Biomedical subjects

Olivier Gallet

Publications and source records attributed to Olivier Gallet.

9 recordsLinked to original sources

PubMed2006

Influence of hydroxyapatite microstructure on human bone cell response.

Microstructure of calcium phosphate ceramics has been shown to influence long-term in vitro cellular events like proliferation and differentiation, and to favor bone integration in vivo. As long-term cellular events are known to be dependent of early cell adhesion events, we decided to study the in vitro influence of the microstructure of a microporous hydroxyapatite (mHA) and a nonmicroporous hydroxyapatite (pHA) ceramic on serum protein adsorption and SaOs-2 human bone cells attachment after 30 min, 1, 4, and 24 h and cell growth after 96 h. Plastic coverslips were used as controls. Hydroxyapatite composition of mHA and pHA was confirmed by X-ray diffraction and Fourier transform infra-red spectroscopy. The surface energies of ceramics were calculated from contact-angle measurements in di-iodomethane, water or complete culture medium. The total surface energy was 44.8 mJ/m(2) for pHA and 48.7 mJ/m(2) for plastic. The contact-angle measurement was impossible on mHA likely because they displayed 12% of open microporosity, pHA ceramic exhibiting only closed pores (2.5%). Moreover, the roughness amplitude was largely higher on mHA (Sa = 4.35 microm) than on pHA (Sa = 0.065 microm) and plastic (Sa = 0.042 microm). Three different techniques were used to evaluate protein adsorption on the ceramics. SDS-PAGE of desorbed proteins demonstrated that more proteins desorbed from mHA (66.02 microg/m(2)) than from pHA (17.2 microg/m(2)) or plastic (0.08 microg/m(2)). A new method was used to evaluate in situ the quantity of adsorbed total proteins: the temperature-programmed desorption (TPD) analysis coupled with mass spectrometry. The TPD analysis confirmed that 10-fold more proteins adsorbed on mHA compared with those on pHA. A direct immunolabeling on ceramics revealed than more fibronectin and serum albumin adsorbed on microporous ceramic than on dense ceramic. The morphology of SaOs-2 cells was the same on all the substrates after 30 min. At later time points, cell morphology on mHA was radically different than on other surfaces, with the particularity of the cytoplasmic edge that appeared undistinguishable from the surface. Only the extremity of the cells and lamellipodia were visible. Cells seemed like "adsorbed" by the mHA surface, whereas on plastic and pHA surfaces the cells displayed classical aspects of polygonal spreading. The cells displayed on mHA the highest initial attachment potential after 30 min, 1, 4, 24 h but the lower proliferation potential after four days. This study confirms that a microporous ceramic surface can modulate the adsorption of proteins and further the adhesion and proliferation of human bone cells.

Adsorption↗

PubMed2006

Removal of surface by-products from sintered hydroxyapatite: effect of a chelation treatment on fibronectin adsorption and cell adhesion.

It was observed that fibronectin precipitates when deposited on hydroxyapatite (HA) ceramics. Fibronectin's known affinity for calcium and the composition of the ceramic itself suggested that calcium release could be the main cause of this aggregation effect. It was then decided to investigate the effect of a surface chelation treatment on fibronectin adsorption, and MG63 cell adhesion, onto porous ceramics of hydroxyapatite (HA), beta-tricalcium phosphate (beta-TCP), and HA/TCP biphasic material (BCP). Those ceramics were immersed in an EDTA solution and the effect of this treatment on the material composition was assayed. X-ray diffraction data showed the presence of alpha- and beta-TCP phases in HA and BCP materials, which were both completely removed by the chelation treatment in the case of HA. On BCP, alpha-TCP was removed and beta-TCP partially dissolved. The TCP material, which was pure beta-TCP, underwent a mass loss, but no change in composition was observed. Adhesion of MG63 cells was overall higher on the fibronectin-coated EDTA-treated HA material, but was especially enhanced on EDTA-treated HA. Changes in surface morphologies, as compared with the use of scanning electron microscopy, did not seem to be related to the effects observed. The EDTA treatment proved to be a very efficient way of removing by-products of HA sintered materials, and thus enhancing the biocompatibility of the material.

Adsorption↗

PubMed2006

Electrochemical processing of fibrinogen modified-graphite surfaces: effect on plasmin generation from adsorbed plasminogen.

With the aim to improve the fibrinolytic properties of carbons by different biological and electrochemical treatments, we modified graphite surfaces by fibrinogen adsorption and subsequent application of various constant potentials before submitting them to plasminogen adsorption. First, we verified that plasminogen (purified or present in human plasma) could adsorb onto these modified surfaces and that adsorbed plasminogen could be converted by t-PA (the principal physiological activator of plasminogen) to adsorbed plasmin. The catalytic properties of the generated enzyme were characterized in assay solutions containing t-PA, fibrinogen and the chromogenic substrate S-2403 (pyroGlu-Phe-Lys-p-nitroaniline, HCl). Experiments showed that the application of electrical potentials to the fibrinogen coating could indirectly affect the properties of the material. In the case of anodic potentials, the amidolytic activity of the generated plasmin was significantly enhanced. Especially, this activity was 10 times higher at a particular potential value.

Adsorption↗

PubMed2005

Adsorption-induced fibronectin aggregation and fibrillogenesis.

Fibronectin (Fn), a high molecular weight glycoprotein, is a central element of extracellular matrix architecture that is involved in several fundamental cell processes. In the context of bone biology, little is known about the influence of the mineral surface on fibronectin supramolecular assembly. We investigate fibronectin morphological properties induced by its adsorption onto a model mineral matrix of hydroxyapatite (HA). Fibronectin adsorption onto HA spontaneously induces its aggregation and fibrillation. In some cases, fibronectin fibrils are even found connected into a dense network that is close to the matrix synthesized by cultured cells. Fibronectin adsorption-induced self-assembly is a time-dependant process that is sensitive to bulk concentration. The N-terminal domain of the protein, known to be implicated in its self-association, does not significantly inhibit the protein self-assembly while increasing ionic strength in the bulk alters both aggregation and fibrillation. The addition of a non-ionic surfactant during adsorption tends to promote aggregation with respect to fibrillation. Ultimately, fibronectin fibrils appear to be partially structured like amyloid fibrils as shown by thioflavine T staining. Taken together, our results suggest that there might be more than one single organization route involved in fibronectin self-assembly onto hydroxyapatite. The underlying mechanisms are discussed with respect to Fn conformation, Fn/surface and Fn/Fn interactions, and a model of fibronectin fibrillogenesis onto hydroxyapatite is proposed.

Journal Article↗

PubMed2005

Adsorption-induced conformational changes in protein diffusion-aggregation surface assemblies.

Two-dimensional rigid colloid aggregation models may be applied to protein layers when no large conformational change is involved. Yet, following adsorption, several proteins undergo a conformational transition that may be involved in aggregative structures. Our focus here is how a conformational change might influence surface clustering in a diffusion-aggregation model. We propose a model including diffusion, aggregation, and unfolding of proteins that are randomly adsorbed onto a surface. Our model allows simulating the case where protein-protein interaction favors unfolding and the case where this interaction prevents it. We study the effect of a simple disk-to-rod unidirectional unfolding and investigate the morphology of the resulting clusters in the diffusion- and reaction-limited regimes. A rich variety of structures is produced, with fractal dimension differing from that in universal diffusive aggregation models. Increasing unfolding probability shifts the system from the neighbor-induced to the neighbor-prevented unfolding regime. The intermediate structures that arise from our model could be helpful in understanding the assembly of different observed protein structures.

Adsorption↗

PubMed2005

Transmigration of human ovarian adenocarcinoma cells through endothelial extracellular matrix involves alphav integrins and the participation of MMP2.

The growth of ovarian carcinoma is dependent upon their vascularistion, but the interaction of ovarian cancer cells with the endothelium and their invasion through an endothelial environment remain poorly understood at the molecular level. To investigate adhesive events underlying this process with focusing on the role of alphav integrins and MT1MMP-MMP2 proteinases, we used in vitro models of cocultures of human ovarian adenocarcinoma cell lines (IGROV1 and SKOV3) with human umbilical vein endothelial cells (HUVECs). Immunostaining of HUVECs revealed the network organisation of fibrillar fibronectin (Fn) and pericellular vitronectin (Vn). During coculture, IGROV1 and SKOV3 cells gain access to subendothelial basement membrane of HUVECs and dislocated endothelial Fn without affecting endothelial Vn. Transmigration assays revealed that tumour cells invade Vn and, with an higher efficiency, Fn. Our data also highlighted that ovarian carcinoma cells migrated through the Fn-rich HUVEC-ECM. The expression of MMP2 and MT1-MMP was revealed in tumour cells within an endothelial environment. Furthermore, we found that cell migration through the endothelial ECM was almost totally dependent on alphav integrin function, whereas beta1 integrins were not solicited. In addition, inhibitors of MMP2 activity (alone or combined with anti-alphav integrin MAb) or TSRI265 (which blocks MMP2-alphavbeta3 association) were found to impede this process. Finally, alphav integrins, MT1-MMP and MMP2 were found in ovarian carcinoma cells within the 3-dimensional architecture of intraperitoneal tumour nodes collected from nude mice xenografted with IGROV1 or SKOV3 cell lines or within human tumour tissues. alphav integrins therefore appear as essential to the migration properties of human ovarian carcinoma cells, especially in an endothelial environment, with MMP2 participating to this process.

Animals↗

PubMed2005

Comparative adherence to human A549 cells, plant fibronectin-like protein, and polystyrene surfaces of four Pseudomonas fluorescens strains from different ecological origin.

The main objective of this study was to compare the adherence properties of four Pseudomonas fluorescens isolates from different ecological niches (human tissue, rhizosphere, drinking water, and cow milk). The substrates used to test P. fluorescens adherence were as follows: cultured human respiratory epithelial cells A549, immobilized plant fibronectin-like protein, and polystyrene. For all the experiments, bacteria were grown at 27 degrees C. The adherence assay to human cells was performed at 37 degrees C, whereas adherence to fibronectin and polystyrene was done at 27 degrees C. The four strains tested adhered to A549 cells but showed different adherence patterns. At 3 h, the milk isolate showed an aggregative adherence phenotype, whereas the three other isolates showed a diffuse adherence pattern. With a longer incubation time of 24 h, the aggregative pattern of the milk isolate disappeared, the adherence of the clinical strain increased, the adherence of the water isolate decreased, and morphological changes in A549 cells were observed with the clinical, water, and soil isolates. The four strains tested formed biofilms on polystyrene dishes. The clinical and milk isolates were the more efficient colonizers of polystyrene surfaces and also the more adherent to immobilized plant fibronectin-like protein. There was no relation between bacterial surface hydrophobicity and P. fluorescens adherence to the substrates tested. The main conclusions of these results are that P. fluorescens is an adherent bacterium, that no clear correlation exists between adherence and ecological habitat, and that P. fluorescens can adhere well to substrates not present in its natural environment.

Animals↗

PubMed2004

Purification of a plant cell wall fibronectin-like adhesion protein involved in plant response to salt stress.

The structural role of extracellular-matrix (ECM) has been recognized in both plants and animals as a support and anchorage-inducing cell behavior. Unlike the animal ECM proteins, the proteins that have been identified in plant ECM have not yet been purified from whole plants and cell wall. As several immunological data indicate the presence of animal ECM-like proteins in plants cell wall, especially under salt stress or water deficit, we propose a protocol to purify a fibronectin-like protein from the cell wall of epicotyls of young germinating peas. The process consists of a combination of gelatin and heparin affinity chromatography, close to the classical one used for human blood plasma fibronectin purification. Proteins with affinity for gelatin and heparin, immunologically related to human fibronectin, are found in the cell wall of epicotyls grown under salt stress or not. Total amount of purified proteins is 3-4 times more enriched in salt stressed epicotyls. SDS-PAGE and Western blot with antibodies directed against human blood plasma fibronectin give evidence that the cell wall proteins purified by gelatin/heparin affinity chromatography are closely related to human fibronectin. The present protocol leads us to purify 17 (control) or 65 (salt stress) micrograms of protein per g of fresh starting material. Our results suggest that plant cell wall proteins can provide better anchorage of the cell to its cell-wall during salt stress or water deficit and could be considered not only as cell adhesion but also as signaling molecules.

Cell Adhesion↗

PubMed2001

Thermally Induced Transient Activity Changes of Plasmin Adsorbed onto Bare and Fibrinogen-Modified Graphite and Glassy Carbon Surfaces.

The occurrence of a thermally induced first-order transition affecting the amidolytic activity of plasmin adsorbed onto bare and protein-modified graphite and glassy carbon was demonstrated in the 10-45 degrees C temperature range in the presence of a chromogenic substrate. Modification of the surfaces was achieved upon spontaneous adsorption of plasmin to surfaces bearing a coating of fibrinogen, whether electrochemically oxidized or not. The amount of fibrinogen adsorbed at graphite was determined by ELISA. The kinetics of the transition was characterized by its starting temperature (T(c)), which was between 14 and 19 degrees C, the first-order rate constant, and the activation energy E(a) deduced from Arrhenius plots. Results showed the absence of a correlation between T(c), E(a), and contact angle variations. It is therefore likely that these variables address separate steps in a complex pathway of reactions undergone by plasmin under mild thermal constraints. Copyright 2001 Academic Press.

Journal Article↗