Search PubMed⌕ Search

Biomedical subjects

K Lindenberg

Publications and source records attributed to K Lindenberg.

At least 19 recordsLinked to original sources

From subdiffusion to superdiffusion of particles on solid surfaces.

We present a numerical and partially analytical study of classical particles obeying a Langevin equation that describes diffusion on a surface modeled by a two-dimensional potential. The potential may be either periodic or random. Depending on the potential and the damping, we observe superdiffusion, large-step diffusion, diffusion, and subdiffusion. Superdiffusive behavior is associated with low damping and is in most cases transient, albeit often long. Subdiffusive behavior is associated with highly damped particles in random potentials. In some cases subdiffusive behavior persists over our entire simulation and may be characterized as metastable. In any case, we stress that this rich variety of behaviors emerges naturally from an ordinary Langevin equation for a system described by ordinary canonical Maxwell-Boltzmann statistics.

Journal Article↗

Diffusion on a solid surface: anomalous is normal.

We present a numerical study of classical particles diffusing on a solid surface. The particles' motion is modeled by an underdamped Langevin equation with ordinary thermal noise. The particle-surface interaction is described by a periodic or a random two-dimensional potential. The model leads to a rich variety of different transport regimes, some of which correspond to anomalous diffusion such as has recently been observed in experiments and Monte Carlo simulations. We show that this anomalous behavior is controlled by the friction coefficient and stress that it emerges naturally in a system described by ordinary canonical Maxwell-Boltzmann statistics.

Journal Article↗

Energy relaxation in nonlinear one-dimensional lattices.

We study energy relaxation in thermalized one-dimensional nonlinear arrays of the Fermi-Pasta-Ulam type. The ends of the thermalized systems are placed in contact with a zero-temperature reservoir via damping forces. Harmonic arrays relax by sequential phonon decay into the cold reservoir, the lower-frequency modes relaxing first. The relaxation pathway for purely anharmonic arrays involves the degradation of higher-energy nonlinear modes into lower-energy ones. The lowest-energy modes are absorbed by the cold reservoir, but a small amount of energy is persistently left behind in the array in the form of almost stationary low-frequency localized modes. Arrays with interactions that contain both a harmonic and an anharmonic contribution exhibit behavior that involves the interplay of phonon modes and breather modes. At long times relaxation is extremely slow due to the spontaneous appearance and persistence of energetic high-frequency stationary breathers. Breather behavior is further ascertained by explicitly injecting a localized excitation into the thermalized arrays and observing the relaxation behavior.

Journal Article↗

Subdiffusion-limited A+A reactions.

We consider the coagulation dynamics A+A-->A and A+A <==> A and the annihilation dynamics A+A-->0 for particles moving subdiffusively in one dimension. This scenario combines the "anomalous kinetics" and "anomalous diffusion" problems, each of which leads to interesting dynamics separately and to even more interesting dynamics in combination. Our analysis is based on the fractional diffusion equation.

Journal Article↗

Thermal resonance in signal transmission.

We use temperature tuning to control signal propagation in simple one-dimensional arrays of masses connected by hard anharmonic springs and with no local potentials. In our numerical model a sustained signal is applied at one site of a chain immersed in a thermal environment and the signal-to-noise ratio is measured at each oscillator. We show that raising the temperature can lead to enhanced signal propagation along the chain, resulting in thermal resonance effects akin to the resonance observed in arrays of bistable systems.

Journal Article↗

Phase-induced stability in a parametric dimer.

We report results on a model of two coupled oscillators that undergo periodic parametric modulations with a phase difference straight theta. Being to a large extent analytically solvable, the model reveals a rich straight theta dependence of the regions of parametric resonance. In particular, the intuitive notion that antiphase modulations are less prone to parametric resonance is confirmed for sufficiently large coupling and damping. Some general results concerning synchronization properties in this system are presented. We also compare our results to a recently reported mean-field model of collective parametric instability, showing that the two-oscillator model captures much of the qualitative behavior of the infinite system.

Journal Article↗

Enhanced pulse propagation in nonlinear arrays of oscillators.

The propagation of a pulse in a nonlinear array of oscillators is influenced by the nature of the array and by its coupling to a thermal environment. For example, in some arrays a pulse can be speeded up while in others a pulse can be slowed down by raising the temperature. We begin by showing that an energy pulse (one dimension) or energy front (two dimensions) travels more rapidly and remains more localized over greater distances in an isolated array (microcanonical) of hard springs than in a harmonic array or in a soft-springed array. Increasing the pulse amplitude causes it to speed up in a hard chain, leaves the pulse speed unchanged in a harmonic system, and slows down the pulse in a soft chain. Connection of each site to a thermal environment (canonical) affects these results very differently in each type of array. In a hard chain the dissipative forces slow down the pulse while raising the temperature speeds it up. In a soft chain the opposite occurs: the dissipative forces actually speed up the pulse, while raising the temperature slows it down. In a harmonic chain neither dissipation nor temperature changes affect the pulse speed. These and other results are explained on the basis of the frequency vs energy relations in the various arrays.

Journal Article↗