The structural changes of bovine serum albumin (BSA) and hen egg white lysozyme (HEL) upon their adsorption onto the surface or their embedding into the interior of poly(allylamine hydrochloride)-(poly(styrenesulfonate) (PAH-PSS) multilayer architectures were investigated by attenuated total reflection Fourier transform infrared (ATR-FTIR) spectroscopy. The presence of the polyelectrolytes seems, as previously observed for fibrinogen (J. Phys. Chem. B 2001, 105, 11906-11916), to prevent intermolecular interactions and, thus, protein aggregation at ambient temperature. The secondary structure of the proteins was somewhat altered upon adsorption onto the polyelectrolyte multilayers. The structural changes were larger when the charges of the multilayer outer layer and the protein were opposing. The adsorption of further polyelectrolyte layers onto protein-terminated architectures (i.e., embedding the proteins into a polyelectrolyte multilayer) did not cause considerable further changes in their secondary structures. The capacity of the polyelectrolyte architectures to delay the formation of intermolecular beta-sheets upon increasing temperatures was not uniform for the studied proteins. PSS in contact with HEL could largely prevent the heat-induced aggregation of HEL. In contrast, PAH had hardly any effect on the aggregation of BSA. The differences are explained on the basis of protein-polyelectrolyte interactions, affected mostly by the nature and the strength of the ionic interactions between the polyelectrolyte-protein contact surfaces.

Adsorption↗

PubMedDate not supplied

Cell interactions with polyelectrolyte multilayer films.

The short-term interactions of chondrosarcoma cells with polyelectrolyte multilayer films built up by the alternate adsorption of poly(L-lysine) (PLL) and poly(L-glutamic acid) (PGA) was studied in the presence and in the absence of serum. The films and their interaction with serum proteins were first characterized by means of optical waveguide lightmode spectroscopy, quartz crystal microbalance, and zeta potential measurements. In a serum-containing medium, the detachment forces measured by the micropipet technique were about eight times smaller on PGA-ending than on PLL-ending films. For these latter ones, the adhesion force decreased when the film thickness increased. In a serum-free medium, the differences between the negative- and positive-ending films were enhanced: adhesion forces on PLL-ending films were 40-100% higher, whereas no cellular adherence was found on PGA-terminating films. PGA-ending films were found to prevent the adsorption of serum proteins, whereas important protein adsorption was always observed on PLL-ending films. These results show how cell interactions with polyelectrolyte films can be tuned by the type of the outermost layer, the presence of proteins, and the number of layers in the film.

Blood Proteins↗

PubMedDate not supplied

Red blood cell adhesion on a solid/liquid interface: comparison of two models.

Discoid red blood cells (RBCs) deposited irreversibly on a horizontal glass surface are studied by means of optical microscopy and image analysis. The relative surface covered by the RBCs, as well as the variance of this surface coverage as a function of the cell concentration, are analyzed and compared to the results derived from the ballistic deposition (BD) model. This model describes the irreversible deposition of spherical particles under the influence of an infinitely large gravitation force and does not allow for overlaps between adsorbed particles. In spite of these characteristics, the BD model permits, surprisingly, to reproduce our experimental observations on the deposition of RBCs on a flat surface. This finding is discussed, in particular in respect to a former study where a model was developed for colloidal particles of this particular geometric shape.

Cell Adhesion↗