Biomedical subjects

Steven Baldelli

Publications and source records attributed to Steven Baldelli.

11 recordsLinked to original sources

PubMed2006

Sum frequency generation imaging microscopy of CO on platinum.

Sum frequency vibrational spectroscopy is utilized as an imaging technique to distinguish and compare the local response of carbon monoxide (CO) covered platinum (Pt) polycrystalline surface versus the average response of the investigated area. The Pt electrode was prepared using the standard method and was exposed to approximately 1 atm of CO(g). SFG images and vibrational spectra were obtained where the contrast is based on the intrinsic nature of each peak in the CO vibrational spectrum. The illustration of the images and the chemical maps of CO on the platinum surface showed the distribution of the CO across the observed area. The results obtained by comparing the local and the average response confirmed the spatial distributions of the CO on the platinum sample which are due to several reasons such as dipole-dipole coupling and surface coverage. This finding has a significant contribution toward recognizing that surfaces usually considered homogeneous may in fact be quite heterogeneous.

Journal Article↗

PubMed2006

Alkanethiol monolayers at reduced and oxidized zinc surfaces with corrosion protection: a sum frequency generation and electrochemistry investigation.

In this work, octadecanethiol (ODT) was demonstrated to form ordered monolayers at either electrochemically reduced or oxidized Zn surfaces, by means of sum frequency generation (SFG) spectroscopy, cyclic voltammetry (CV), and electrochemical impedance spectroscopy (EIS). The SFG spectra of ODT-modified Zn electrodes featured three methyl group resonances in the C-H vibrational region (2800-3100 cm(-1)). A significant decrease in interfacial capacitance and an increase in charge-transfer resistance were observed in EIS measurement after ODT modification. The alkane chain tilt angle of ODT within a monolayer at the Zn surface was estimated as 0 degrees with respect to the surface normal by interfacial capacitance measurement via EIS. CV and SFG investigation revealed that ODT monolayers undergo reductive desorption from the Zn electrode in 0.5 M NaOH at -1.66 V (vs SCE) and in 0.5 M NaClO4 at -1.62 V. The integrated charge consumed to the desorption of ODT is determined as 87 mC/cm2 from the reductive peak on CV curve, resulting in a coverage of 9.0 x 10(-10) mol/cm2 (5.4 x 10(14) molecules/cm2) if assuming the reduction follows a one-electron process. ODT monolayers show corrosion protection to underlying zinc at the early immersion stage in base, salt, and acid media. However, the protection efficiency was reduced with immersion time due to the presence of defects within the monolayers.

Journal Article↗

PubMed2006

Sum frequency generation spectroscopy and double-layer capacitance studies of the 1-butyl-3-methylimidazolium dicyanamide-platinum interface.

The orientation of the cation and the anion of 1-butyl-3-methylimidazolium dicyanamide at the platinum-liquid interface, using sum frequency generation (SFG) spectroscopy is reported. Sum frequency spectra at two different polarizations and different potentials are recorded, and analysis of polarization-dependent spectra is performed to estimate the orientation of the dicyanamide anion and the alkyl and ring moieties in the cation as a function of the potential applied to the platinum electrode. In addition, cyclic voltammetry and electrochemical impedance spectroscopy are conducted. A model of the double-layer structure at the electrified interface is presented from the analysis of capacitance and SFG data.

Journal Article↗

PubMed2006

Influence of water on the surface of the water-miscible ionic liquid 1-butyl-3-methylimidazolium tetrafluoroborate: a sum frequency generation analysis.

Sum frequency generation spectroscopy (SFG) was used to study the influence of water on the surface of the water-miscible ionic liquid 1-butyl-3-methylimidazolium tetrafluoroborate. The orientation of the cation at the gas-liquid interface was analyzed as a function of ionic liquid concentration in water for concentrations from 0 to 1 mole fraction of the ionic liquid. The cation was found to be oriented with the imidazolium ring nearly parallel to the surface plane with a tilt angle > or = 70 degrees when the ionic liquid was dry. Furthermore, no noticeable change in the orientation was observed when high concentrations of water were mixed with the ionic liquid. The cation butyl chain is projecting into the gas phase with a CH(3) tilt angle of 54 +/- 2 degrees when the ionic liquid is dry and 46 +/- 4 degrees when mixed with water. Water is oriented at the surface only for concentration < or = 0.02 mole fraction of the ionic liquid. At higher ionic liquid concentrations (mole fractions > or = 0.05) the gas-liquid interface resembles that of the pure ionic liquid.

Journal Article↗

PubMed2006

Potential-dependent sum frequency generation study of 5-methylbenzotriazole on polycrystalline copper, platinum, and gold.

In situ sum frequency generation vibrational spectroscopy, at varied potentials and polarization combinations, was performed on polycrystalline copper, polycrystalline platinum, and polycrystalline gold samples in 0.5 M HClO4 with 50 mM 5-methylbenzotriazole (5-methylBTAH) added. These studies were performed to determine the orientation of 5-methylBTAH on the surface at different potentials. For copper surfaces, orientation of the molecule on the surface is not affected by potential within the potential window studied (-500 to -100 mV vs saturated calomel electrode (SCE)). Sum frequency generation spectra of 5-methylBTAH on platinum show a change in orientation over the potential range studied (-250 to 750 mV vs SCE). The orientation of the methyl group tilts more toward the plane of the interface as the potential is scanned in the positive direction. This orientation change is correlated to hydrogen coadsorption on the platinum surface at low potentials. 5-Methylbenzotriazole lies in the surface plane or does not orient on gold at lower potentials but the orientation is tilted toward normal at more positive potentials over the potential range studied (-500 to 900 mV vs SCE). To compliment these results, cyclic voltammetry and electrochemical impedance spectroscopy measurements were performed. Cyclic voltammograms of copper show that addition of 5-methylBTAH protects the surface from copper dissolution, increasing the electrochemical window by 450 mV. Cyclic voltammetry of 5-methylBTAH on platinum showed a partial blockage of adsorbed hydrogen and also prevented the adsorption of oxygenated species at 450-600 mV. Cyclic voltammetry on gold shows that 5-methylBTAH blocks oxide formation for 400 mV thus increasing the electrochemical window. Electrochemical impedance spectroscopy has been performed to determine the potential of zero charge of 5-methylBTAH on copper.

Journal Article↗

PubMed2006

Sum frequency generation study of the room-temperature ionic liquids/quartz interface.

The purpose of this investigation is to study the ionic liquid/quartz interface with sum frequency generation vibrational spectroscopy (SFG). SFG spectroscopy was chosen for this study because of its unique ability to yield vibrational spectra of molecules at an interface. Different polarization combinations are used, which probe different susceptibilities, giving SFG the ability to determine molecular orientation at the interface. The ionic liquids used were 1-butyl-3-methylimidazolium tetrafluoroborate, [BMIM][BF(4)], and 1-butyl-3-methylimidazolium hexafluorophosphate, [BMIM][PF(6)]. To determine the influence of the molecular structure and charge on orientation at the interface, neutral, 1-methylimidazole, and 1-butylimidazole were also studied. Raman spectra and depolarization ratios were obtained for neat samples of 1-methylimidazole, 1-butylimidazole, and 1-butyl-3-methylimidazolium tetrafluoroborate recorded from 2700 to 3300 cm(-1). SFG spectra of the 1-methylimidazole/quartz interface showed both methyl and aromatic C-H vibrations. Orientation calculations determined that the ring of the molecule is tilted 45-68 degrees from normal, with the methyl group oriented 32-35 degrees from normal. The SFG spectra of 1-butylimidazole contain several resonances from the alkyl chain with only one weak resonance from the aromatic ring. Orientation calculations suggest that the ring is lying in the plane of the surface with the methyl group pointing 43-47 degrees from normal. The orientation of the [BMIM][PF(6)] ionic liquid was sensitive to trace amounts of water and had to be evacuated to <3 x 10(-5) Torr for the water to be removed. SFG spectra of both ionic liquids were similar, displaying resonances from the alkyl chain as well as the aromatic ring. Orientation analysis suggests the aromatic ring was tilted 45-90 degrees from normal for [BMIM][BF(4)], while the ring for [BMIM][PF(6)] was tilted 38-58 degrees from normal. This suggests the orientation of the molecule is influenced by the size of the anion.

Journal Article↗

PubMed2006

Surface characterization of 1-butyl-3-methylimidazolium Br-, I-, PF6-, BF4-, (CF3SO2)2N-, SCN-, CH3SO3-, CH3SO4-, and (CN)2N- ionic liquids by sum frequency generation.

Sum frequency generation spectroscopy, SFG, was used for the surface characterization at the gas-liquid interface of the 1-butyl-3-methylimidazolium cation combined with the following anions: Br-, I-, PF6-, BF4-, (CF3SO2)2N- (imide), SCN-, CH3SO3- (MeSO3), CH3SO4- (MS), and (CN)2N- (DCN). The SFG spectra obtained for the different ionic liquids were similar independent of the anion selected; therefore, a comprehensive analysis for the surface characterization of the ionic liquids' cation was focused only on the PF6- and Br- anion combinations. For an accurate identification of the vibrational modes observed, FT-IR and Raman spectroscopy in combination with isotopic labeling with deuterium and polarized Raman spectroscopy was used. The cation orientation was determined by analysis of polarization-dependent SFG spectra. For a compound dried in a vacuum to < or = 2 x 10(-5) Torr, the cation appears to be oriented with the ring laying flat along the surface plane and the butyl chain projecting into the gas phase independent of the anion identity.

Journal Article↗

PubMed2006

Sum frequency generation microscopy of microcontact-printed mixed self-assembled monolayers.

Sum frequency generation imaging microscopy (SFGIM) is used to image the chemically distinct regions of a microcontact-printed monolayer surface. The contrast in the images is based on the vibrational spectrum of each component in the monolayer. Mixtures of C16 thiols on gold with CH3 and phenyl termination are imaged with a resolution of approximately 10 microm. Microcontact printing produces films that are different compared to the immersion procedure of forming self-assembled monolayers. The SFGIM technique is able to obtain a vibrational spectrum at each point on the surface and demonstrate that the stamped area has significant mixing with the molecules deposited from the backfilling solution.

Journal Article↗

PubMed2005

Preparation of alkanethiol monolayers on mild steel surfaces studied with sum frequency generation and electrochemistry.

An n-alkanethiol, octadecanethiol (ODT), monolayer was successfully prepared onto an oxide-free mild steel (MS) surface under cathodic polarization in a 0.1 M LiCl/CH(3)OH solution containing 1 mM ODT. Cyclic voltammetry (CV) and electrochemical impedance (EIS) and sum frequency generation (SFG) spectroscopy were applied to study and characterize the adsorption of ODT at a MS surface. In 0.1 M LiCl/CH(3)OH solution containing 1 mM ODT, CV of the MS electrode shows a dramatic decrease in charging current and a positive shift in oxidation potential when compared to a solution without ODT. The interfacial capacitance was obtained as 2.52 microF/cm(2) from the impedance data. An average chain tilt angle of 48 degrees for the ODT molecules was deduced from the comparison of the interfacial capacitances of the ODT/MS and ODT/Au monolayers. X-ray photoelectron spectroscopy confirmed the formation of the ODT monolayer on mild steel. The ppp SFG spectrum of the ODT-modified MS features three strong methyl vibrational modes at 2877, 2943, and 2967 cm(-1), indicating the formation of the oriented and densely packed ODT monolayer. However, the appearance of the two weak CH(2) groups' vibrational modes at 2850 and 2914 cm(-1) implies the presence of defects in the ODT monolayer. ODT/Au films were prepared to compare with the ODT/MS films. Orientation analysis of the air/solid interface suggests that the methyl group of ODT/Au films has a tilt angle of 30 degrees , while the methyl group of ODT/MS films has a tilt angle of 23 degrees . Water was found to have an impact on the shape of the SFG spectra of ODT/MS. This suggests that the solution penetrated through the defects to reach the MS surface.

Journal Article↗

PubMed2005

Probing electric fields at the ionic liquid-electrode interface using sum frequency generation spectroscopy and electrochemistry.

The arrangement of ions at the platinum electrode in the room-temperature ionic liquid 1-butyl-3-methylimidazolium tetrafluoroborate has been determined using sum frequency generation vibrational spectroscopy (SFG), electrochemical impedance spectroscopy (EIS), and the vibrational Stark effect. The results indicate that CO adsorbed on the Pt electrode has a Stark shift of 30-35 cm(-1)/V in the ionic liquid. The potential of zero charge (PZC) of the ionic liquid-Pt system is approximately -500 mV (vs Ag wire), with a capacitance of 0.12 F/m2. Further, polarization-dependent SFG experiments suggest the ions reorganize at the surface depending on the electrode charge. In combination, all these results indicate that the ions of a neat ionic liquid are organized in a Helmholtz layer at the electrified metal electrode interface.

Letter↗

PubMed2004

Influence of water on the surface of hydrophilic and hydrophobic room-temperature ionic liquids.

Vibrational spectroscopy, sum frequency generation, has been used to study the gas-liquid interface of imidazolium-based, room-temperature ionic liquids. The ionic liquids are divided into two categories on the basis of their miscibility with water, as hydrophobic (immiscible) and hydrophilic (miscible). The spectroscopy results indicate that water will reorient the cations of the hydrophobic ionic liquid, while in the hydrophilic ones they remain unaffected. Thus, under low water conditions the plane of the imidazolium ring remains parallel to the surface for both types of ionic liquid. However, at high water content the ring will reorient to along the surface normal for the hydrophobic ionic liquid but remain parallel to the surface for the hydrophilic one. This is a reversible process.

Journal Article↗