Biomedical subjects

Y Vander Heyden

Publications and source records attributed to Y Vander Heyden.

15 recordsLinked to original sources

PubMed2001

Quantitative structure-retention and retention-activity relationships of beta-blocking agents by micellar liquid chromatography.

Sixteen beta-blocking agents (acebutolol, alprenolol, atenolol, bisoprolol, carteolol, celiprolol, esmolol, labetalol, metoprolol, nadolol, oxprenolol, pindolol, practolol, propranolol, sotalol and timolol) showing a large range of hydrophobicity (octanol-water partition coefficients, log P between -0.026 and 2.81) were subjected to micellar liquid chromatography with sodium dodecyl sulfate as micelle forming agent, and n-propanol as organic modifier. The correlation between log P and the retention factor extrapolated to a mobile phase free of micelles and organic modifier was investigated. The use of an interpolated retention factor or the retention factor for specific individual experimental mobile phases was however advantageous since the retention factors of all beta-blocking agents were measurable in the selected mobile phases. Good correlations with log P and with in vitro biological parameters (cellular permeability coefficients in Caco-2 monolayers and apparent permeability coefficients in rat intestinal segments) were found.

Adrenergic beta-Antagonists↗

PubMed2001

Development and validation of a high-performance liquid chromatographic method for the determination of gamma-hydroxybutyric acid in rat plasma.

A method for the determination of gamma-hydroxybutyric acid (GHB) in rat plasma was developed using solid-phase extraction (SPE) and high-performance liquid chromatography (HPLC) with UV detection. GHB was isolated from plasma using strong anion-exchange SPE columns. The chromatographic separation was performed on a C18 Aqua column. The lower limit of quantification was 10 microg/ml using 60 microl of plasma. The linearity of the calibration curves was satisfactory as indicated by correlation coefficients of >0.990. The within-day and between-day precision were <10% (n=24), the accuracy was nearly 101%. Plasma concentrations in rats after GHB infusion determined by HPLC-UV were compared with the corresponding concentrations determined with a validated gas chromatographic-mass spectrometric method by orthogonal distance regression. A good correlation was observed and a t-test indicated no significant differences from 0 and 1 for the intercept and slope, respectively.

Animals↗

PubMed2001

Evaluation of dissolution profiles using principal component analysis.

The performance of principal component analysis (PCA) for the evaluation of dissolution profiles is examined and compared with other methods such as the similarity factor and the calculation of the area under the curve. Both simulated and real data from the pharmaceutical industry are used. The PCA scores plots of the dissolution curves provide information about the between- and within-batch variations. Differences in level or shape can be observed in the first two principal components (PCs). Irrelevant irregularities, which have a strong influence on the similarity factor, are neglected in PC1/PC2. To detect outliers in a set of dissolution curves, PCA was preferred above Hotelling's T2 test. In general, PCA is found to be a useful technique to examine dissolution data visually, but however, it does not contain criteria to decide if batches are similar or not. This can be done by combining PCA with the resampling with replacement or bootstrap method to construct confidence limits.

Solubility↗

PubMed2001

Rapid screening for chiral separations by short-end injection capillary electrophoresis using highly sulfated cyclodextrins as chiral selectors.

Two series of amino acid derivatives and phenylamines were used to evaluate the potential of highly sulfated cyclodextrins (HS-CDs) for the screening for chiral separations by capillary electrophoresis (CE). HS-CDs showed to be very versatile and to exhibit very high enantioselectivity. The use of short-end injection allowed to reduce dramatically the analysis time. From the results obtained, a scheme for the rapid screening of enantiomeric molecules was developed and applied to various chiral drugs. Results are very satisfying as almost all compounds (62 out of 67) could be baseline-resolved. Usually, less than three experiments were necessary to obtain very good separation.

Acids↗

PubMed2001

Optimization of the chiral separation of some 2-arylpropionic acids on an avidin column by modeling a combined response.

The enantiomeric separation of some nonsteroidal antiinflammatory drugs was investigated on an avidin column. An experimental design approach (central composite design) was used to evaluate the effects of three method parameters (pH, concentration of organic modifier, and buffer concentration) on the analysis time and the resolution, as well as to model these responses. This revealed that the organic modifier concentration and sometimes the pH are significant parameters to control because of their influence on both analysis time and resolution. Furthermore, the central composite design results were combined in a multicriteria decision-making approach in order to obtain a set of optimal experimental conditions leading to the most desirable compromise between resolution and analysis time.

Anti-Inflammatory Agents, Non-Steroidal↗

PubMed2001

Screening of an enterovirus specific RT-PCR ELISA method for the quantification of enterovirus genomes in human body fluids by means of a three-level experimental design.

In order to obtain a detection limit as low as possible for a quantitative enterovirus specific RT-PCR ELISA assay, optimal reaction conditions, which give rise to the highest response, need to be determined. This was done by investigating the influence of 13 factors, selected from RT and PCR, in a multivariate approach by means of a well-balanced three-level screening design, derived from a three-level Plackett--Burman design. Optimal reaction conditions could be determined by calculation and evaluation of the effects of the different factors on the response, i.e. the measured absorbance of the ELISA detection. The method will be used to study a possible longitudinal relationship between enteroviruses and the development of multiple sclerosis and juvenile diabetes.

Body Fluids↗

PubMed2001

Guidance for robustness/ruggedness tests in method validation.

This paper is intended to give guidance in setting-up and interpreting a robustness test. The different steps in a robustness test are discussed and illustrated with examples. The recommendations given for the different steps are based on approaches found in the literature, several case studies performed by the authors and discussions of the authors within a commission of the French SFSTP (Société Française des Sciences et Techniques Pharmaceutiques). In the end of the paper a worked-out example is given of a robustness test case study set up and interpreted according to the guidelines.

Chemistry, Pharmaceutical↗

PubMed2001

LC separation of calcipotriol from its photodegradation products and protection possibilities using adjuvants.

Mobile phase optimization and reversed-phase column characteristics were used to separate photodegradation products from the parent compound, 24-cyclopropyl-9-,10-secochola-5,7,10(19),22-tetraene-1alpha,3beta,24-triol (calcipotriol). Separation between calcipotriol and its degradation products was obtained with an acetonitrile/water (53:47, v/v) mobile phase on a C(18) Hypersil ODS column (250 mm length, 4.6 mm id, 5 microm particle size) and a flow rate of 1 ml/min. Using this system, the influence of commonly used solvents in dermatology on degradation was studied. The addition of a UV filter in two concentrations was also evaluated for its possible protective effect to light exposure. Propylene glycol and polyethylene glycol 400 decreased the speed of degradation. The sunscreen 2-hydroxy-4-methoxybenzophenone affords a protection proportional to the filter concentration used in the study.

Calcitriol↗

PubMed2000

Exploratory chemometric analysis of the classification of pharmaceutical substances based on chromatographic data.

A chemometric study has been conducted on a published data set consisting of the retention times of 83 substances, from five pharmacological families, on eight HPLC systems. Principal component analysis, clustering and sequential projection pursuit were applied. In this way it was investigated to what extent the combination of chromatography and chemometrics allows one to make conclusions about pharmacological activities of (candidate) drugs and what the contribution is of the different HPLC systems considered.

Chromatography, High Pressure Liquid↗

PubMed2000

Robustness testing of a reversed-phase high-performance liquid chromatographic assay: comparison of fractional and asymmetrical factorial designs.

Robustness tests were performed on a reversed-phase HPLC assay for triadimenol. Different experimental designs were compared. Two-level fractional factorial designs with different resolutions were used to study the influence of procedure-related factors. The factors chromatographic column manufacturer at four levels and instrument at three levels were stepwise included in the study using asymmetrical factorial designs. The significance of the factor effects was determined statistically, using two types of error estimates in the calculation of critical effects, and graphically, by means of half-normal plots. The asymmetrical designs turned out to be an efficient and economic method to examine the influence of factors at different numbers of levels in the robustness testing of analytical methods.

Chromatography, High Pressure Liquid↗

PubMed1999

Rapid development of the enantiomeric separation of beta-blockers by capillary electrophoresis using an experimental design approach.

A rapid method for determining the separation conditions for chiral resolution of eleven beta-blocking drug substances by capillary electrophoresis is described, using an experimental design approach. An acidic phosphate-triethanolamine buffer and an uncoated fused-silica capillary were used for all experiments. Several modified cyclodextrins were applied as chiral selectors: sulfobutyl ether beta-cyclodextrin (SBE-beta CD), dimethyl beta-cyclodextrin (DM-beta CD), carboxymethyl beta-cyclodextrin (CM-beta CD), and hydroxypropyl beta-cyclodextrin (HP-beta CD). Two different fractional factorial experimental designs were applied: (1) a design examining four factors at three levels (3(4-2)) and (2) one examining three factors at two levels (2(3-1)). The factors studied were: type of cyclodextrin, cyclodextrin concentration, pH of the background electrolyte and percentage of organic modifier. Enough resolution for the separation of the enantiomers and even for their quantification was reached. The same scheme is proposed when a fast chiral separation method needs to be developed for other drug families.

Adrenergic beta-Antagonists↗

PubMed1999

Nested designs in ruggedness testing.

Nested designs were performed in order to execute a ruggedness test according to the United States Pharmacopeia definition for ruggedness, in which mainly non-procedure related factors are examined. Several nested designs have been executed on a high performance liquid chromatography assay to determine tetracycline and related substances in bulk samples of tetracycline. Factors such as different laboratories, analysts, instruments, columns, days and batches were examined. The interpretation methods described in the literature were found to cause problems. In these methods the variances of the examined factors are estimated from the calculated mean square values and from the equation for the expected mean squares. Very frequently, negative variance estimates were obtained. Their absolute values were found to be dependent on the influence of the factor examined below it in the design, on the examined response. Therefore an alternative interpretation method for nested designs, based on pooled variances, was proposed and found to be appropriate to use for ruggedness testing purposes. Both approaches, the one from the literature and the one proposed here, were tested on simulated data coming from a nested design with four factors and on the experimentally measured data.

Analysis of Variance↗

PubMed1999

Use of experimental design to optimise a flow injection analysis assay for L-N-monomethylarginine.

A flow injection analysis (FIA) method to determine L-N-monomethylarginine, based on the reaction with ortho-phthalaldehyde in the presence of a suitable thiol-group, was optimised using experimental design. Two different approaches were followed wherein, (i) critical factors were identified in a screening design, and (ii) the simplex algorithm was used for further optimisation. In the first approach, the chemical reaction was optimised off-line and the optimal chemical conditions were transferred to the FIA-system. In the second approach the reaction and the FIA-system parameters were optimised together. The on-line approach is preferred.

Acetylcysteine↗

PubMed1998

RTS, a computer program for the experimental set-up and interpretation of ruggedness tests.

A computer program is described for the experimental set-up and interpretation of ruggedness tests. The implemented strategy was based on a number of case studies and contains both recommended designs and minimal designs. The minimal designs reduce the number of experiments, but they cannot be statistically interpreted based on the interaction or dummy factor effects. The use of randomization tests as an alternative statistical interpretation method for the significance of the effects was examined. Some of the minimal designs are expandable to designs with characteristics similar to those of the recommended designs. The program is designed to facilitate the selection of the designs and the interpretation of the results and to prevent or detect problems such as drifting of responses.

Chemistry Techniques, Analytical↗

PubMed1998

Ruggedness testing of chromatographic methods: selection of factors and levels.

The first step in a ruggedness test is the selection of factors to be examined and their levels. In this paper, both topics are discussed, thereby completing a strategy described earlier. It is demonstrated, by means of some examples, that depending on the formulation (definition) of a factor, information that is physically more or less meaningful is extracted from the experimental design results. Among others, the inclusion of the compounds of a buffer and of the components of a mixture in a screening design were examined. A general guideline to select the levels of the factors in a ruggedness test was proposed. Some special cases, i.e. asymmetric intervals around the nominal level, were also discussed.

Chemistry Techniques, Analytical↗