Search PubMed⌕ Search

Biomedical subjects

J L Zatz

Publications and source records attributed to J L Zatz.

36 records · Page 2Linked to original sources
PubMed1979

Flocculation of sulfamerazine suspensions by a cationic polymer.

Flocculation by a cationic polymer of sulfamerazine suspensions containing a wetting agent was evaluated. Suspensions with sufficient surfactant concentrations to ensure complete wetting were deflocculated. When the anionic surfactant, dioctyl sodium sulfosuccinate, was used as a wetting agent, the suspensions were flocculated over a limited polymer concentration range. Flocculation was attributed to simultaneous interaction of a polymer molecule with more than one particle. At higher polymer concentrations, the particles were covered completely with polymer, leading to repulsion between the particles and deflocculation of the suspensions. The polymer concentration required for flocculation provided evidence for interaction between the anionic surfactant and the cationic polymer. Suspensions containing a nonionic surfactant also were flocculated using various polymer concentrations. When a surfactant mixture was employed in the suspensions, the peak sedimentation volume of flocculated systems and the concentration of polymer at the peak depended on the surfactant mixture composition.

Cations↗
PubMed1978

Effect of formulation factors on penetration of hydrocortisone through mouse skin.

The effect of formulation factors on the steady-state flux of hydrocortisone through mouse skin was evaluated. The flux of hydrocortisone from solutions containing propylene glycol as a cosolvent varied inversely with the propylene glycol concentration. Solutions containing 2-propanol gave flux values higher than those obtained from propylene glycol solutions and independent of the 2-propanol concentration. Addition of polysorbate 80 to 2-propanol-water solutions produced an increase in flux at low surfactant concentrations that reached an apparent limiting value at higher concentrations. The penetration flux was the same from solutions and gels. The role of vehicle-skin interactions in penetration is emphasized.

Administration, Topical↗
PubMed1978

Comparison of adsorbed films of a polyvinylpyrrolidone copolymer with spread monolayers.

The adsorption of a polyvinylpyrrolidone-polyvinyl acetate graft copolymer from solution was studied by surface pressure measurement. Adsorption from the dilute solutions was slow, limited, in part, by diffusion of polymer molecules to the surface. When absorbed monolayers were compressed on a surface balance, the resulting surface pressure values paralled those of a spread monolayer, strongly suggesting that the structures of adsorbed and spread monolayers are the same.

Adsorption↗
PubMed1977

Interaction of hydrocortisone with model membranes containing phospholipid and cholesterol.

Pure and mixed monolayers of lecithin and cholesterol were spread on substrates of dissolved hydrocortisone at 25 and 37 degrees. The presence of hydrocortisone increased the surface pressure of dipalmitoyl and egg lecithin films that were in head contact. The increase in surface pressure was dependent on steroid concentration. There were no significant interactions with coherent cholesterol monolayers. Penetration of hydrocortisone was decreased by the addition of cholesterol to the monolayer system. These model membrane systems indicate that hydrocortisone interacts with the hydrated polar head group of the phospholipid and not with films whose molecules are in hydrocarbon tail contact.

Chemical Phenomena↗
PubMed1975

Molecular arrangement in monolayers containing cholesterol and dipalmitoyl lecithin.

The molecular arrangement of dipalmitoyl lecithin and cholesterol in mixed monolayers was investigated with the aid of a physical model. The two lipids are miscible at the surface, but there is no indication of a specific interaction. In equimolar mixed monolayers at 25 and 37 degrees, the lipids are in tail contact. Lecithin molecules are able to remain hydrated in the mixed monolayers at high values of surface pressure.

Chemical Phenomena↗
PubMedDate not supplied

Kinetics of permeation and metabolism of alpha-tocopherol and alpha-tocopheryl acetate in micro-Yucatan pig sin.

The objective of this research was to investigate the permeation and metabolism of alpha-tocopheryl acetate (alpha-TAc) and alpha-tocopherol (alpha-T) from solution and emulsion formulations and to delineate the kinetics of such metabolism. Simple formulations containing alpha-TAc and alpha-T were applied to fresh, viable micro-Yucatan skin dermatomed to a thickness of 250-300 microns, as a finite dose in a flow-through diffusion system. The experiments were stopped at time intervals of 2, 6, 12, and 24 hours. At the end of each time interval, the amounts removed by washing, retained in the stratum corneum (SC), and penetrated into the viable skin and receptor were determined by a validated HPLC method. Receptor concentrations were below the limit of detection. alpha-TAc underwent metabolism in pig skin to the active antioxidant alpha-T. The metabolite appeared as early as two hours after application. The extent of metabolism was highest at 6-12 hours after application. No metabolism was detected in the stratum corneum. Delivery of alpha-T from isopropyl myristate (IPM) solution was more efficient than utilization of alpha-TAc from the same solution. Approximately 1.5% of alpha-T yielded the same viable skin concentration as 5% alpha-TAc. Topical application of alpha-tocopherol or its prodrug acetate was capable of enhancing the overall antioxidant capacity of pig skin. The hydrolytic pathway of alpha-TAc leading to the active antioxidant alpha-T could possibly be saturable.

Animals↗
PubMedDate not supplied

Differential scanning calorimetry studies of sebum models.

Human sebum is a mixture of triglycerides, fatty acids, wax esters, squalene, cholesterol, and cholesterol esters. P. acnes, a bacterium that is normally found on the skin, hydrolyzes certain triglycerides to fatty acids, thereby changing the sebum composition. The objective of this study was to examine the physical state of a model sebum and the effect of variations in its composition on its physical properties including (a) the carbon chain length of the components, (b) the ratio of unsaturated to saturated components, and (c) the ratio of triglycerides to fatty acids. A model sebum mixture was prepared based on a composition reported in the literature and evaluated by differential scanning calorimetry (DSC). Since cholesterol and cholesterol esters contribute insignificantly to sebum composition, they were not included. Squalene was kept constant (13%), while the concentration of the rest of the components was varied. Variations of sebum were prepared by dissolving all components in a 3:1 chloroform-methanol mixture for uniformity. Subsequently the solvent was evaporated at room temperature. The samples were then analyzed using DSC. Four distinct endotherms (namely, Mp-1, Mp-2, Mp-3, and Mp-4) were observed between -50 degrees C and 100 degrees C. Mp-1 and Mp-2 occurred below 0 degrees C and were contributed by unsaturated components. Mp-3 and Mp-4, which represent the saturated components, occurred above 30 degrees C. Thus, at normal skin temperature (skin surface temperature is 32 degrees C), sebum contains both a solid and a liquid phase. All the transition temperatures increased with an increase in carbon chain length for the same ratio of unsaturation to saturation. A replacement of unsaturated components with corresponding saturated components led to a decrease in the transition temperatures for the former (Mp-1 and Mp-2) and an increase in the transition temperatures for the latter (Mp-3 and Mp-4). Replacement of triglycerides with corresponding fatty acids (mimicking the action of anaerobic bacteria) caused an increase in Mp-2 and a decrease in Mp-4. In all cases, the final melting temperature (Mp-4) was greater than the temperature of the human skin surface (32 degrees C); thus components contributing to these endotherms are still solids at skin temperature. All variations in the sebum model led to mixtures of solids and liquids at skin temperature. Considering a reduction in Mp-3 and/or Mp-4 to represent sebum "fluidization," it was achieved by a decrease in carbon chain length, an increase in unsaturation, or a substitution of triglycerides by corresponding fatty acids. Preferential enrichment with the saturated species will lead to enrichment of solids versus liquids in the sebum, presumably making it difficult for the liquid phase to dissolve the solids. It seems plausible that perturbation of the balance of solid and liquid components of sebum, such as by P. acnes action, may lead to blockage of the follicle. Future research will investigate strategies to dissolve and/or liquify the solid phase of sebum.

Calorimetry, Differential Scanning↗
PubMedDate not supplied

Effect of formulation on the delivery and metabolism of alpha-tocopheryl acetate.

The effect of delivery system on the permeation and metabolism of alpha-tocopheryl acetate (alpha-TAc) was studied in micro-Yucatan pig skin, which closely resembles human skin. Various alpha-tocopheryl acetate formulations, including a simple isopropyl myristate (IPM) solution, an o/w emulsion, microemulsions, which differed in their oily phase content, and alcoholic and hydroalcoholic gels were made. A suitable HPLC method was developed and validated to separate and quantify alpha-TAc and alpha-tocopherol (alpha-T). Dulbecco's modified phosphate-buffered saline with 3% bovine serum albumin (DMPBS-BSA 3%) served as the receptor media to ensure tissue viability and to maintain skin conditions. Finite doses (5 microl) of the formulations were applied to viable pig skin using a statistically approved randomized complete block design. Data were analyzed using Tukey's studentized range test, and interday variability was estimated using an F-test. About 70% of the active was recovered from the wash, representing the amount adhering to the surface of the skin. alpha-TAc underwent metabolism in pig skin to the active antioxidant, alpha-T. The identity of the HPLC peaks were confirmed by spiking studies using known standards. The extent of metabolism was found to be formulation-dependent. No alpha-T was, however, detected in the stratum corneum. A higher extent of metabolism was obtained for the IPM solution, a microemulsion containing IPM as the oily phase, and the hydroalcoholic gel, when calculated based on the percent of total alpha-TAc permeated in the viable skin. Metabolism occurred in pig skin to the extent of 15-20% in terms of the total amount of alpha-TAc permeated in the viable skin and stratum corneum. Thus the topical delivery and metabolism of alpha-TAc were found to be dependent on formulation.

Animals↗
PubMedDate not supplied

Deposition of salicylic acid into hamster sebaceous.

In an earlier paper, we identified vehicles that are miscible with sebum, using differential scanning calorimetry (DSC). In this paper, the potential of these vehicles to deliver salicylic acid (SA) into the sebum-filled follicles of hamster ears is examined. The main objective of this study is to correlate the melting transitions of a model sebum with the follicular delivery of SA, using two different types of vehicles (fatty and polar). Generally, the fatty vehicles show higher deposition than the polar vehicles. Follicular delivery of salicylic acid correlates well with its solubility in the respective vehicles. This extent of deposition also shows a relationship with the effect of the vehicle on thermal behavior of the model sebum. The nature of the relationship depends on the vehicle (polar or fatty) tested. We conclude that DSC could be used to identify appropriate vehicles for drugs whose follicular delivery depends on solubility. The results also suggest that delivery into the sebaceous glands occurs by two different mechanisms, depending upon the polarity of the vehicle and the physicochemical properties of the drug. The results of these experiments are further extended to investigate follicular delivery of SA from two different types of oil-in-water emulsion formulations. From these studies we conclude that either increasing the volume of the oil phase or changing the emulsion to a water-in-oil emulsion would increase follicular deposition. Our research highlights the role of sebum, its compatibility with drug molecules, and vehicle selection in the transport of drugs into the follicles. The overall results of these experiments provide a reasonable understanding of the mechanisms underlying the transport of drugs to, and subsequently through, the sebaceous follicle.

Animals↗