Search PubMed⌕ Search

PubMed · 10139739

Hepatitis: protecting BMETs & CEs.

Abstract

Hepatitis is the primary occupational hazard for healthcare workers. Not until the 1970s were hepatitis viruses isolated and identified as types A and B. In the late 1970s, hepatitis D was discovered as a major cause of fulminant hepatitis. Soon, it was evident that another type was also at work. Because testing was only available for types A and B, the new category was referred to as non-A, non-B. In the 1980s, scientists identified two more viruses from this non-A, non-B group, namely hepatitis E and hepatitis C. These five types of hepatitis have different modes of transmission. The fecal-to-oral route is the mode of transmission for hepatitis types A and E. But, types B and D are bloodborne pathogens. With the advent of a safe vaccine for hepatitis B, this category is declining. To date, hepatitis C appears to have multiple routes of transmission, with half the cases being posttransfusion. In the United States, 85,000 people per year develop chronic hepatitis C, which ultimately leads to severe liver damage. This paper addresses each of the five viruses that have been grouped by routes of transmission, prevention techniques for BMETs and CEs, and statistics of reported cases to the Centers for Disease Control and Prevention (CDCP) over the last 20 years.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

S A Baker. Hepatitis: protecting BMETs & CEs.. https://doi.org/10.1097/00004669-199411000-00013

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

Optimal design of non-Newtonian, micro-scale viscous pumps for biomedical devices.

The present paper addresses the numerical optimization of geometrical parameters of non-Newtonian micro-scale viscous pumps for biomedical devices. The objective is to maximize the mass flow rate per unit of shaft power consumed by the rotor when an external pressure load is applied along the channel that houses the rotor. Two geometric parameters are considered in the optimization process: (i) the height of the channel that houses the rotor (H) and (ii), the eccentricity (epsilon) of the rotor. Three different micro-scale viscous pump configurations were tested: a straight-housed pump (I-shaped housing) and two curved housed pumps (L- and U-shaped housings). The stress-strain constitutive law is modeled by a power-law relation. The results show that the geometric optimization of micro-scale viscous pumps is critical since the mass flow rate propelled by the rotor is highly dependent on epsilon and H. Numerical simulations indicate that mass flow rate is maximized when epsilon approximately 0, namely when the rotor is placed at a distance of 0.05 radii from the lower wall. The results also show that micro-scale viscous pumps with curved housing provide higher mass flow rate per unit of shaft power consumed when compared with straight-housed pumps. The results are presented in terms optimized dimensions of all three configurations (i.e., H(opt) and epsilon(opt)) and for values of the power-law index varying between 0.5 (shear thinning fluids) and 1.5 (shear-thickening fluids).

Biomedical Engineering↗