Search PubMed⌕ Search
Home/Archive/PubMed

PubMed · 10188762

Lamifiban.

M Dooley·K L Goa
View original source ↗Export metadata ↓

Abstract

Lamifiban is an intravenously administered, selective, reversible, nonpeptide glycoprotein IIb/IIIa receptor antagonist which inhibits platelet aggregation and thrombus formation by preventing the binding of fibrinogen to platelets. In trials in patients with non-Q wave myocardial infarction (MI) or unstable angina pectoris (PARAGON A and the Canadian Lamifiban Study), the incidence of clinical events at 30 days in patients receiving lamifiban (1 to 5 microg/min) was not significantly different from that in patients receiving aspirin plus heparin or aspirin alone. In PARAGON A, the incidence of clinical events at 6 months was significantly lower after lamifiban (with or without heparin) and aspirin therapy than after standard heparin and aspirin therapy. A large phase III trial (PARAGON B) is under way comparing lamifiban plus aspirin and heparin with standard aspirin and heparin therapy in patients with non-Q wave MI or unstable angina pectoris. In clinical trials, the most common adverse events associated with lamifiban were bleeding complications which were increased by the concomitant administration of heparin.

Explore related subjects

AcetatesAnimalsBleeding TimeClinical Trials as TopicHumansPlatelet Aggregation InhibitorsTyrosineJournal ArticleReview

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

M Dooley, K L Goa. 1999. Lamifiban.. https://doi.org/10.2165/00003495-199957020-00009

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

PubMed2007

Neural network prediction of thermophilic (65 degrees C) sulfidogenic fluidized-bed reactor performance for the treatment of metal-containing wastewater.

The performance of a fluidized-bed reactor (FBR) based sulfate reducing bioprocess was predicted using artificial neural network (ANN). The FBR was operated at high (65 degrees C) temperature and it was fed with iron (40-90 mg/L) and sulfate (1,000-1,500 mg/L) containing acidic (pH = 3.5-6) synthetic wastewater. Ethanol was supplemented as carbon and electron source for sulfate reducing bacteria (SRB). The wastewater pH of 4.3-4.4 was neutralized by the alkalinity produced in acetate oxidation and the average effluent pH was 7.8 +/- 0.8. The oxidation of acetate is the rate-limiting step in the sulfidogenic ethanol oxidation by thermophilic SRB, which resulted in acetate accumulation. Sulfate reduction and acetate oxidation rates showed variation depending on the operational conditions with the maximum rates of 1 g/L/d (0.2 g/g volatile solids (VS)/d) and 0.3 g/L/d (0.06 g/g VS/d), respectively. This study presents an ANN model predicting the performance of the reactor and determining the optimal architecture of this model; such as best back-propagation (BP) algorithm and neuron numbers. The Levenberg-Marquardt algorithm was selected as the best of 12 BP algorithms and optimal neuron number was determined as 20. The developed ANN model predicted acetate (R=0.91), sulfate (R=0.95), sulfide (R=0.97), and alkalinity (R=0.94) in the FBR effluent. Hence, the ANN based model can be used to predict the FBR performance, to control the operational conditions for improved process performance.

Acetates↗
PubMed2007

Short-term temperature effects on the anaerobic metabolism of glycogen accumulating organisms.

Proliferation of glycogen accumulating organisms (GAO) has been identified as a potential cause of enhanced biological phosphorus removal (EBPR) failure in wastewater treatment plants (WWTP). GAO compete for substrate with polyphosphate accumulating organisms (PAO) that are the microorganisms responsible for the phosphorus removal process. In the present article, the effects of temperature on the anaerobic metabolism of GAO were studied in a broad temperature range (from 10 to 40 degrees C). Additionally, maximum acetate uptake rate of PAO, between 20 and 40 degrees C, was also evaluated. It was found that GAO had clear advantages over PAO for substrate uptake at temperatures higher than 20 degrees C. Below 20 degrees C, maximum acetate uptake rates of both microorganisms were similar. However, lower maintenance requirements at temperature lower than 30 degrees C give PAO metabolic advantages in the PAO-GAO competition. Consequently, PAO could be considered to be psychrophilic microorganisms while GAO appear to be mesophilic. These findings contribute to understand the observed stability of the EBPR process in WWTP operated under cold weather conditions. They may also explain the proliferation of GAO in WWTP and thus, EBPR instability, observed in hot climate regions or when treating warm industrial effluents. It is suggested to take into account the observed temperature dependencies of PAO and GAO in order to extend the applicability of current activated sludge models to a wider temperature range.

Acetates↗
PubMed2007

Long-term performance of peat biofilters treating ethyl acetate, toluene, and its mixture in air.

Three laboratory-scale peat biofilters were operated at 90 s empty bed residence time (EBRT) for over a year. Biodegradation of ethyl acetate, toluene, or a 1:1 mixture were investigated. In first stage, inlet concentration was progressively increased from 0.4 to 4.5 g/m(3). The maximum elimination capacity (EC) found for ethyl acetate was 190 gC/m(3).h, and it was not affected by toluene. The maximum EC found for toluene as a sole contaminant was 150 gC/m(3).h, but the presence of ethyl acetate decreased the toluene maximum EC to 80 gC/m(3).h. From respirometry monitoring, values of 3.19 g CO(2)/gC and 3.06 g CO(2)/gC for pure ethyl acetate and pure toluene, respectively, were found, with overall yield coefficients of 0.13 g dry biomass produced per gram ethyl acetate consumed and 0.28 g dry biomass produced per gram toluene consumed. CO(2) production in the 1:1 mixture was successfully simulated. Dynamics of living and dead cells were monitored in four sections of the biofilters. Concentrations ranged between 2.6 x 10(9) and 3.0 x 10(10) cells per gram-dry peat for total bacteria, and 2.4 x 10(9)-1.9 x 10(10) cells per gram-dry peat for living bacteria. At high loads loss of bacterial density in the inlet zones, and increase in the dead cells percentages up to 60% was observed. In second stage, long-term performance at an inlet concentration of 1.5 g/m(3) was evaluated to show the process feasibility. Good agreement with previous data was obtained in terms of EC and CO(2) production. Restoration of living cells proportion was also observed.

Acetates↗