Search PubMed⌕ Search

Biomedical subjects

S M Joshi

Publications and source records attributed to S M Joshi.

26 records · Page 2Linked to original sources

Molecular properties of Drosophila acetylcholinesterase.

Two distinct classes of acetylcholinesterase (AChE) from the fruit fly Drosophila melanogaster are reported: a soluble species that shows heterogeneity of forms and a particulate species. The subunit composition of the particulate enzyme was studied using the active site label [3H]diisopropylfluorophosphate. Comparison of the electrophoretic patterns on nondenaturing gels using the activity stain and the active site label shows that the label is specific to AChE. The smallest active site-containing subunit of the enzyme is a monomer of approximately 60,000 daltons MW. Two such units are linked by disulphide bonds to produce a dimer of about 110,000 daltons. Another monomeric form of MW approximately 64,000 daltons, although present, does not participate in the dimerisation. The particulate enzyme when solubilised exists as a 9-10S species as determined by sucrose gradient centrifugation. This species has a MW greater than 200,000, as shown by its behaviour on a coarse-bead Sephadex-G200 column. Electrophoretic analysis suggests a MW of nearly 250,000 daltons for this form. Thus, this species is likely to be a tetramer. One possibility is that this tetramer is made up of two units of 64,000 daltons each and a dimer of 110,000 daltons. Preliminary data on mutant enzymes that support such a possibility are also presented.

Acetylcholinesterase↗

Evaluation of the polished surface characteristic of cobalt-chrome castings subsequent to various finishing and polishing techniques.

Finishing and Polishing constitutes an essential requisite after the fabrication of removable partial dentures. Improper finishing and polishing of cast framework will adversely affect the quality of functional units of partial dentures due to reduced dimensions. In this study the polished surface characteristic and loss of weight of the casting were evaluated and compared following different finishing and polishing techniques. A total number of thirty test specimens were cast and each surface finishing and polishing technique was carried out with a high speed polishing motor and an electropolishing unit under standardised conditions. Surface roughness was evaluated by means of a surface roughness analyzing instrument, Perthometer. The loss of weight due to the metal lost was observed on a sensitive electronic balance. The results of polishing technique employed with G3 group revealed better surface characteristic. It may be understood that sandblasting causes initial roughness and the sequence of coarse cylindrical abrasive, Black hard rubber polisher (coarse grit-Dentauram), Grey hard rubber polisher (Med-grit-Dentauram), Green hard rubber polisher (Fine-grit-Dentauram), Grey flexible rubber polisher (Fine grit-Renfert), felt buff with pumice slurry and felt buff with green polishing compound (Degussa) produced improved surface in this case. The loss of weight due to metal lost show concern with technique groups G4, G5, G6. It can be avoided by judicious sandblasting and application of proper grit of abrasive agents.

Analysis of Variance↗