Search PubMedSearch

Biomedical subjects

L Gorelick

Publications and source records attributed to L Gorelick.

At least 19 recordsLinked to original sources

Reducing white spot lesions in orthodontic populations with fluoride rinsing.

A clinical study was conducted to determine if rinsing frequency with a neutral 0.05% sodium fluoride rinse influenced white spot lesion formation associated with orthodontic brackets. Patients from two private orthodontic practices participated. Each received home-care instructions and were told to use 10 ml of sodium fluoride rinse daily before bedtime. The rinse was supplied free of charge to determine if this affected compliance with its prescribed use. Compliance was measured by recording the number of bottles used by each patient. As assessment of oral hygiene status was conducted, and at the time of debonding, white spot lesions were recorded. Only 13% of the 206 participants fully complied with the rinse protocol; 42% of the subjects used 10 ml approximately every other day; and 45% used the rinse less frequently. A significant dose response relationship was noted in which those who rinsed at least once every other day had fewer lesions (21%) than those who rinsed less frequently (49%). It was concluded that a significant reduction in enamel white spot lesions can be achieved during orthodontic therapy through the use of a 10 ml neutral sodium fluoride rinse. The more closely patients complied with the prescribed use, the more likely they could expect a decrease in the occurrence of lesions.

Adolescent

Inlayed teeth of ancient Mayans: a tribological study using the SEM.

A study has begun of inlayed teeth of Meso-American Indian skulls using scanning electron microscopy and modelling techniques. Round cavity preparations 2-3 mm in diameter and 1-2 mm deep had been cut through the enamel and just into the underlying dentin of the teeth. The vertical walls of the preparation met the floor in either a square, rounded or undercut form. Towards its center, the floor was occasionally elevated, sometimes depressed and commonly rounded. Closer examination showed abrasion anomalies as concentric, shallow grooves cut into the tooth tissue. A modification of the Semenovian principle was employed to determine the tool: 1) from the marks registered the the cavity and 2) the outline form of the preparation itself. Preparing cavities experimentally in teeth using wood and stone drills and sand as an abrasive produced certain characteristics consistent with those in the Meso-American teeth in which wooden drills created a variety of cutting patterns which included flat, elevated and depressed floors in the preparations. We have tentatively concluded that suggestions for the use of a tubular drill does not adequately explain the variety of forms encountered and that the cutting patterns were more consistent with the use of a wooden drill and sand.

Dental Cavity Preparation

Bonding metal brackets with a self-polymerizing sealant-composite: a 12-month assessment.

Data spanning 15 months and about 1,500 bands have been presented describing an effective procedure for bonding metal brackets to enamel by the acid-etch method. A sealant-composite combination for metal brackets, not previously reported, has been described. Data have also been presented showing that, for the method and material used, it did not seem to matter clinically if a 37 per cent acid were used or if, instead a 50 per cent orthophosphoric acid in a liquid or thixotropic form, applied for 2 to 2 1/2 minutes, and drying agent were used. A comparison with the Nuva system was made and a modification was described for a useful combination technique, namely, Enamel Bond-Nuva-Tach, which takes advantage of certain attributes of each.

Acid Etching, Dental

Microscopic evaluation of enamel after debonding: clinical application.

Enamel surfaces were debonded by methods recommended in the literature and found to be problematic. A new method, not previously recommended, involving the use of a green rubber wheel followed by pumice or composite finishing paste was similarly examined and found to come closest to restoring the original, natural enamel surface. A step-by-step clinical procedure was described for highly filled, lightly filled, and unfilled adhesives.

Composite Resins

Direct bonding in the management of an ankylosed second deciduous molar.

A simple and efficient bonding procedure has been described for the management of an ankylosed deciduous second molar. This has, in our experience, provided a satisfactory occlusal and periodontal environment in selected patients. Based on a limited number of cases, restorations have been maintained for about two years to date.

Acrylic Resins

Acupuncture.

Explore the source record for details and available documents.

Acupuncture Therapy