduced inside a bed of black-coated particles. The effects of pan loading, pan speed, and particle shape on the movement of particles was studied. The response variables were circulation time, surface time, projected area of particle per pass, dynamic angle of repose, cascading velocity, and dispersion coefficient. Experiments were conducted at 3 different pan speeds, 6, 9, and 12 rpm, and 2 fill levels (ratio of bed depth to pan diameter), one eighth and one quarter, and data were collected over a 30-minute time period. The differences in circulation times of spheres and tablets, with similar volume equivalent diameter as that of the sphere, were found to be insignificant at the 95% confidence interval. The circulation time ranged from 2.8 to 10.8 seconds depending on the operating condition and increased with increasing pan load and decreasing pan speed. The distributions of circulation time, surface time, and projected surface area were found to be nonnormal. The dynamic angle of repose for tablets was higher than for spheres. Also, the bed surface for spheres was much flatter in comparison with tablets where the bed shape attained a "wave-like" form. The average velocity of tablets in the cascading layer was found to be significantly higher than spheres. A linear model (R(2) > 0.98) best described the variation of velocity as a function of pan speed for all of the operating conditions.
The delivery of intensity-modulated radiation therapy (IMRT) with a multileaf collimator (MLC) requires the conversion of a radiation fluence map into a leaf sequence file that controls the movement of the MLC during radiation delivery. It is imperative that the fluence map delivered using the leaf sequence file is as close as possible to the fluence map generated by the dose optimization algorithm, while satisfying hardware constraints of the delivery system. Optimization of the leaf sequencing algorithm has been the subject of several recent investigations. In this work, we present a systematic study of the optimization of leaf sequencing algorithms for segmental multileaf collimator beam delivery and provide rigorous mathematical proofs of optimized leaf sequence settings in terms of monitor unit (MU) efficiency under most common leaf movement constraints that include minimum leaf separation constraint and leaf interdigitation constraint. Our analytical analysis shows that leaf sequencing based on unidirectional movement of the MLC leaves is as MU efficient as bidirectional movement of the MLC leaves.