Biomedical subjects

Xiangfeng Duan

Publications and source records attributed to Xiangfeng Duan.

3 recordsLinked to original sources

PubMed2005

Nanowires for integrated multicolor nanophotonics.

Nanoscale light-emitting diodes (nanoLEDs) with colors spanning from the ultraviolet to near-infrared region of the electromagnetic spectrum were prepared using a solution-based approach in which emissive electron-doped semiconductor nanowires were assembled with nonemissive hole-doped silicon nanowires in a crossed nanowire architecture. Single- and multicolor nanoLED devices and arrays were made with colors specified in a predictable way by the bandgaps of the III-V and II-VI nanowire building blocks. The approach was extended to combine nanoscale electronic and photonic devices into integrated structures, where a nanoscale transistor was used to switch the nanoLED on and off. In addition, this approach was generalized to hybrid devices consisting of nanowire emitters assembled on lithographically patterned planar silicon structures, which could provide a route for integrating photonic devices with conventional silicon microelectronics. Lastly, nanoLEDs were used to optically excite emissive molecules and nanoclusters, and hence could enable a range of integrated sensor/detection "chips" with multiplexed analysis capabilities.

Luminescent Measurements↗

PubMed2003

High-performance thin-film transistors using semiconductor nanowires and nanoribbons.

Thin-film transistors (TFTs) are the fundamental building blocks for the rapidly growing field of macroelectronics. The use of plastic substrates is also increasing in importance owing to their light weight, flexibility, shock resistance and low cost. Current polycrystalline-Si TFT technology is difficult to implement on plastics because of the high process temperatures required. Amorphous-Si and organic semiconductor TFTs, which can be processed at lower temperatures, but are limited by poor carrier mobility. As a result, applications that require even modest computation, control or communication functions on plastics cannot be addressed by existing TFT technology. Alternative semiconductor materials that could form TFTs with performance comparable to or better than polycrystalline or single-crystal Si, and which can be processed at low temperatures over large-area plastic substrates, should not only improve the existing technologies, but also enable new applications in flexible, wearable and disposable electronics. Here we report the fabrication of TFTs using oriented Si nanowire thin films or CdS nanoribbons as semiconducting channels. We show that high-performance TFTs can be produced on various substrates, including plastics, using a low-temperature assembly process. Our approach is general to a broad range of materials including high-mobility materials (such as InAs or InP).

Journal Article↗

PubMed2003

Single-nanowire electrically driven lasers.

Electrically driven semiconductor lasers are used in technologies ranging from telecommunications and information storage to medical diagnostics and therapeutics. The success of this class of lasers is due in part to well-developed planar semiconductor growth and processing, which enables reproducible fabrication of integrated, electrically driven devices. Yet this approach to device fabrication is also costly and difficult to integrate directly with other technologies such as silicon microelectronics. To overcome these issues for future applications, there has been considerable interest in using organic molecules, polymers, and inorganic nanostructures for lasers, because these materials can be fashioned into devices by chemical processing. Indeed, amplified stimulated emission and lasing have been reported for optically pumped organic systems and, more recently, inorganic nanocrystals and nanowires. However, electrically driven lasing, which is required in most applications, has met with several difficulties in organic systems, and has not been addressed for assembled nanocrystals or nanowires. Here we investigate the feasibility of achieving electrically driven lasing from individual nanowires. Optical and electrical measurements made on single-crystal cadmium sulphide nanowires show that these structures can function as Fabry-Perot optical cavities with mode spacing inversely related to the nanowire length. Investigations of optical and electrical pumping further indicate a threshold for lasing as characterized by optical modes with instrument-limited linewidths. Electrically driven nanowire lasers, which might be assembled in arrays capable of emitting a wide range of colours, could improve existing applications and suggest new opportunities.

Journal Article↗