Search PubMed⌕ Search

Biomedical subjects

N Peyghambarian

Publications and source records attributed to N Peyghambarian.

At least 19 recordsLinked to original sources
PubMed2006

Phase locking and in-phase supermode selection in monolithic multicore fiber lasers.

We report a compact multicore fiber laser that utilizes an all-fiber approach for phase locking and in-phase supermode selection. By splicing passive coreless fibers of controlled lengths to both ends of an active 19-core fiber, we demonstrate that the fundamental in-phase supermode can be selectively excited with a completely monolithic fiber device, instead of conventional free-space and bulk optics, to achieve phase-locked operation for a multiemitter laser device.

Journal Article↗
PubMed2006

Photorefractive polymer device with video-rate response time operating at low voltages.

The high-voltage bias required for video-rate compatible, efficient operation of a photorefractive polymer composite is reduced from 6-8 to 1.3 kV. At this low voltage, the device can hold erasable Bragg holograms with 80% efficiency in addition to having a video-rate response time. The transition of the hologram's state from thick to thin is analyzed in detail.

Journal Article↗
PubMed2006

All-fiber passively mode-locked laser oscillator at 1.5 microm with watts-level average output power and high repetition rate.

We report on a passively mode-locked all-fiber laser oscillator at 1.5 microm based on heavily doped phosphate-glass active fiber. An active fiber only 20 cm long is sufficient to produce as much as 2.4 W of average output power directly from the oscillator. The width of the mode-locked pulses varies from 8 ps at the lowest output power in the mode-locked state to 44 ps at the highest power. Our picosecond laser oscillator features a high repetition rate of 95 MHz and high peak pulse power of approximately 540 W. The oscillator combines the convenience of all-fiber construction with power performance that was previously achievable only with mode-locked bulk-optic laser oscillators or more complex systems involving fiber amplifiers.

Journal Article↗
PubMed2005

Single-frequency laser oscillator with watts-level output power at 1.5 microm by use of a twisted-mode technique.

We report an all-fiber laser oscillator producing as much as 1.9 W of single-frequency direct output at 1.5 microm. Spatial gain hole burning in the active fiber has been eliminated by use of a twisted-mode cavity approach. The two short pieces of a polarization-maintaining fiber that were spliced to the ends of the active fiber served as ultracompact quarter-wave plates. To our knowledge, the use of such a wave plate to manipulate the polarization state of light inside a fiber laser cavity is reported here for the first time. The laser output is linearly polarized and delivered through a polarization-maintaining fiber pigtail. We believe that the output power of our laser is the highest among all single-frequency fiber laser oscillators reported to date.

Journal Article↗
PubMed2005

Generation of watt-level single-longitudinal-mode output from cladding-pumped short fiber lasers.

We generate as much as 1.6 W of continuous-wave 1550 nm single-longitudinal-mode output from a cladding pumped Er-Yb codoped phosphate fiber laser. This power is to our knowledge among the highest in single-longitudinal-mode fiber lasers. The narrowband fiber Bragg grating output coupler is demonstrated to be an effective element for providing the single-longitudinal-mode selection.

Journal Article↗
PubMed2005

Evanescent field-based optical fiber sensing device for measuring the refractive index of liquids in microfluidic channels.

We report a simple optical sensing device capable of measuring the refractive index of liquids propagating in microfluidic channels. The sensor is based on a single-mode optical fiber that is tapered to submicrometer dimensions and immersed in a transparent curable soft polymer. A channel for liquid analyte is created in the immediate vicinity of the taper waist. Light propagating through the tapered section of the fiber extends into the channel, making the optical loss in the system sensitive to the refractive-index difference between the polymer and the liquid. The fabrication process and testing of the prototype sensing devices are described. The sensor can operate both as a highly responsive on-off device and in the continuous measurement mode, with an estimated accuracy of refractive-index measurement of approximately 5 x 10(-4).

Complex Mixtures↗
PubMed2005

Short-length microstructured phosphate glass fiber lasers with large mode areas.

We report fabrication and testing of the first phosphate glass microstructured fiber lasers with large Er-Yb-codoped cores. For an 11-cm-long cladding-pumped fiber laser, more than 3 W of continuous wave output power is demonstrated, and near single-mode beam quality is obtained for an active core area larger than 400 microm2.

Journal Article↗
PubMed2005

Watts-level, short all-fiber laser at 1.5 microm with a large core and diffraction-limited output via intracavity spatial-mode filtering.

We report over 2 W of single spatial-mode output power at 1.5 microm from an 8-cm-long, large-core phosphate fiber laser. The fiber has a numerical aperture of approximately equal to 0.17 and a 25-microm-wide core, heavily doped with 1% Er(+3) and 8% Yb(+3). The laser utilizes a scalable evanescent-field-based pumping scheme and can be pumped by as many as eight individual multimode pigtailed diode laser sources at a wavelength of 975 nm. Nearly diffraction-limited laser output with a beam quality factor M2 approximately equal to 1.1 is achieved by use of a simple intracavity all-fiber spatial-mode filter. Both spectrally broadband and narrowband operation of the laser are demonstrated.

Journal Article↗
PubMed2003

Buried ion-exchanged glass waveguides: burial-depth dependence on waveguide width.

A detailed theoretical and experimental study of the depth dependence of buried ion-exchanged waveguides on waveguide width is reported. Modeling, which includes the effect of nonhomogeneous time-dependent electric field distribution, agrees well with our experiments showing that burial depth increases linearly with waveguide width. These results may be used in the proper design of integrated optical circuits that need waveguides of different widths at different sections, such as arrayed waveguide gratings.

Journal Article↗
PubMed2001

Evidence for intervalence band coherences in semiconductor quantum wells via coherently coupled optical Stark shifts.

We report the experimental observation of coherently coupled heavy-hole-light-hole Stark shifts, i.e., light-hole exciton shifts under heavy-hole exciton pumping conditions, in InGaAs quantum wells. The theoretical analysis of the data is based on a full many-body approach (dynamics-controlled truncation formalism) in the third-order nonlinear optical regime. It is shown that the Stark shift data can be interpreted as strong evidence of suitably defined nonradiative intervalence band coherences in a semiconductor quantum well. Hence, the observations establish a semiconductor analog of Raman coherences in three-level atoms.

Journal Article↗
PubMed2001

Two-photon resonant third-harmonic generation in La2CuO4.

Combining linear absorption and nonlinear third harmonic generation (THG) experiments, we investigate details of the electronic structure of the highly correlated electronic system in La2CuO4. We demonstrate strong THG mainly due to the charge transfer excitation from O (2p(sigma)) to Cu (3d(x2-y2)). The THG spectrum shows pronounced features due to three-photon and two-photon resonance enhancement as well as quantum interference effects. We obtain excellent agreement with a THG spectrum calculated in terms of the excitonic cluster model and can identify both odd and even symmetry excitation modes.

Journal Article↗
PubMed1998

Infrared photorefractive polymers and their applications for imaging.

Photorefractive polymers with high diffraction efficiency in the visible and near-infrared regions of the electromagnetic spectrum have been developed. These polymers, which have a large dynamic range because of their high orientational birefringence, incorporate a dye designed to have a large dipole moment and a high linear polarizability anisotropy. Such polymers have enabled demonstrations of imaging through scattering media, using a holographic time-gating technique at a wavelength that is compatible with the transparency of biological tissues and with the emission of low-cost semiconductor laser diodes.

Birefringence↗