Biomedical subjects

Shigeaki Morita

Publications and source records attributed to Shigeaki Morita.

8 recordsLinked to original sources

PubMed2006

Study on temperature-dependent changes in hydrogen bonds in cellulose Ibeta by infrared spectroscopy with perturbation-correlation moving-window two-dimensional correlation spectroscopy.

Infrared (IR) spectra were measured for cellulose Ibeta prepared from the mantle of Halocynthia roretzi over a temperature range of 30-260 degrees C to explore the temperature-dependent changes in hydrogen bonds (H-bonds) in the crystal. Structural changes at the phase transition temperature of 220 degrees C are elucidated at the functional group level by perturbation-correlation moving-window two-dimensional (PCMW2D) correlation spectroscopy. The PCMW2D correlation spectra show that the intensities of bands arising from O3-H3...O5 and O2-H2...O6 intrachain H-bonds dramatically decrease at 220 degrees C, whereas the intensity changes of bands due to interchain H-bonds are not observed adequately. These results suggest that the phase transition is induced by the dissociation of the O3-H3...O5 and O2-H2...O6 intrachain H-bonds. However, the interchain H-bonds are not so much responsible for the transition directly.

Carbohydrate Conformation↗

PubMed2006

Perturbation-correlation moving-window two-dimensional correlation spectroscopy.

A new method of analysis, perturbation-correlation moving-window two-dimensional (PCMW2D) correlation spectroscopy, is proposed. For a spectral data set collected under an external perturbation, this method provides a pair of synchronous and asynchronous two-dimensional correlation spectra plotted on a plane between a spectral variable (e.g., wavenumber) axis and a perturbation variable (e.g., temperature) axis. One of the advantages of this new correlation analysis method is that complicated spectral variation along the perturbation direction can be monitored. It has been found that the synchronous and asynchronous PCMW2D correlation spectra are similar to the first perturbation derivative and negative second perturbation derivative spectra of the original data, respectively. To demonstrate the potential of PCMW2D correlation spectroscopy, it has been applied to temperature-dependent infrared (IR) spectra of a poly(vinyl alcohol) (PVA) film. The thermal behavior of the PVA film has been revealed by the PCMW2D correlation analysis. Two characteristic cross-peaks are observed in the synchronous PCMW2D correlation spectra generated from the temperature-dependent IR spectra between the crystalline phase C-O stretching band at 1141 cm-1 and the melting temperature of 209 degrees C and between the amorphous phase C-O stretching band at 1095 cm-1 and another specific temperature of 233 degrees C. This specific temperature of 233 degrees C corresponds to the thermal degradation temperature due to the elimination of the hydroxyl group attached to the main chain.

Journal Article↗

PubMed2006

Temperature-dependent structural changes in hydrogen bonds in microcrystalline cellulose studied by infrared and near-infrared spectroscopy with perturbation-correlation moving-window two-dimensional correlation analysis.

Temperature-dependent structural changes in hydrogen bonds (H-bonds) in microcrystalline cellulose (MCC) were investigated by infrared (IR) and near-infrared (NIR) spectroscopy. The O-H stretching fundamentals and their first overtone bands were employed to explore the structural changes. In order to analyze the overlapping OH bands due to various H-bonds, perturbation-correlation moving-window two-dimensional (PCMW2D) correlation spectroscopy was applied to the IR and NIR data. Typical spectral variation temperatures were visualized by the PCMW2D correlation analysis. Structural changes in the strong H-bonds in MCC gradually occur in the temperature region of 25-130 degrees C, and they become greater above 130 degrees C. Both OH groups with H-bonds of intermediate strength and very weak H-bonds arise from the structural change of strong H-bonds in the temperature region of 40-90 degrees C, whereas the appearance of the latter OH groups with very weak H-bonds gradually becomes dominant above 90 degrees C. It is revealed from the present study that the glass transition at 184 degrees C induces the changes in the H-bonds in the Ibeta and the O3-H3...O5 intrachain H-bonds. Band assignments for the O-H stretching first overtone vibration region are proposed based on the results of the PCMW2D correlation analyses.

Algorithms↗

PubMed2006

New method for spectral data classification: two-way moving window principal component analysis.

Two-way moving window principal component analysis (TMWPCA), which considers all possible variable regions by using variable and sample moving windows, is proposed as a new spectral data classification method. In TMWPCA, the similarity between model function and the index obtained by variable and sample moving windows is defined as "fitness". For each variable region selected by a variable moving window, the fitness is obtained through the use of a model function. By maximizing the fitness, an optimal variable region can be searched. A remarkable advantage of TMWPCA is that it offers an optimal variable region for the classification. To demonstrate the potential of TMWPCA, it has been applied to the classification of visible-near-infrared (Vis-NIR) spectra of mastitic and healthy udder quarters of cows measured in a nondestructive manner. The misclassification rate of TMWPCA has been compared with those of other chemometric methods, such as principal component analysis (PCA), soft independent modeling of class analogies (SIMCA), and principal discriminant variate (PDV). TMWPCA has yielded the lowest misclassification rate. The result indicates that TMWPCA is a powerful tool for the classification of spectral data.

Journal Article↗

PubMed2006

A study on water adsorption onto microcrystalline cellulose by near-infrared spectroscopy with two-dimensional correlation spectroscopy and principal component analysis.

Water adsorption onto microcrystalline cellulose (MCC) in the moisture content (M(c)) range of 0.2-13.4 wt % was investigated by near-infrared (NIR) spectroscopy. In order to distinguish heavily overlapping O-H stretching bands in the NIR region due to MCC and water, principal component analysis (PCA) and generalized two-dimensional correlation spectroscopy (2DCOS) were applied to the obtained spectra. The NIR spectra in four adsorption stages separated by PCA were analyzed by 2DCOS. For the low M(c) range of 0.2-3.1 wt %, a decrease in the free or weakly hydrogen-bonded (H-bonded) MCC OH band, increases in the H-bonded MCC OH bands, and increases in the adsorbed water OH bands are observed. These results suggest that the inter- and intrachain H-bonds of MCC are formed by monomeric water molecule adsorption. In the M(c) range of 3.8-7.1 wt %, spectral changes in the NIR spectra reveal that the aggregation of water molecules starts at the surface of MCC. For the high M(c) range of 8.1-13.4 wt %, the NIR results suggest that the formation of bulk water occurs. It is revealed from the present study that approximately 3-7 wt % of adsorbed water is responsible for the stabilization of the H-bond network in MCC at the cellulose-water surface.

Adsorption↗

PubMed2004

Hydrogen bonding on the surface of poly(2-methoxyethyl acrylate).

Hydrogen bonding on the interface and in the bulk of a poly(2-methoxyethyl acrylate) (PMEA) thin film has been investigated by sum frequency generation, infrared reflection absorption, and Raman scattering measurements in different kinds of solutions containing hydrogen-bonding donators. These results indicate that the majority of the carbonyl groups on the PMEA surface are hydrogen-bonded with water or ethanol molecules, while the PMEA bulk is still dominated by the free carbonyl group.

Journal Article↗

PubMed2004

Quartz crystal microbalance and infrared reflection absorption spectroscopy characterization of bisphenol A absorption in the poly(acrylate) thin films.

The absorption process of bisphenol A (BPA) in a number of poly(acrylate) thin films, such as poly(2-methoxyethyl acrylate) (PMEA), poly(ethyl acrylate) (PEA), poly(n-butyl methacrylate) (PBMA), and poly(methyl methacrylate) (PMMA), has been investigated by quartz crystal microbalance (QCM) and infrared reflection absorption spectroscopy (IRRAS) measurements. Both QCM and IRRAS measurements show that the BPA molecules absorb in PMEA, PEA, and PBMA thin films but not in PMMA thin film. The differences in the BPA absorption behavior are mainly attributed to the difference in the glass transition temperature (T(g)) between these polymers. This absorption behavior also depends on the BPA concentration and polymer film thickness. Furthermore, IRRAS characterization demonstrates that the hydrogen bonding is formed between the hydroxyl group in BPA and the carbonyl group in the poly(acrylate) thin films. BPA molecule absorbed in these polymer thin films can be removed by ethanol rinse treatment. By optimizing experimental conditions for the QCM electrode modified by PMEA thin film, detection limitation of approximately 1 ppb for BPA can be realized by the in situ QCM measurement. This method is expected to be a sensitive in situ detection way for trace BPA in the environmental study.

Journal Article↗

PubMed2004

Cd2+-induced interfacial structural changes of Langmuir-Blodgett films of stearic acid on solid substrates: a sum frequency generation study.

The molecular structures and their stabilities at the outmost-layer of the Langmuir-Blodgett (LB) films of stearic acid on solid substrates have been investigated by a highly surface-sensitive spectroscopic technique, sum frequency generation (SFG), in air and in aqueous solution, using the combination of both normal and deuterated stearic acid. Peaks observed in the SFG spectra are mainly attributed to the terminal methyl group at the outmost layer of the LB films. The SFG spectra in air are virtually identical and are independent of the odd-even property and thickness (1-12) of the LB films, indicating that the even-numbered LB film changes its surface structure after passing through the interface between the water subphase and air, especially when the Cd2+ cation was included in the water subphase. Furthermore, we have demonstrated for the first time using in situ SFG measurement that the interfacial molecular structure at the LB bilayer of stearic acid on the hydrophilic substrates significantly change with immersion in the water subphase containing Cd2+ cation while such a structural change has not been observed in the water subphase without Cd2+. These results clearly indicate that a reorganization process takes place on the surface of the stearic acid bilayer induced by the Cd2+ cation. The electrostatic interaction between the carboxylate headgroup of stearic acid via the Cd2+ cation seems to play an important role in the surface reorganization process both in air and in solution.

Journal Article↗