Search PubMed⌕ Search

Biomedical subjects

M E Bayer

Publications and source records attributed to M E Bayer.

At least 55 records · Page 3Linked to original sources

Diffusion constant and dimension of bacteriophage phi X174 as determined by self-beat laser light spectroscopy and electron microscopy.

The diffusion constant of bacteriophage phiX174 was determined by laser light self-beat spectroscopy. The method allows one to establish the diffusion constant in comparatively short time and with high accuracy. From the diffusion constant D(37) = 1.96 +/- 0.08 x 10(-7) cm(2)/s, the size of the virus particles within their aqueous milieu can be calculated. For phiX174, a diffusional diameter of 31.4 +/- 1.0 nm was found, in good agreement with measurements of diameters of freezeetched (32.3 +/- 1.8 nm) and negatively stained particles (33.8 +/- 2.1 nm), provided that the entire spikes of the virion are included. Other isometric viruses may show a complex interaction of the virion with the surrounding water and its ions.

Coliphages↗

Host cell growth in the presence of the thermosensitive drug resistance factor, Rts1.

We have confirmed and extended the observation of Terawaki et al. that the R factor, Rts1, alters the growth of its host at 42 C. In all media tested there was a period during which total cell numbers increased linearly, while viable counts remained constant. During this period the rate of precursor incorporation per cell particle into deoxyribonucleic acid, ribonucleic acid, and protein declined steadily. These patterns were a consequence of the accumulation of increasing numbers of cells which had lost colony-forming ability. A temperature shiftdown experiment showed that the colony formers could, after a lag, go on to divide normally, whereas most of the noncolony formers could not undergo even a limited number of divisions after shiftdown. The number of normal divisions which occurred after shiftup of Rts1 cells to 42 C was medium dependent. In rich medium there were, on the average, two or three doublings; in glucose medium, one; and in glycerol medium, only a fraction of a doubling. Even in glucose medium, however, no increase in viable counts was observed during growth at 42 C if the cells were first starved for glucose for 1 h at 42 C. A temperature shiftdown from 42 C to 27 C during glucose starvation reversed the effect of starvation at 42 C alone. These results are consistent with the hypothesis that the thermosensitive Rts1 component(s) responsible for the host effects is present at permissive temperature, but can undergo a reversible temperature-induced alteration which then interferes with some essential host function. The detrimental effects of this R factor on its host were also reflected in a heightened sensitivity to kanamycin and actinomycin D at 42 C. Electron microscope observations revealed changes in the appearance of the cell membrane. Membranous invaginations were noted at discrete sites in the cell.

Bacterial Proteins↗

Bacteriophage T4 head models based on icosahedral symmetry.

In an accompanying paper, the coordinate variation in lengths of deoxyribonucleic acid molecules and head lengths in morphological variants of bacteriophage T4 is discussed. As an appendix to that report, models for the T4 phage heads, based on previously developed architectural principles for assembly of icosahedral virus, are compared with the data for the best fit.

Coliphages↗

Mode of host cell penetration by bacteriophage phi X174.

Bacteriophage phiX174 is an icosahedral phage which attaches to host cells without the aid of a complex tail assembly. When phiX174 was mixed with cell walls isolated from the bacterial host, the virions attached to the wall fragments and the phage deoxyribonucleic acid (DNA) was released. Attachment was prevented if the cell walls were treated with chloroform. Release of phage DNA, but not viral attachment, was prevented if the cell walls were incubated with lysozyme or if the virions were inactivated with formaldehyde. Treatment of the cell walls with lysozyme released structures which were of uniform size (6.5 by 25 nm). These structures attached phiX174 at the tip of one of its 12 vertices, but the viral DNA was not released. The virions attached to these structures were oriented with their fivefold axis of symmetry normal to the long axis of the structure. No virions were attached to these structures by more than one vertex. Freeze-etch preparations of phiX174 adsorbed to intact bacteria showed that the virions were submerged to one half their diameter into the host cell wall, and the fivefold axis of symmetry was normal to the cell surface. A second cell could not be attached to the outwardly facing vertex of the adsorbed phage and thus the phage could not cross-link two cells. When the virions were labeled with (3)H-leucine, purified, and adsorbed to Escherichia coli cells, about 15% of the radioactivity was recovered as low-molecular-weight material from spheroplasts formed by lysozyme-ethylenediaminetetraacetic acid. Other experiments revealed that about 7% of the total parental virus protein label could be recovered in newly formed progeny virus.

Binding Sites↗

Australia antigen (a hepatitis-associated antigen): purification and physical properties.

Australia antigen [Au(1)], a particle associated with viral hepatitis, was isolated from the plasma of a patient with chronic anicteric hepatitis and leukemia who had received radioactive phosphorus. We have found that the immunoreactivity and appearance of Au(1) in the electron microscope were not altered by treatment with enzymes including trypsin, pronase, lipase, phospholipase C, ribonuclease, deoxyribonuclease, amylase, and neuraminidase. In contrast, other serum constituents were degraded by these enzymes. Therefore, treatment of the patient's plasma with many enzymes was exploited as an initial step for the isolation of Au(1). Subsequently, Au(1) was purified from the enzyme-treated (32)P-labeled plasma by gel filtration through Sephadex G-200 and centrifugation through sucrose and in cesium chloride gradients. There were no detectable human serum components in the purest fractions, as tested by immunoelectrophoresis and immunodiffusion. The density of the purified Au(1) was 1.21 in CsCl. The particle measured about 200 A in diameter, was predominantly spherical in shape and appeared to be composed of subunits. Nucleic acids were not detected by spectrophotometric, radiochemical, and chemical analyses. Immunoreactivity of purified Au(1) was destroyed by heating for 1 hr at 85 degrees C but was stable at 56 degrees C. Treatment with Carnoy's solution (3 parts ethanol:1 part glacial acetic acid) followed by pronase disrupted the particles as seen with the electron microscope. These findings, combined with other published information on Australia antigen and viral hepatitis, suggest that the bulk of Australia antigen in the blood of this patient is an incomplete virus or virus capsid.

Amylases↗

Structure of Escherichia coli after freeze-etching.

Survival of Escherichia coli, quick-frozen under conditions similar to those employed for freeze-etching, is close to 100%. For determination of cell shrinkage, the diameters of freeze-etched E. coli cells (average, 0.99 mum) were compared with those of preparations after negative staining and after ultrathin sectioning. Negatively stained cells measured from 0.65 to 1.0 mum in diameter, and ultrathin sections showed average cell diameters of 0.70 mum. Freeze-etched replicas of logarithmically growing, as well as stationary, E. coli B cells revealed a smooth, finely pitted cell surface in contrast to cell surfaces seen with other preparative methods. The frozen cell wall may cleave in two planes, exposing (i) a smooth fracture face within the lipid layer and (ii) in rare instances an ill-defined particulate layer. Most frequently, however, cleavage of the envelope occurred between wall and protoplasmic membrane; large areas of the membrane were then exposed and showed a surface studded with predominantly spherical particles, an appearance which did not significantly change when the cells were fixed in formaldehyde and osmium tetroxide before freeze-etching. The distribution of these particles differed between logarithmically growing cells and stationary cells.

Cell Membrane↗

Adsorption of bacteriophages to adhesions between wall and membrane of Escherichia coli.

In plasmolyzed Escherichia coli, wall and membrane adhered to one another at 200 to 400 localized areas. This number of specialized wall areas per cell was of the same order of magnitude as the total number of bacteriophage receptors. When bacteriophages T1 to T7 were adsorbed to the bacteria, they were seen to attach almost exclusively to these areas. Comparisons of the number of adsorbed phage particles observed in ultrathin sections and the expected number of phages per cell were in agreement. These results suggest a sharing of receptive areas by the various phages. Adsorption to the wall-membrane associations would permit the virus to release its nucleic acid at an area closest to the cell's protoplasmic contents.

Adsorption↗

Response of Cell Walls of Escherichia coli to a Sudden Reduction of the Environmental Osmotic Pressure.

The rate of survival after osmotic shocks was found to be dependent on the state of growth. When growing logarithmically, Escherichia coli was about 20 to 100 times more sensitive to an abrupt decrease of the environmental osmotic pressure than when it was in the stationary phase. Subjecting rapidly growing cells to such a treatment caused fingerlike extrusions to emerge from the bacterial wall. Our results suggest that underneath these extrusions the rigid layer of the wall contains weak areas which appear as discontinuities or gaps when viewed in an electron microscope. After exposure to osmotic shock, the gaps became wider. We concluded that the gaps represent sites of mucopolymer synthesis where the rigid structure has temporarily been opened by hydrolytic enzymes to allow for the insertion of new wall material into the older portions of the wall.

Journal Article↗

Borrelia burgdorferi DNA in the urine of treated patients with chronic Lyme disease symptoms. A PCR study of 97 cases.

The presence of Borrelia burgdorferi DNA was established by PCR from urine samples of 97 patients clinically diagnosed as presenting with symptoms of chronic Lyme disease. All patients had shown erythema chronica migrans following a deer tick bite. Most of the patients had been antibiotic-treated for extended periods of time. We used three sets of primer pairs with DNA sequences for the gene coding of outer surface protein A (OspA) and of a genomic sequence of B. burgdorferi to study samples of physician-referred patients from the mideastern USA. Controls from 62 healthy volunteers of the same geographic areas were routinely carried through the procedures in parallel with patients' samples. Of the 97 patients, 72 (74.2%) were found with positive PCR and the rest with negative PCR. The 62 healthy volunteers were PCR negative. It is proposed that a sizeable group of patients diagnosed on clinical grounds as having chronic Lyme disease may still excrete Borrelia DNA, and may do so in spite of intensive antibiotic treatment.

Anti-Bacterial Agents↗

Anionic sites on the envelope of Salmonella typhimurium mapped with cationized ferritin.

Binding of either ferritin (F) or cationized ferritin (CF) was employed to indicate the surface charge of the envelope of mainly two Salmonella typhimurium strains (395 MR10, a Rd-mutant, and LT2-M1, a UDP-galactose-4-epimerase-less mutant). Lowering the pH from 7 to 4 decreased binding of CF, but increased binding of F. At low concentrations, the distribution of CF on S. typhimurium 395 MR10 was in general random, with individual ferritin molecules often forming clusters of two or three particles. At ionic strengths of 0.25M NaCl, ferritin produced distinctive, larger clusters at relatively few sites (10-50/cell). Addition of galactose to cultures of growing S. typhimurium, LT2-M1 reduced the binding of CF in 1-10 min, and numerous ferritin-free areas became visible. Possibly this is caused by a pluri-focal reduction in the negative cell surface charge that was generated at the multiple sites of export of new, smooth-type lipopolysaccharide, which either exhibits lesser charge or masks a preexisting surface charge. Dividing cells may show unequal charges on the prospective daughter cells, and the difference in the capacity for ferritin adsorption of both daughter cells is sharply separated at the division site.

Cell Membrane↗