Applied physics. Waves on the horizon.
Explore the source record for details and available documents.
Biomedical subjects
Publications and source records attributed to Ping Sheng.
Explore the source record for details and available documents.
We report the experimental verification of the predicted chaotic mixing characteristics for a polydimethylsioxane microfluidic chip, based on the mechanism of multistage cross-channel flows. While chaotic mixing can be achieved within short passage distances, there is an optimal side channel flow pulsation frequency beyond which the mixing becomes ineffective. Based on the physical understanding of a Poincaré section analysis, we propose the installation of passive flow baffles in the main microfluidic channel to facilitate high-frequency mixing. The combined hybrid approach enables chaotic mixing at enhanced frequency and reduced passage distance in two-dimensional flows.
We report measurements of the static shear modulus of electrorheological (ER) fluids consisting of water-wetted silica microspheres in silicone oil. A shear-annealing method, using creep-recovery (CR) cycles under an external electric field, is used to enhance ER properties of the fluid. The shear-annealing method enables the silica spheres in the ER fluid to form better aligned and denser column microstructures. A stable state with elastic shear deformation is obtained after a sufficient number of CR cycles, with an optimal combination of stress duration and shear strength. Static shear modulus is obtained by measuring the elastic deformations at different shear stresses for an electric field frequency from 10 to 1000 Hz. A water-bridge model is proposed to explain the enhanced shear modulus.
We show through rigorous derivation and experimental support that the dynamic effective mass density of an inhomogeneous mixture, used in the prediction of wave velocities in the long wavelength limit, can differ from the static version--the volume average of the component mass densities. The physical reason for this difference is explained. The dynamic mass density expression, first derived by Berryman more than two decades ago, is shown to give a closer correspondence between the acoustic and electromagnetic metamaterials by allowing for negative mass densities at frequencies around resonances.
We have fabricated planar structures of silver nanoparticles in monochromatic gelatin emulsion with a continuous spacing ranging from 0.15-0.40 micron using a two-beam interference of a single laser source. Our planar holograms display a colorful "rainbow" pattern and photonic bandgaps covering the visible and IR ranges. We model the planar silver nanoparticle-gelatin composite system using an effective medium approach and good agreement is obtained between theory and experiment.
We present results from finite element calculations on electrorheological fluids consisting of bidispersed dielectric microspheres and nanoparticles suspended in liquid, with one type much smaller than the other. The face-centered-cubic (fcc) structure of the larger microspheres is shown to be the ground state when the volume concentration of the nanoparticles is between 3-5 %. This is in contrast to the usual situation in which the body-centered-tetragonal (bct) structure is the lowest-energy state. As a function of the nanoparticles' concentration, the bct-fcc structural transition occurs when the nanoparticles' dielectric constant exceeds a threshold value, leading to the electrostatic energy curves of the two structures crossing each other.
We consider the pretilt alignment of a nematic liquid crystal (LC) on inhomogeneous surface patterns comprising patches of homeotropic alignment domains in a matrix favoring homogeneous alignment, or vice versa. We found that the resultant LC pretilt generally increases continuously from the homogeneous limit to the homeotropic limit as the area fraction of the homeotropic region increases from 0 to 1. For any given homeotropic area fraction, the variations are qualitatively different depending on how the distance between adjacent patches compares to the extrapolation lengths of the anchoring domains. Our results agree with those previously found in stripe patterns. The present finding provides useful guidelines for designing inhomogeneous alignment surfaces for variable LC pretilt control.
We investigate the slip boundary condition for flows past a chemically patterned surface. Molecular dynamics simulations show that fluid forces and stresses vary laterally along the patterned surface. A subtraction scheme is developed to verify the validity of the Navier slip boundary condition, locally, for the patterned surface. A continuum hydrodynamic model is formulated using the Navier-Stokes equation and the Navier boundary condition, with a slip length varying along the patterned surface. Steady-state velocity fields from continuum calculations are in quantitative agreement with those from molecular simulations.
We consider the resonant optical force acting on a pair of transparent microspheres by the excitation of morphology-dependent resonance (MDR). The bonding and antibonding modes of the MDR correspond to strong attraction and repulsion, respectively. The dependence of the force on separation and the role of absorption are discussed. At resonance, the force can be enhanced by orders of magnitude such that it will dominate other relevant forces. We found that a stable binding configuration can be induced by the resonant optical force.
Large-scale molecular dynamics (MD) simulations on two-phase immiscible flows show that, associated with the moving contact line, there is a very large 1/x partial-slip region where x denotes the distance from the contact line. This power-law partial-slip region is verified in large-scale adaptive continuum calculations based on a local, continuum hydrodynamic formulation, which has proved successful in reproducing MD results at the nanoscale. Both MD simulations and numerical solutions of continuum equations indicate the existence of a universal slip profile in the Stokes-flow regime.
We present a combined experimental and theoretical study of phonon focusing phenomena in a pass band above the complete band gap in a 3D phononic crystal. Wave propagation was found to depend dramatically on both frequency and incident direction. This propagation anisotropy leads to very large negative refraction, which can be used to focus a diverging ultrasonic beam into a narrow focal spot with a large focal depth. The experimental field patterns are well explained using a Fourier imaging technique, based on the 3D equifrequency surfaces calculated from multiple scattering theory.
In a recent experiment, we uncovered an unconventional liquid crystal (LC) orientation transition on microtextured substrates consisting of alternating horizontal and vertical corrugations. When the period of alternation was decreased toward approximately 1 microm, the LC alignment underwent an abrupt transition from inhomogeneous planar to a more uniform configuration with a large pretilt angle ( approximately 40 degrees ). With the aid of a model based on the competition between the Frank-Oseen elastic energy and a phenomenological surface potential of the form W(theta,phi)=(1/2)W((2))(theta) sin(2) theta+(1/4)W((4))(theta) sin(4) theta+(1/2)W(phi) cos(2) theta sin(2) phi(x,y) (where theta and phi are, respectively, the pretilt and azimuthal angles of the LC director and W((2))(theta), W((4))(theta), and W(phi) are constants) that demonstrated good agreement with experiment, we investigated the microscopic origin of the observed transition. It was found that this transition comprises two steps. First, the LC director homogenizes toward the phi=45 degrees azimuthal direction in the plane to relax the elastic energy. The resulting rise in azimuthal anchoring energy subsequently drives the LC to adopt a finite pretilt. The values of the W's deduced from the model reveal that the polar anchoring energy is about approximately 1/10 of the typical values, with the sin(4) theta term dominating the sin(2) theta term. We present a possible explanation for this unexpected finding.
A uniform alignment of liquid crystal (LC) with finite pretilt was observed on microtextured substrates that were lithographically fabricated with alternating horizontal and vertical corrugations. As the period of alternation was decreased toward 0.8 microm, the nematic LC alignment on these substrates changed from inhomogeneous in plane, copying the substrate corrugations, to a uniform configuration with a large pretilt of approximately 40 degrees. This transition is pertinent to a frustrated boundary wherein a lowering in the LC elastic energy due to spatial variation in the LC orientation compromises an increase in the surface anchoring energy. A model based on this idea demonstrates good agreement with the experiment. This result may open up a new arena for tailoring substrate characteristics for LC alignment.
Electrorheology (ER) denotes the control of a material's flow properties (rheology) through an electric field. We have fabricated electrorheological suspensions of coated nanoparticles that show electrically controllable liquid-solid transitions. The solid state can reach a yield strength of 130 kPa, breaking the theoretical upper bound on conventional ER static yield stress that is derived on the general assumption that the dielectric and conductive responses of the component materials are linear. In this giant electrorheological (GER) effect, the static yield stress displays near-linear dependence on the electric field, in contrast to the quadratic variation usually observed. Our GER suspensions show low current density over a wide temperature range of 10-120 degrees C, with a reversible response time of <10 ms. Finite-element simulations, based on the model of saturation surface polarization in the contact regions of neighbouring particles, yield predictions in excellent agreement with experiment.
From extensive molecular dynamics simulations on immiscible two-phase flows, we find the relative slipping between the fluids and the solid wall everywhere to follow the generalized Navier boundary condition, in which the amount of slipping is proportional to the sum of tangential viscous stress and the uncompensated Young stress. The latter arises from the deviation of the fluid-fluid interface from its static configuration. We give a continuum formulation of the immiscible flow hydrodynamics, comprising the generalized Navier boundary condition, the Navier-Stokes equation, and the Cahn-Hilliard interfacial free energy. Our hydrodynamic model yields interfacial and velocity profiles matching those from the molecular dynamics simulations at the molecular-scale vicinity of the contact line. In particular, the behavior at high capillary numbers, leading to the breakup of the fluid-fluid interface, is accurately predicted.
We report the enhancement of yield stress in electrorheological (ER) fluids by a shear-annealing method, using creep-recovery (CR) cycles under an external electric field. The enhancement depends on the duration and the strength of the applied shear stress, as well as on the number of the CR cycles. The shear-annealing method enables the particles in the ER fluid to form microstructures with an increased yield stress, manifest as better aligned and denser columns. For a sufficiently large number of CR cycles, with an optimal combination of stress duration and shear strength, a stable state can be obtained whereby shear deformation becomes elastic.
We have observed the azimuthal switching at the interface of nematic liquid crystals (LCs) and the aligning substrate, induced by the planar electric field of a fine comb electrode. Optical transmittance as a function of applied voltage was modeled by both the elastic theory with rigid anchoring and the Landau-de Gennes theory with the interfacial energy expression 1/2Wtr[(Q two down arrows -Q two down arrows (0))(2)], where Q two down arrows is the liquid crystal order parameter and Q two down arrows (0) is the surface order parameter induced by the aligning substrate. Optical data on the in-plane switching LC cells were found to differ qualitatively with the predictions of the rigid anchoring model but to agree well with those of the Landau-de Gennes theory. We obtain not only the strength W of the azimuthal anchoring, but also find the surface order parameter S(surface) to be 20-30 % less than that of the bulk. The optically measured azimuthal anchoring strength is in good agreement with the literature values determined through other means.
Based on the approach suggested by Tarantola, and Gauthier et al., we show that the alternate use of the step (linear) function basis and the block function (quasi-delta function) basis can give accurate full waveform inversion results for the layered acoustic systems, starting from a uniform background. Our method is robust against additive white noise (up to 20% of the signal) and can resolve layers that are comparable to or smaller than a wavelength in thickness. The physical reason for the success of our approach is illustrated through a simple example.