Search PubMed⌕ Search

Biomedical subjects

Soan Kim

Publications and source records attributed to Soan Kim.

3 recordsLinked to original sources

Defect and lattice structure for air-silica index-guiding holey fibers.

We propose new design parameters for index-guiding holey fiber that can provide flexibility in defect and lattice design and adiabatic mode transformation capability. The new defect consists of a central air hole and a germanosilicate ring surrounding it, which results in a large-area annulus mode profile, low splice losses to standard fiber, 0.7 dB at 1.55 microm, and chromatic dispersion with a low slope, 0.002 ps/km nm2.

Journal Article↗

Decrease in skin permeation and antibacterial effect of parabens by a polymeric additive, poly(2-methacryloyloxyethyl phosphorylcholine-co-butylmetacrylate).

The inhibitory effect of poly(2-methacryloyloxyethyl phosphorylcholine-co-butylmetacrylate) (PMB) on the in vitro skin permeation of p-hydroxybenzoic acid and its esters (parabens; methylparaben, ethylparaben, n-propylparaben and n-butylparaben) as model compounds was evaluated. Solubility of the parabens in distilled water was increased by addition of PMB, and the increasing ratio was dependent on the concentration of PMB. The increment of the ratio was more marked in lipophilic parabens than hydrophilic ones. Skin permeability of parabens from their aqueous suspensions was decreased by addition of PMB, and the decreasing ratio was dependent on the PMB concentration. Then, antibacterial effect of parabens of their aqueous solutions was determined with and without PMB by measuring minimum inhibitory concentration (MIC) against E. coli and S. aureus. As results, MIC and antibacterial effect were increased and decreased, respectively, by addition of PMB. The contribution of PMB was more marked in butylparaben than methylparaben. These decreases in skin permeation and antibacterial effect of parabens by PMB are probably due to a higher solubility in water and a lower partition to the skin and bacterial membranes of parabens by addition of PMB.

Animals↗

[Effect of admixture of betamethasone butyrate propionate ointment on preservative efficacy].

Twenty percent of dermatologists have experienced a separation of water or deterioration of topical corticosteroids mixed with commercially available ointments and/or creams. However, few investigations of this deterioration of admixtures have been reported. To assess the effects of preservatives in preventing microbial contamination of these admixtures, we attempted to investigate the concentration of preservative agents in admixtures and the microbial contamination of these admixtures with a topical corticosteroid ointment (Antebate). The concentration of parabens was reduced by half using an admixture of corticosteroid ointment with four types of moisturizing creams, Urepearl, Pastaronsoft, Hirudoid, and Hirudoidsoft. After a further 3 months, no decrease in parabens was seen. No microbial contamination was found in any admixture stored at room temperature for 1 week and touched two times daily with a finger. The concentration and ratio of the parabens in the aqueous phase and oil phase were entirely different in the admixtures before being centrifuged. The aqueous phase of the admixtures of the oil/water (O/W)-type emulsions of Urepearl and Hirudoid was not found to have microbial contamination immediately after being centrifuged. All aqueous phases stored at room temperature or in a refrigerator for 1 week and touched with a finger twice daily exhibited microbial contamination. These experiments demonstrated that O/W-type emulsions, in which the water easily separates from the bases, should be thoroughly mixed to prevent microbial contamination.

Betamethasone↗