Biomedical subjects

O Gurel

Publications and source records attributed to O Gurel.

14 recordsLinked to original sources

PubMed1997

Primary importance of zwitterionic over anionic phospholipids in the surface-active function of calf lung surfactant extract.

The relative contributions of zwitterionic and anionic phospholipids to the surface-active function of calf lung surfactant extract (CLSE) were assessed by measurements of surface properties in vitro and pressure-volume (P-V) mechanics in excised rat lungs in situ. Surface activity and mechanical effects were compared for chromatographically purified CLSE subfractions containing the complete mix of phospholipids (PPL) or modified phospholipids depleted in anionic components (mPPL), alone or combined with 1.3% (by weight) of hydrophobic surfactant proteins (SP-B and SP-C). Surface pressure-time (pi-t) adsorption isotherms at 37 degrees C were very similar for dispersions of PPL and mPPL in a Teflon dish with a stirred subphase to minimize diffusion resistance. Combination of either PPL or mPPL with hydrophobic SP substantially improved adsorption, but mixtures of PPL:SP and mPPL:SP had only small differences in pi-t isotherms and reached the same final equilibrium pi of approximately 47 mN/m achieved by CLSE. Surface pressure-area (pi-A) isotherms and maximum surface pressures were also very similar for spread films of PPL versus mPPL and PPL:SP versus mPPL:SP on the Wilhelmy balance (23 degrees C and 37 degrees C). Respreading based on pi-A isotherm area calculations was slightly better in surface-excess films of PPL versus mPPL and PPL:SP versus mPPL:SP, but differences were minor and were smaller at 37 degrees C than at 23 degrees C. Overall dynamic surface activity in oscillating bubble studies was not significantly different for PPL versus mPPL or for PPL:SP versus mPPL:SP, and the latter two mixtures both reached minimum surface tensions < 1 mN/m (37 degrees C, 20 cycles/min, 0.5 mM phospholipid). Dispersions of PPL:SP, mPPL:SP, and CLSE were also not significantly different in improving P-V mechanics almost to normal when instilled in lavaged, excised rat lungs at 37 degrees C (30 mg/2.5 ml saline). These data suggest that zwitterionic phospholipids have a major role over anionic phospholipids in interacting with hydrophobic SP in the adsorption, dynamic surface tension lowering, film respreading, and pulmonary mechanical activity of the hydrophobic components of calf lung surfactant in CLSE.

Absorption↗

PubMed1996

Acylation of pulmonary surfactant protein-C is required for its optimal surface active interactions with phospholipids.

This study investigates the importance of thioester-linked acyl groups in lung surfactant protein C (SP-C) in facilitating interactions with phospholipids that yield functionally important surface active behaviors. Native SP-C, palmitoylated at cysteine residues at positions 5 and 6, was isolated from bovine lung surfactant by liquid chromatography. Deacylated SP-C (dSP-C), unchanged in composition and sequence from SP-C but having a decreased alpha-helical content in films with dipalmitoyl phosphatidylcholine (DPPC) of 52 versus 70%, was obtained by treatment with 0.1 M sodium carbonate buffer at pH 10. Surface activity was studied for SP-C and dSP-C combined with column-purified phospholipids (PPL) from calf lung surfactant or with synthetic phospholipids (DPPC or a synthetic phospholipid mixture (SPL) containing 50:35:15, DPPC:egg phosphatidylcholine:egg phosphatidylglycerol). Interfacial measurements included surface pressure time adsorption isotherms for dispersed surfactants with diffusion minimized, dynamic surface pressure area isotherms and respreading for films in the Wilhelmy balance, and overall surface tension lowering at physiologic cycling rate in oscillating bubble experiments. Dispersions of PPL:SP-C and SPL:SP-C rapidly adsorbed to high equilibrium surface pressures of 47-48 mN/m, significantly better than corresponding dispersions containing dSP-C. The adsorption of PPL:dSP-C was essentially unchanged from that of PPL alone, and the adsorption of SPL:dSP-C was improved only slightly over SPL alone. In Wilhelmy balance studies, dynamic respreading was significantly improved over phospholipids alone in films of SP-C plus PPL, SPL, or DPPC. Respreading was improved less markedly by dSP-C in corresponding films with SPL or DPPC and not at all in films with PPL. Maximum surface pressures were also higher in cycled films of SP-C versus dSP-C combined with PPL or SPL. In bubble experiments (37 degrees C, 20 cycles/min), dispersions of PPL:SP-C and SPL:SP-C reached low minimum surface tensions of <1 and 5 mN/m, respectively, whereas PPL:dSP-C and SPL:dSP-C only reached minima of approximately 20 mN/m as did PPL and SPL alone. Acylation in SP-C is crucial for its interactions with phospholipids over the full spectrum of adsorption and dynamic surface behaviors important for lung surfactant.

Acylation↗

PubMed1996

Differential activity and lack of synergy of lung surfactant proteins SP-B and SP-C in interactions with phospholipids.

This study shows that the hydrophobic lung surfactant proteins (SP)-B and SP-C are not synergistic in enhancing functionally relevant surface behaviors in films and dispersions with phospholipids, and that SP-B is more effective than SP-C in facilitating surface activity. Purified bovine SP-B, SP. C, or SP-B/C (1/1 by wt) were combined with chroma tographically purified calf lung surfactant phospholipids (PPL), or with dipalmitoyl phosphatidylcholine (DPPC) or complex phospholipid mixtures containing 75% or 50% DPPC (75% SPL or 50% SPL). Adsorption was consistently better in corresponding mixtures of phospholipids plus SP-B versus SP-C, but was not improved further by substitution of SP-B/C for SP-B. Interfacial films of DPPC or SPL plus 1.3% SP-B or 1.3% SP-C had improved respreading compared to phospholipids alone (Wilhelmy balance, 23 degrees C and 37 degrees C), but substitution of mixed SP-B/C for either pure apoprotein did not increase respreading further. Surface-excess films of phospholipids plus SP-B had higher maximum surface pressures, or maintained a high maximum pressure through more consecutive compressions, than corresponding films with SP-C. Dispersions of phospholipids plus 1.3% SP-B or mixed (1/1) SP-B/C (2.6%) rapidly lowered surface tension to < 1 mN/m in oscillating bubble studies (20 cpm, 37 degrees C), while corresponding dispersions containing SP-C reduced surface tension more slowly or reached higher minima. Mixtures of 50% SPL with SP-B versus SP-C were also better able to resist inhibition by serum albumin in bubble and adsorption studies, and inhibition resistance was not significantly improved in mixtures containing 2.6% SP-B/C (1/1) versus 1.3% SP-B. The lack of synergy in hydrophobic apoprotein function, coupled with the greater effectiveness of SP-B in improving phospholipid adsorption, dynamic surface activity, and inhibition resistance, suggests that mixtures of phospholipids plus SP-B or related peptides may be particularly relevant its clinical exogenous surfactants.

1,2-Dipalmitoylphosphatidylcholine↗

PubMed1989

Tertiary structure of bacteriorhodopsin. Positions and orientations of helices A and B in the structural map determined by neutron diffraction.

Positions and rotations of two helices in the tertiary structure of bacteriorhodopsin have been studied by neutron diffraction using reconstituted, hybrid purple membrane samples. Purple membrane was biosynthetically 2H-labeled at non-exchangeable hydrogen positions of leucine and tryptophan residues. Two chymotryptic fragments were purified, encompassing either the first two or the last five of the seven putative transmembrane segments identified in the amino acid sequence of bacteriorhodopsin. The 2H-labeled fragments, diluted to variable extents with the identical, unlabeled fragment, were mixed with their unlabeled counterpart; bacteriorhodopsin was then renatured and reconstituted. The crystalline purple membrane samples thus obtained contained hybrid bacteriorhodopsin molecules in which certain transmembrane segments had been selectively 2H-labeled to various degrees. Neutron diffraction powder patterns were recorded and analyzed both by calculating difference Fourier maps and by model building. The two analyses yielded consistent results. The first and second transmembrane segments in the sequence correspond to helices 1 and 7 of the three-dimensional structure, respectively. Rotational orientations of these two helices were identified using best fits to the observed diffraction intensities. The data also put restrictions on the position of the third transmembrane segment. These observations are discussed in the context of folding models for bacteriorhodopsin, the environment of the retinal Schiff base, and site-directed mutagenesis experiments.

Amino Acid Sequence↗

PubMed1975