Search PubMed⌕ Search

Biomedical subjects

J L Marty

Publications and source records attributed to J L Marty.

6 recordsLinked to original sources
PubMed2006

An electrochemical bioassay for dichlorvos analysis in durum wheat samples.

The use of an acetylcholinesterase inhibition assay for the detection of dichlorvos in durum wheat samples by a simplified extraction procedure is reported. After an incubation step, the residual activity was determined with an amperometric biosensor using a portable potentiostat. The use of electric eel and recombinant acetylcholinesterase was compared. The effect of the matrix extract was evaluated by using various sample:solvent ratios, 1:2.5, 1:5, 1:10, and 1:20. The optimal extraction ratio, considering the electrochemical interferences and the effect on enzyme activity and bioavailability of the pesticide, was 1:10. Calibrations were performed in buffer and durum wheat extract. The calculated detection limits in buffer solution were 10 ng/ ml and 0.045 ng/ml for electric eel and recombinant acetylcholinesterase, respectively, whereas operating in the matrix extract they increased up to 45 ng/ml and 0.07 ng/ml, corresponding to 0.45 mg/kg (extraction ratio 1:10) and 0.07 mg/kg in samples. These characteristics allowed the detection of contaminated samples at the maximum residue limit, which is 2 mg/kg and well below. Fortified samples of durum wheat were obtained with both dichlorvos and the commercial product Didivane, which contains dichlorvos as an active molecule. At all the tested levels, the occurrence of contaminant was detected with an average recovery of 75%. The total assay time, including the extraction step, was 30 min. Because several extractions as well as most of the assay steps can be run simultaneously, the throughput for one operator is 12 determinations per hour.

Acetylcholinesterase↗
PubMed2000

Flow analysis for determination of paraoxon with use of immobilized acetylcholinesterase reactor and new type of chemiluminescent reaction.

A highly sensitive flow analysis method for determination of acetylcholinesterase (AChE) inhibitors like organophosphorous pesticides using a new chemiluminescent reaction was developed and optimized. This method is fast, sensitive, and cheap, because it requires only one enzyme and its substrate. The system incorporates a reactor with immobilized AChE on controlled pore glass (CPG) and a chemiluminometric detector. Variations in enzyme activity due to inhibition are measured from the changes of concentrations of thiocholine produced when the substrate (acetylthiocholine chloride) is pumped before and after the passage of the solution containing the pesticide through the immobilized AChE reactor. Thiocholine is determined by a new chemiluminescent reaction with luminol in the presence of potassium ferricyanide. The percentage inhibition of enzyme activity is correlated to the pesticide concentration. The inhibited enzyme is reactivated by 10 mM pyridine-2-aldoxime methiodide (2-PAM). The experimental conditions were first optimized for activity determination of the effect of pH, flow rates, and Tris concentrations. For the measurement of AChE inhibition, the appropriate concentration of the substrate is selected such that the rate of noninhibited reaction can be considered unchanged and could be used as a reference. For optimization of experimental conditions for inhibition, several parameters of the system are studied and discussed: flow rate, enzyme-pesticide contact time, luminol concentration, ferricyanide concentration, 2-PAM concentration, and configuration of the FIA manifold. Paraoxon, an organophosphorous pesticide was tested. For an inhibition time of 10 min the calibration graph is linear from 0.1 to 1 ppm paraoxon with a relative standard deviation (n = 5) of 4.6% at 0.5 ppm. For an inhibition time of 30 min the calibration graph is linear from 25 to 250 ppb paraoxon.

Acetylcholinesterase↗
PubMed2000

Improved multianalyte detection of organophosphates and carbamates with disposable multielectrode biosensors using recombinant mutants of Drosophila acetylcholinesterase and artificial neural networks.

Engineered variants of Drosophila melanogaster acetylcholinesterase (AChE) were used as biological receptors of AChE-multisensors for the simultaneous detection and discrimination of binary mixtures of cholinesterase-inhibiting insecticides. The system was based on a combination of amperometric multielectrode biosensors with chemometric data analysis of sensor outputs using artificial neural networks (ANN). The multisensors were fully manufactured by screen-printing, including enzyme immobilisation. Two types of multisensors were produced that consisted of four AChE variants each. The AChE mutants were selected in order to obtain high resolution, enhanced sensitivity and minimal assay time. This task was successfully achieved using multisensor I equipped with wild-type Drosophila AChE and mutants Y408F, F368L, and F368H. Each of the AChE variants was selected on the basis of displaying an individual sensitivity pattern towards the target analytes. For multisensor II, the inclusion of F368W, which had an extremely diminished paraoxon sensitivity, increased the sensor's capacity even further. Multisensors I and II were both used for inhibition analysis of binary paraoxon and carbofuran mixtures in a concentration range 0-5 microg/l, followed by data analysis using feed-forward ANN. The two analytes were determined with prediction errors of 0.4 microg/l for paraoxon and 0.5 microg/l for carbofuran. A complete biosensor assay and subsequent ANN evaluation was completed within 40 min. In addition, multisensor II was also investigated for analyte discrimination in real water samples. Finally, the properties of the multisensors were confirmed by simultaneous detection of binary organophosphate mixtures. Malaoxon and paraoxon in composite solutions of 0-5 microg/l were discriminated with predication errors of 0.9 and 1.6 microg/l, respectively.

Acetylcholinesterase↗
PubMed1999

Structure-functional effects of ethanol on Drosophila melanogaster acetylcholinesterase probed by kinetic studies with substrate and inhibitors.

Ethanol is commonly used to extract and dissolve insecticides acting as inhibitors of acetylcholinesterase (EC 3.1.1.7). Here, experiments were undertaken to investigate the influence of solvent on the reaction and inhibition of the enzyme from Drosophila melanogaster. Ethanol (up to 20% by volume) is shown to induce a dramatic reduction of the affinity of acetylcholinesterase for the acetylthiocholine iodide substrate and all the edrophonium chloride, paraoxon ethyl and propidium diiodide inhibitors, with little influence on the rate constants. Taken together, these results point to a main perturbation of active-center related components involved in the formation and/or stability of Michaelis complexes. Inactivation and ligand-stabilization studies of acetylcholinesterase activity further indicate the occurrence of specific "conformational scrambling" at catalytic and regulatory sites. It is proposed that ethanol affects the enzyme reactivity by modifying the conformation of the aromatic gorge containing the active centre and hence, interactions involved in the molecular recognition of substrates and ligands.

Acetylcholinesterase↗
PubMed1992

A novel microbial sensor using luminous bacteria.

A novel microbial sensor system that uses luminous bacteria was developed for the determination of both glucose and toxic compounds. The sensor system consisted of a membrane with luminous bacteria immobilized upon it and a photomultiplier. Measurements were based on the in vivo intensity of the light emitted by the bacteria, as this is affected by their environment. A linear relationship was observed between increased luminescence and concentrations of glucose between 0.05 mM and 0.55 mM. The relative standard deviation was 10% for 0.55 mM glucose (n = 10). Toxic compounds such as benzalkonium chloride, sodium dodecyl sulphate and chromium(VI) were also detected by measuring the decrease in luminescence in their presence.

Bacteria↗