Biomedical subjects

P A Blomberg

Publications and source records attributed to P A Blomberg.

3 recordsLinked to original sources

PubMed1994

Preventing morphological disturbances in burn-scarred children wearing compressive face garments.

Continuous external compression in the form of elasticized garments is a well-accepted and substantiated form of management for postburn hypertrophic scarring. Children who have sustained deep partial thickness and/or full skin thickness burns to the face and head are frequently prescribed elasticized compressive face garments in the post-acute stage of their recovery. Recurrent concerns expressed by parents prompted investigation into the frequency of sleep disturbances, such as snoring subsequent to the application of face garments, and the possibility of changes to the developing dentition. This preliminary study utilized a single case design to demonstrate the effectiveness of a bimaxillary mouthguard in circumventing such problems.

Bandages↗

PubMed1992

Comparative elasticity tests for elastomeric (non putty) impression materials.

This study was conducted to evaluate the methods used for measuring the elastic recovery of various elastomeric impression materials. One brand from each chemical group was selected to allow relative ranking of the results from each deforming test mode. For compression tests, the polysulphide and silicone specimens made in metal moulds gave significantly less set than those made in acrylic moulds; this was not so for the polysiloxane and polyether specimens. For polysulphide and polyether materials, the set in compression was greater using the BSI balanced beam method than for an optical method without inertia or load effects; this was not so for silicone or polysiloxane materials. The elastic recovery of the materials did not alter significantly after ten minutes of strain release, except in tensile tests, where the elastic recovery continued to change for twenty minutes. The rank ordering of the deformation set showed a relative correlation for the compression test, a new tensile test method, and bend and torsion testing methods. Thus only one method is needed to determine set per cent.

Dental Impression Materials↗

PubMed1992

Some parameters for testing deformation of elastomeric impression materials.

Because of conflicting published data, the temperature rise in four elastomeric materials was measured with a thermistor during setting in the oral cavity and in metal and plastic moulds of varying shapes and volumes for 'elastic set' specimens. The clinical temperature rise was 2-3 degrees C higher in the molar region than anteriorly, except for the polysiloxane. The temperature range attained in the set materials varied from 29 degrees C to nearly 35 degrees C for clinical and in vitro specimens. The average time taken by a group of operators to remove this type of impression from the mouth was five seconds. In a custom tray with light and heavy viscosity materials, the syringe material layer was only 0-0.15 mm thick and, essentially, the heavy viscosity material provided the elastic components for the impression.

Dental Impression Materials↗