Search PubMedSearch

Biomedical subjects

W M Busing

Publications and source records attributed to W M Busing.

4 recordsLinked to original sources

Perspective and limitations of cryo-electron microscopy. From model systems to biological specimens.

We investigated the possibility of vitrifying temperature-sensitive lipid phases as well as (small) biological specimens. From a suspension of unilamellar vesicles, prepared from dipalmitoyl-phosphatidylcholine (DPPC), thin aqueous films were formed at various temperatures. With cryo-electron microscopy vesicles were found to be smooth, rippled and faceted or faceted only, depending on the temperature of thin-film formation (318, 312 and 296 K respectively). The morphology and the electron diffraction patterns indicate that membranes can by physically fixed by vitrification in their high-temperature configuration and studied at low temperature by cryo-electron microscopy. This finding suggests that it may also be possible to preserve, in their original state, the more complex membrane systems found in living organisms by initiating rapid-cooling at a physiological temperature. This was explored by vitrification of thin films formed on specimen grids with (human) blood platelets adhering to collagen fibres. Low-temperature observation with an acceleration voltage of 120 kV revealed subcellular details, More details were observed when using higher accelerating voltages (200 and 300 kV) of the electron beam. The results presented in this paper illustrate the great potential of cryo-electron microscopy in the study of membrane dynamics, both in relatively simple model membrane systems and in more complex biological membrane systems.

Blood Platelets

Phospholipid, nature's own slide and cover slip for cryo-electron microscopy.

Thin films of surface-active compounds, with or without particulate material, can be obtained by immersing and withdrawing a bare specimen grid from a solution/suspension of the compound. Immediately after withdrawing the grid, thinning of the film starts. Thinning is initially powered by gravity and capillary forces and will proceed in thin films (less than 100 nm) driven by intermolecular forces until the London-van der Waals attractive forces come to an equilibrium with electrostatic repulsion of similarly charged surfaces of the film. With small unilamellar vesicles prepared from the phospholipid dimyristoyl phosphatidyl choline (DMPC) the draining behaviour of these films was studied by cryo-electron microscopy. Small unilamellar vesicles were observed within the film as well as the coalescence of these vesicles into sheets ('leaky' membrane fusion). Sheets dominate the images when films are allowed to drain for longer periods (greater than 3 min). Thin films were formed on grids from catalase crystals suspended in a DMPC suspension and vitrified by cooling. High-resolution information was obtained by electron diffraction at low temperature and under low-dose conditions from catalase crystals surrounded by small vesicles as well as from catalase crystals surrounded by sheets of DMPC. In the latter case the water content drops from 99% (DMPC in small vesicles) to less than 30% (DMPC in sheets) during draining. Ferritin was added to a DMPC suspension and thin films were prepared and vitrified. After prolonged draining ferritin molecules were deposited in layers with a stepwise increase in thickness. Draining of thin films has thus a dehydrating effect as well as a sorting and ordering effect. These effects must be considered when using surface-active compounds at air-water interfaces as a slide and cover slip for electron microscopy.

Catalase

Cryo-transfer revised.

Vapour deposition of water is a major problem in cryo-transfer and cryo-observation of frozen specimens. The use of (sliding) shields to protect the specimen during transfer has been evaluated and was found to be a fail-safe procedure. Shielding the specimen with solidified coolant is proposed as an alternative or additional protection. The protective layer (ethane, Freon 22) can be evaporated in the high vacuum of the microscope. The evaporating coolant will carry away water films deposited on top. The temperature of coolant evaporation is low enough to prevent possible devitrification of water in the specimen itself.

Freezing

Freezing of tissue-limits for the autoradiographic localization of diffusible substances.

Frozen thin sections and sections from freeze-dried and embedded tissue are used for the autoradiographic localization of diffusible substances at the electron microscope level. The presence of ice crystals in such sections may limit the autoradiographic resolution. Ice crystals are formed during freezing and may grow during subsequent processing of tissue. The contribution of ice crystal growth to the final image was estimated by measuring the distribution of the ice crystal sizes in freeze-etch replicas and in sections from freeze-dried and embedded tissues. A surface layer (10-15 mu) without visible ice crystals was present in both preparations. Beneath this surface layer the diameter of ice crystals increased towards the interior with the same relationship between crystal size and distance from the surface in the freeze-etch preparation as in the freeze-dry preparation. Ice crystal growth occurring during a much longer time during freeze-drying compared to freeze-etching does not significantly contribute to the final image in the electron microscope. The formation of ice crystals during freezing determines to a large extent the image (and therefore the autoradiographic resolution) of freeze-dry preparations and this probably holds also for thin cryosections of which examples are given.

Animals